20 Most Recent
Questions & Answers
How to clean waste toner tank
1st don't wear a new shirt when doing this !!!!
waste toner tanks are not meant to be reused (not saying you couldn't ) but its gonna make a mess doing it so id choose not to do iinside the office that's for sure , replacement tanks are available from same sources you buy toner cartridges from then just tape up the spout and toss old one away , some machines will require a manual reset of toner tank alarm , consult your manual to see how you do it
and if your dead set on cleaning it , what id do is buy one new one install it and take old one outside in a field miles from nowhere using 91% isopropanol alcohol and a hand full of old rags (disposable gloves too) id wipe it clean ,then store it under machine in paper storage box (not tray) so its there ready to use next time you need it
on Sep 17, 2015
Samsung CLX-3305FW Imaging Unit error
Insufficient information to answer the problem. Try going directly to their web site http://www.samsung.com/us/search/espsearch.us?keyword=CLX-3305FW+ and check the SUPPORT and FREQUENTLY ASKED QUESTIONS section
on May 04, 2014
Whenever i give print command on my samsung scx4321ns printer it shows the msg rear door open how will i cure it.
I am only guessing at this point but there should be a tap that sticks out from the back of the rear door ( much like the way a microwave door has a tab on it that lets you know that the door is fully closed ) so check the back of your printer to make sure that the tab is still in place and if it is, check to see if it is doing what it was meant to do, also the tab system might have been replaced with a small magnet or a metal plate that makes contact with each other and when this is done the printer knows the door is closed, so if all looks good then it could be the electronic part that the tab or magnet comes into contact with and this is faulty or misaligned, remember to look closely at the back of the door to see if a tab has been broken off or is missing. So also study the printer body and look for a way in which the printer knows that the door might be open eg. some sort of electrical switch that tell the printer that the door is not shut and then ask yourself why the switch is not been activated.You might have to takes steps like gluing on a tab or wedging something in between the switch to trick the printer into thinking that the door is shut but a little bit of detective work is required on your behalf.
on Nov 20, 2019
Not finding what you are looking for?