20 Most Recent
- Page 5 Questions & Answers
I need the firmware for
You probably have it by now, but I'm looking too. I did come across this site in the U.K. that will sell it for 5 British Pounds (about $8 right now):
The latest version is 1.86 (Build 1009).
The only downside is that they appear to not take credit cards unless you're in the U.K. to start with -- you need to do a bank transfer of some kind.
on Feb 17, 2011
I just put in a
The new ink cartridge has a plastic lining requiring removable before snapping in placement area on printer. Inserting a new cartridge without removing the plastic lining safe requirimng disposal would least produce results upon installing cartidges. Good lcuk
on Jan 11, 2011
I have a copystar 1810 loaner. I am trying to
Thanks for using FixYa.
Error Code E07 means paper jams near the fuser unit. Try removing the paper jams and check for any small bits of paper near the fuser unit.
Follow this procedure---
the left cover. Holding the green handles, lower the two fixing section release
the misfed paper while taking care not to tear it. If the paper is not
easy to remove, proceed to the next step.
- If the
paper is removed successfully, proceed to step 9. If the paper should be
torn, remove all the scraps from the inside the copier.
the green handle, open the ejection guide.
the misfed paper while taking care not to tear it.
the ejection guide.
the fixing section release levers.
If the fixing section
release levers are lowered, the left cover does not close.
the left cover and multi-bypass.
Pull the drawer out and check that no paper is
Close the drawer slowly.
Also check for the User and Operating instructions manual for details--
Copystar C1810 User and Operating instructions manual
Please do accept the solution if the issue is resolved or else revert for further assistance.
on Oct 25, 2009
I have a copystar c2520 and am getting a c6000
C6000, С6030 is Abnormally high temperature in the fixing section – The fixing unit
thermistor output voltage remains less than 0.5 V for longer than 1 s,
indicating the fixing temperature rises above 536F this may be the fuser is no good. Sorry? coll to Servise center Mita. Dood lack!
on Sep 22, 2009
On my Copystar 8030, can't print 2 sided.
What type of paper are you telling the copier your using, your copier's duplexer (The section that turns the paper over for the second side image) if the copier is told that the paper is to thick (lbs/gm2) you operator manual will tell you what media (paper) can be used. either, via lbs system (US System) or g/m2 system rest of the world. What the paper comes wrap up in will tell the thicknest of the paper either in lbs, g/m2, or both
Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f
on Aug 19, 2009
I have a copystar CS
Do unplug the unit for at least an hour, this can help you reset the unit. Or you have to clear out the memory by accessing the fuse on the power board, you have to remove it to reset unit.
Make sure that your printer was not plug into elec outlet before doing this.
Hope this helps
on Jul 31, 2009
Not finding what you are looking for?