20 Most Recent Sierra International 18-4310 Marine Powerhead Gasket Set for Johnson/Evinrude Outboard Motor () Questions & Answers


yes if yuo go to iboats.com the forum will allow you to search by serial number and give info on your outboard.

Sierra... | Answered on Feb 03, 2016


Try to tun shaft with vice grip or Stilton wrench(bobbyaan spanner)put spanner nearest to end,try not to damage shaft.if shaft will not turn you will probably have to cut cable and knock out from other side

Sierra... | Answered on Dec 11, 2013


Check pump housing and plate for wear,make sure aluminium housing not corroded under plate. Suggest fitting electric drill to drive shaft and emerse lower unit in bucket of water.make sure drill doesn't get wet.is motor going into gear,maybe splines are rusted off in crankshaft,could also have holes in inner exhaust side plate

Sierra... | Answered on Dec 09, 2013


No,check vro fuel pump diaphragm.if primer bulb doesn't get hard when priming is a sign of needle and seat not sealing or a hole in fuel pump diaphragm.

Sierra... | Answered on Dec 09, 2013


Check and clean carbs. If same problem persists rebuild or change full pump. Firstly ensure clean plugs,and fuel filter. If you hook up a inline fuel pressure gauge, then run. You may have low press output, at cont full load. If so you need to open your vapor separator tank. Check and clean high presure pump and pre filter. You need to clean and inspect needle and seat. Than repeat test as outlned above.

Sierra Boating | Answered on Sep 25, 2017


I think there is a nut holding the prop to the shaft and there might be a shear pin going through the prop and shaft. Remove those to get the prop off. It may have been on so long, there might be rust and other junk holding it on. Spray with penetrating oil and let sit to loosen the rust.

Boating | Answered on Oct 31, 2019


I suggest you post your question on this forum:

http://www.boatered.com/forum/topic.asp?TOPIC_ID=131726

Boating | Answered on Oct 30, 2019


I suggest you go to this site and obtain a manual for your Evinrude engine. Hope it helps:

Literature

Boating | Answered on Oct 30, 2019


In demo mode, it will show fish and bottom details when the transponder is out of water. If the boat is in a mooring, put a metal spade under the transponder, you should see the detail change.

Google

make model manual

Boating | Answered on Oct 28, 2019

Not finding what you are looking for?
Sierra International 18-4310 Marine Powerhead Gasket Set for Johnson/Evinrude Outboard Motor () Logo

10 questions posted

Ask a Question

Usually answered in minutes!

Top Sierra Boating Experts

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8981 Answers

Kardoc

Level 3 Expert

5436 Answers

Bill Boyd

Level 3 Expert

53755 Answers

Are you a Sierra Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Sierra Boating

  • Sierra Boating

Most Popular Question

find year manufacture old

  • Boating
Loading...