20 Most Recent Senco 2K0013N FramePro 702XP 2Inch 312Inch Full Round Head Framing Na Questions & Answers


Before you use the tool put a few drops of oil into the air line input. The pin may be sticking. You could try spraying WD40 into the area where the nail comes out also.
Sometimes dirt can build up in the region that the pin slides in and other moving parts and cause them to stick so you may have to dismantle the gun to clean it. Spray WD40 on all moving parts before re-assembly.

Senco 2K0013N... | Answered on Jul 14, 2011


Undersized extension cord, voltage drop, worn piston connecting rod, bad capacitor, hot ambient temperature, etc.
How does it connect to power?

Senco Air Tools... | Answered on Aug 29, 2019


Most of the time this symptom is actually caused by a jammed driver blade.
Remove the head cap and see if the driver moves up and down freely - if it does then I would install a service kit.
If you send the model number I can get you the correct part number.

Senco Air Tools... | Answered on Apr 13, 2019


Take off cap of tool remove wagon wheel. remove cylinder and driver on outside of cylinder there are o-rings. A large one and a small one. It might be a band instead of an o-ring. there should be bunch of tiny holes your o-ring or band is worn or missing its called a return band. Replace the O-Ring or band and you should be good to go. Alos do not forget to lubricate.

Senco Air Tools... | Answered on Mar 11, 2019


Check for correct air pressure, released safety interlock, no jammed nails, correctly lubricate the drive mechanism.

Senco Air Tools... | Answered on Feb 14, 2019


Replace the split O ring, I would get a rebuild kit from Senco or dealer and rebuild the unit. O rings fail, if you opt only for the O ring buy a Viton O ring preferably American made, Good Luck.

Senco Air Tools... | Answered on Dec 20, 2018


Nitrogen tacker Fusion 15 could be pcb assembly or wire battery contact ?

http://www.senco.com/docs/manuals-and-parts-charts/F-15_MAN.pdf

Senco Air Tools... | Answered on Oct 05, 2018


If you are certain the finishing nails are the ones that are supposed to be used in this gun, try lubricating it inside with a really light oil such as 3 in 1, or PB Blaster, or sewing machine oil.
This worked for me.

Senco Air Tools... | Answered on Feb 17, 2018


being you say light comes on my guess is it is electric so i will try to help based on the electric model. here is a link to the f16s fusion 18volt model hope this help you figure the rest out.
Fusion 16S
this link is to the main page copie this one if the first one fails you. good luck

http://www.senco.com/parts-and-service/cordless/

Senco Air Tools... | Answered on Nov 19, 2017

Not finding what you are looking for?
Senco 2K0013N FramePro 702XP 2Inch  312Inch Full Round Head Framing Na Logo

1 questions posted

Ask a Question

Usually answered in minutes!

Top Senco Air Tools & Compressors Experts

John Trevino

Level 3 Expert

1420 Answers

Trippy Tripp

Level 2 Expert

194 Answers

Mike

Level 3 Expert

4363 Answers

Are you a Senco Air Tool and Compressor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Senco Air Tools & Compressors

  • Senco Air Tools & Compressors

Most Popular Question

framers 702xp won 39 t drive

  • Air Tools & Compressors
Loading...