20 Most Recent Craftsman 29cc 4Cycle Straight Shaft Weedwacker Gas Trimmer () Questions & Answers


talking lawn mower ot petrol trimmer --get a new bulb from any mower repair shop get a new diaphragm kit was well

Craftsman 29cc... | Answered on Jun 03, 2017


If you go to searspartsdirect.com and put the model number in it will show you a diagram and on the page is a offering for the owners manual.

Craftsman 29cc... | Answered on Dec 07, 2016


Check and adjust the spark plug if that is ok then replace the coil.

Craftsman 29cc... | Answered on Dec 07, 2016


Have you checked the fuel filter and made sure it is not plugged. Make sure the primer bulb is not cracked or leaking pressure. If you have then I would be sure the fuel cap is not bad. To check the cap you should be able to put the cap on the tank pump the primer button to build pressure in the tank and then turn the cap a turn or so and hear the pressure release. If that is all ok then I would think the diaphragm in the carb is bad and the carb needs to be rebuilt.

Craftsman 29cc... | Answered on Nov 22, 2016


Not sure what you mean but if you are saying the weedwacker head is not engaging it may be the cable that goes from the motor to the weedwacker head and runs down the inside of the shaft.

Craftsman 29cc... | Answered on Nov 22, 2016


Go to searspartsdirect.com and put in your model number and it will give you a drawing showing the parts you are looking for. Hope this helps.

Craftsman 29cc... | Answered on Oct 24, 2016


L + H adjustments IF someone can have mis adjusted.?
and or leaking gaskets. (or tank airiation) fuel hose porous

Craftsman 29cc... | Answered on Feb 18, 2016


If you go to searsparts.com and put in your model number it will show you a drawing of your weed wacker. Not sure of what you are looking for. Hope this helps.

Craftsman 29cc... | Answered on Jul 09, 2015


Bought this model 2 years ago. Used it 3 seasons. Started getting hard to keep running and finally checked out the issue. Found the primer bulb cracked. Got a primer bulb (Walbro 188-12-1) from Co-op and seemed to fit but still wouldn't start.

Started looking for a rebuild kit and found none. Called the MTD office (this was built by MTD for Craftsman) and they don't make a rebuild kit. They said because the new carb is as cheap as a kit. I looked for a new carb and found one on ebay for $28 shipped free. PN: (753-06258a)
Ordered it, it arrived 3 days later and installed it. Started right away. Comes with a few part I didn't use. Gaskets and spacers. I only replaced the carb. Also I am pretty sure the orientation of the gas lines are different on this new carb. This one is a replacement "a" model and I think I had to put the green and yellow line different than the original model. stead of coming out the top the ports come out the bottom. Just hook it up and have only about half a tank of gas. That way the return line is above gas level and can't suck gas if hooked up backwards. If you start to prime and get only air then reverse the lines.
Went to Lowes and got the jumpstart bit for a troybilt for $10. Place on the cordless drill (high speed) and start like a car...get one but make sure you have a fast drill.

Craftsman 29cc... | Answered on Mar 23, 2015


is the pull rope in front of the engine ???
yes ???
you dont wanna know

Craftsman 29cc... | Answered on Sep 03, 2014


Check for spark if u have pour a small amount of gas in carb it should start also check air filter if runs then stops carb problem . Spray some carb cleaner then re try

Craftsman 29cc... | Answered on Aug 05, 2014


Call ur local small engine shop

Craftsman 29cc... | Answered on Aug 05, 2014


go to sears parts direct and they have it at a discounted price... www.searspartsdirect.com

Craftsman 29cc... | Answered on Jul 20, 2014


There is not much to it. There should be information stamped or printed on the side of the carb - maker and model#s. Take this information and do an internet search with it. You should find a rebuild kit for around $10. The kit should come with a diagram and directions. Take the carb apart, clean as necessary, reassemble with the new parts and you are good to go.

Craftsman 29cc... | Answered on Jun 04, 2014

Not finding what you are looking for?
Craftsman 29cc 4Cycle Straight Shaft Weedwacker Gas Trimmer () Logo

84 questions posted

Ask a Question

Usually answered in minutes!

Top Craftsman Garden Experts

john h

Level 3 Expert

22486 Answers

rjivaro

Level 2 Expert

158 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Are you a Craftsman Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Craftsman Garden

  • Craftsman Garden

Most Popular Question

bulb will not fill gas trouble last

  • Garden
Loading...