20 Most Recent Taylor 1431 Digital Wireless Thermometer Questions & Answers


remove four screws on back of unit,cut red wire going to round beeping speaker inside lower front faceplate. problem solved it will never beep again but still read temp correctly.

Taylor 1431... | Answered on Feb 10, 2016


yes there is a solution to stop the beep. Take a piece of cotton and put into ur ears..... simple

Taylor 1431... | Answered on Nov 14, 2015


If the unit was workingg prior to the battery replacement, you must remove the battery and check on the terminals to the battery. Make that these are clean, the battery is good - test using a multimeter- and replace with the correct postion.
Now if the earlier battery had leaked it could have damaged the internal board and if so you need to open to check if the board is clogged with the battery leak. If so try and clean the board.

Taylor 1431... | Answered on May 05, 2014


Remove the 4 small phillips head screws on the battery cover and it lifts off.
When you replace the cover make sure the gasket (black rubber) is in it's groove.

Taylor 1431... | Answered on Jul 24, 2012


The Clock display is located at the top of the base unit's LCD screen. The clock has alarm and snooze functions.
A) Clock Setting
1. Press and hold the "SET" button on the back of the base unit for 3 seconds to enter Clock Setting Mode. The year digits flash in place of the clock digits.
2. Press the "+" or "-" button to change the year. Press "SET" to confirm. The month digits flash.
3. Press the "+" or "-" button to change the month. Press "SET" to confirm. The date digits flash.
4. Press the "+" or "-" button to change the date. Press "SET" to confirm. The Day/Month ("D M") or Month/Day
("M D") selection flashes.
5. Press the "+" or "-" button to toggle between Day/Month and Month/Day format. Press "SET" to confirm. A language selection flashes under the "DAY" icon to the left of the clock digits.
6. Press the "+" or "-" button to toggle between language selections*. Press "SET" to confirm the displayed language. Time zone offset digits flash in place of the clock.
7. Press the "+" or "-" button until the correct time zone offset** appears (-12 to +12). Press "SET to confirm the displayed time zone offset. "12 Hr" or "24 Hr" flashes.
8. Press the "+" or "-" button to toggle between 12 and 24 hour clock mode. Press "SET" to confirm.
The hour and minute digits reappear. The hour digits flash.
9. Press the "+" or "-" button to change the hours. Press "SET" to confirm. The minute digits flash.
10. Press the "+" or "-" button to change the minutes. Press "SET" to confirm. The hour and minute digits stop flashing. The clock is set.

Taylor Measuring... | Answered on Nov 04, 2019

Not finding what you are looking for?
Taylor 1431 Digital Wireless Thermometer Logo

22 questions posted

Ask a Question

Usually answered in minutes!

Top Taylor Measuring Tools & Sensors Experts

Jim Oliver
Jim Oliver

Level 1 Expert

23 Answers

Keith Bowers

Level 2 Expert

153 Answers

Richard Marshall

Level 2 Expert

41 Answers

Are you a Taylor Measuring Tool and Sensor Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Taylor Measuring Tools & Sensors

  • Taylor Measuring Tools & Sensors

Most Popular Question

stop taylor 1341 digital thermometer

  • Measuring Tools & Sensors
Loading...