Top 20 JVC AM FM CD DET FACE CAR STEREO Questions & Answers


your accessory power for the radio is on the wrong circuit,wish the red wire of the radio

JVC AM FM CD DET... | 91 views | 0 helpful votes


I suggest you ensure the ground is made to a sensible ground point and the supplies are also good and the antenna is also properly grounded and then monitor the supply voltage and the current consumed by the radio until it begins to distort. If the voltage and current remain steady the fault is either local interference or inside the radio, probably in the tuner.

If the current climbs and the voltage remains steady the fault is likely in the audio section...

JVC AM FM CD DET... | 338 views | 0 helpful votes


Contact JVC customer service please.

JVC AM FM CD DET... | 2,648 views | 0 helpful votes


Did you verify it has 12 volts on it's main power wire? Make sure the ground connection is good?

JVC AM FM CD DET... | 372 views | 0 helpful votes


It has to be taken to service or to the dealer.

JVC AM FM CD DET... | 153 views | 0 helpful votes


Are you a technical person? If so, reply. Otherwise it is advisable to take it to a service center.

JVC AM FM CD DET... | 1,231 views | 0 helpful votes


Instructions
    • 1Remove the faceplate around your stereo. Slip a flat object under the edge and gently pry it up. A flat-head screwdriver works well. There will be clips holding the faceplate in place, so feel for them. You may need to move your faceplate up or down to slide it out of position.
    • 2 Find and remove any screws holding the stereo in place.
    • 3 Slide the stereo component out far enough to see the label on top of the stereo. Write down the model and serial numbers of your car stereo component.
    • 4 Locate your VIN number at the base of the front window, driver side. If you can't read your VIN off the window, you will have it on your proof of insurance and title as well. Write it down.
    • 5 Locate your car manufacturer's toll-free Customer Service number and call them. Click on the link in the Resource section of this article and find your car manufacturer's toll-free number.
    • 6 Call the number and let customer service know you need your stereo code and have the vehicle's VIN number, as well as the model and serial numbers off the stereo. They will provide you with the code. If you are unsure how to input the code, be sure to ask for support at this time.

JVC AM FM CD DET... | 276 views | 0 helpful votes


You would have to reach out directly to your GMC dealership for a schematic for your car.

JVC AM FM CD DET... | 519 views | 0 helpful votes


If you have a JVC in your car now, you will need the extraction keys that were given with the radio. (thin sheet metal keys) that allow radio to be removed. They can be purchased by calling JVC once you know model or reach out to installer who might have them available.

JVC AM FM CD DET... | 60 views | 0 helpful votes


Your CD may not be music CD. Some car radio doesn't accept MP3 or WMV files. Change it to a good radio such as JVC car radio.

JVC AM FM CD DET... | 177 views | 0 helpful votes


This answer is found on page 16 of manual. goto BT mode and Press and hold [MENU]. Select
[BLUETOOTH]->
[DELETE PAIR]->[PHONE NAME]-> [DELETE YES]->DELETED!

JVC AM FM CD DET... | 622 views | 0 helpful votes


The instruction book can be downloaded from books.jvc.com.

JVC AM FM CD DET... | 106 views | 0 helpful votes


The best advice for a quick solution is for you to look at your fuse box. It should indicate right there what fuse is for the radio. If not, look at all of the fuses and replace the one that is blown.

JVC AM FM CD DET... | 68 views | 0 helpful votes


This is not a question for JVC but more for GMC. On the JVC radio side, if it can be controlled via steering wheel, you will see a blue with yellow stripe cable that states [STEERING WHEEL]. Not all radios can adapt to steering wheels controls.

JVC AM FM CD DET... | 133 views | 0 helpful votes


MISWIRING OR CHKWIRING is displayed when there is a DC offset voltage detected at the speaker terminals ('+' and '-').

This is normally caused by connecting a '+' or '-' speaker wire to either GND or Vcc (+12V).

1. Collect cable not being used and make sure they are tapped off and reset

2. Remove a connected cable one at a time and press RESET

3. If after a cable removal and reset the error goes away, last cable removed was fault. Examine cable for short.

4. If you remove and reset all cables except for (RED, YELLOW, and BLACK) and you stilll have error, the short is internal of unit and requires service

JVC AM FM CD DET... | 1,586 views | 0 helpful votes


samsung tv go in to tools on remote

JVC AM FM CD DET... | 40 views | 0 helpful votes


I am confused with your question. All JVC radios have extraction keys given to remove if you are trying to uninstall.

JVC AM FM CD DET... | 50 views | 0 helpful votes


What is the model of the JVC radio? What is the "code" that you are seeing?

JVC AM FM CD DET... | 31 views | 0 helpful votes

Not finding what you are looking for?
JVC AM FM CD DET FACE CAR STEREO Logo

916 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top JVC Car Audio & Video Experts

Dalynn Turner

Level 2 Expert

346 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8984 Answers

Are you a JVC Car Audio and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

JVC Car Audio & Video

  • JVC Car Audio & Video

Most Popular Question

2010 vw cc factory stereo amp popping

  • Car Audio & Video
Loading...