20 Most Recent KitchenAid KGYS750LQ Gas Dryer Questions & Answers


You will have to remove the back panel to access this part. Be sure that you unplug the machine before starting. Once the back panel has been taken off and placed aside the thermal switch will be located on the left lower side near the blower housing . It will be thin and long and located near the cycling thermostat that has for prongs on it. On certain machines, the thermal fuse is located in the front. To access this you must remove the kickplate, which can be done by pushing the clips, one on each side jsut above the top of the kickplate, in between the top and abottom portion. The part numbers are the same for either style dryer. To test this part you can either take the wires off it and tie them together then plug the machine back in and see if it heats, or you can use amultimeter and check to see if there is continuity, if there is its good, if not, bad. The thermal fuse will usually be white, and if located in the back, be thin and long with two wires on it, left and right. If in the bottom front, it will be front center on the exhaust duct. In some cases the ignitor or the gas coils will go bad. Here is a good process of elimination.
1)Verify that the thermal fuse is good. If you don't have a meter bypass it and turn the machine on. If heats, thermal fuse is bad, if not leave connected and continue
2)When the dryer starts and thermal fuse bypassed, the ignitor should start to get hot and glow, if your thermal fuse is in the back you are going to have to have to the top of the dryer up to see down inside near the front for the glow. You can do this by taking the lint trap out and removing the two screws and popping the top up. If the ignitor comes on more than likely the gas coils are bad and if it doesn't the ignitior is bad. (this is while the thermal fuse is bypassed so the ignitor has power to it regardless)

If you need further help, I’m available over the phone at https://www.6ya.com/expert/jason_4570d45317834dd3

KitchenAid... | Answered on Jun 05, 2012


Hi, If you are having problems with your gas dryer not heatingthe most common problem is that the ignitor goes bad. Even though it glowssometimes it is still not working properly. if you dryer is gas check out this gas no heat tip.... If you have an electric dryer, you can have many differentthings that can go wrong causing the dryer not to heat. check outthis electric no heat tip...

heatman101;';
;
';
;

KitchenAid... | Answered on Aug 05, 2011


Hi, If you are having problems with your gas dryer not heatingthe most common problem is that the ignitor goes bad. Even though it glowssometimes it is still not working properly. if you dryer is gas check out this gas no heat tip.... If you have an electric dryer, you can have many differentthings that can go wrong causing the dryer not to heat. check outthis electric no heat tip...

heatman101';
'
;

KitchenAid... | Answered on Jun 02, 2011


Hi,

If you are having problems with your gas dryer not heating the most common problem is that the ignitor goes bad. Even though it glows sometimes it is still not working properly.


if you dryer is gas check out this gas no heat tip....


If you have an electric dryer, you can have many different things that can go wrong causing the dryer not to heat.


check out this electric no heat tip...

heatman101



l'l'

KitchenAid... | Answered on Mar 04, 2011


Hi,

If you are having problems with your gas dryer not heating the most common problem is that the ignitor goes bad. Even though it glows sometimes it is still not working properly.


if you dryer is gas check out this gas no heat tip....


If you have an electric dryer, you can have many different things that can go wrong causing the dryer not to heat.


check out this electric no heat tip...

heatman101


------------------------=

KitchenAid... | Answered on Feb 05, 2011


that's not a glow plug its the ignitor if you have a voltage tester set it to amps and clip on one of those wires should be reading 3-3.3 amps any less and you should replace the ignitor a weak ignitor will not light the flame in time when the gas shuts off and goes to turn back on again which will make the unit continually try to reach the factory set temperature if you have any further questions please message me back and please remember to rank how this opinion has helped when our chat has concluded Merry Christmas
Rick

KitchenAid... | Answered on Dec 26, 2010


Hi, If you are having problems with your gas dryer not heatingthe most common problem is that the ignitor goes bad. Even though it glowssometimes it is still not working properly. if you dryer is gas check out this gas no heat tip.... If you have an electric dryer, you can have many differentthings that can go wrong causing the dryer not to heat. check out this electric no heat tip...

heatman101

KitchenAid... | Answered on Nov 26, 2010


replace goor switch

KitchenAid... | Answered on Sep 30, 2009


replace the gas valve coils. they sit right on top of the gas valve. they are black and round, and clide down over a shaft. remove screw from plate holding them, and slide them up and off, replace, and it will run....turn gas off while working on unit:)

KitchenAid... | Answered on Sep 16, 2009


Note: Normal drying time for a dryer is about 45 minutes (some may take up to an hour).

1. Venting
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.

Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.

2. Thermostat
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.

KitchenAid... | Answered on Jul 23, 2009


It’s likely caused by a fan. Air circulation fans usually only run when the door is closed or the door switch is depressed. The fan blade could be hitting some built up ice or maybe it needs replacing.

KitchenAid... | Answered on Jul 15, 2019


next time send the full model number,on the older ka's the timer was on the bottom,pull off the kick panel and see if it's down there under the freezer door

KitchenAid... | Answered on Nov 14, 2017


your oven is wired for mobile home use . Have it changed over to a 3 wire by a professional electrician

KitchenAid... | Answered on Oct 19, 2017

Not finding what you are looking for?
KitchenAid KGYS750LQ Gas Dryer Logo

17 questions posted

Ask a Question

Usually answered in minutes!

Top KitchenAid Dryers Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Ekse

Level 3 Expert

13434 Answers

durantheman

Level 2 Expert

134 Answers

Are you a KitchenAid Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

KitchenAid Dryers

  • KitchenAid Dryers

Most Popular Question

gas dryer kgys750lq

  • Dryers
Loading...