20 Most Recent Canon NP 7130 Black and White Copier - Page 6 Questions & Answers


clean the scanner glass. There is probably a tiny dot thats the culprit.

Canon NP 7130... | Answered on Jul 06, 2008


It could be a bad voltage board, which is not supplying enough power to the lamp.

Canon NP 7130... | Answered on Jun 30, 2008


the error code you are refering to is not an inverted 83 is in actuality an E803 flashed by an E8 followed by an 03.Basically your 24V dc is either being shorted somwhere internally or the DC controller or composite PCB needs to be replaced in either case the cost associated with replacing either curcuit board would far exceed the value of the copier.

Canon NP 7130... | Answered on Jun 07, 2008


Hello joeboo123,
The fact that you had the foresight to ask the question leads me to believe you can do it.Your question was is it easy. Well, its one of those things that is easy to anyone who has done it before. My suggestion would be to order the drum/developer cartridge, instructions are enclosed. This device was designed to be to a large extent consumer serviceable,and the drum is one of the items. I have to admit it is more difficult than Canon seems to believe it is. However, if you take your time, you can do it. The drum unit is to a large degree protected from mild probing. So you can fart around a little as you try and as long as you dont force anything you will be ok. In my opinion you ,at a minimum will be able to purchase the drum without having to pay a 3rd party. And in the event you find that you can't install the drum or just plain feel uncomfortable, you can always call in the calvary. At least you will have purchased the drum without paying the copier dude (I AM ONE LOL ) and his company the additional mark-up on the item. Again, it is awkward to install the first time. Just take your time. When it falls into place you will grin like a set of high beams. I have been working on copiers for over 20 years, which means nothing. I mite have left a trail of disaster for 20 years for all you know. But I am being honest that I believe you can do it. Take care and good luck. ............spinal...

Canon NP 7130... | Answered on Apr 18, 2008


This is the add toner light. Replace the tube of toner and will be well.

Canon NP 7130... | Answered on Dec 28, 2007


hi im jules_09.have check the drum unit and the fuser unit check the two unit.first of all the drum unit the drum may be scratch or damage that goes with the fuser unit too.

Canon NP 7130... | Answered on Dec 13, 2007


hi im jules_09,you should not use compatible consumables for the copier sometime np7130 copier are nasty specially with opc drum,if the copy is blnk the problem is in the high voltage unit or in the transfer unit and drum charge unit you might have the wrong process replacing the drum.re install the drum then try it again .

Canon NP 7130... | Answered on Dec 02, 2007


hi im jules_09.at the packaging of the drum has a instruction that will show you the process in replacing he drum or just open the front door of the copier the drum unit has a lock for you to lit up just a small lever or 2 lever.after that you can easily full out the drum.just remember just dont let the drum before be expose to light it is sensitve to mit.5minutes is enough time for it to be expose morethan that the drum becomes deffective

Canon NP 7130... | Answered on Nov 21, 2007


Yes, it sounds as if the lamp has blown. These are halogen lamps on the older models and run over $100 to $150 or more depending on the make. Usually if you take the platten glass off, you can slide the scanner over and see where the screws that mount the lamp end contact down are. BE SURE TO UNPLUG THE MACHINE BEFORE ATTEMPTING TO DO ANYTHING, ESPECIALLY IN THE SECTION, OR ANYTIME YOU TAKE ANY COVER OR PANEL OFF!!!!!!!!! The halogen lamps use 120v ac and will bite! They are very delicate lamps, and you cannot touch them, or the oil in your skin will cause it to blow again...an expensive mistake. make sure the contacts are in place well before you finish. And make sure to check your existing lamp on a meter for continuity... to mke sure it is blown and not just a bad lamp board. Yes, it's all very tricky and kinda dangerous, that's why we charge "so much" in the service industry.
Good luck, and you may find it cheaper to just replace the machine with a lesser make from a local dealer or office supply company.

Canon NP 7130... | Answered on Nov 21, 2007


Make sure that the black plastic arm just to the right of the gray drum release handle is in the proper position. This arm sometimes gets knocked out of position when engaging the tube of new toner. When the copier is clammed closed, this will sometimes come down on the right side of the post on the bottom front cover. This will move the developer far enough away from the drum to make blank copies. Hope this helps.

Canon NP 7130... | Answered on Nov 13, 2007


Is it copying the size of a Letter paper?
If yes it's not set to Legal, go in the menu and set to Legal.

Canon NP 7130... | Answered on Oct 26, 2007


GOOGLE MIGHT HAVE THE ANSWER

Canon Office... | Answered 20 hours ago


check the developing unit, gears get clogged sometimes

Canon Office... | Answered Yesterday


Download inkpad resetter and reset it.

Canon Office... | Answered 2 days ago


Can you remove the ink from the printer then power it off.
then using a Q-Tip with cleaning alcohol (or warm water if you do not have any), clean out the areas where the ink goes in.
Then use a damp cloth and wipe down the inside of the printer.
Once done, let it dry for 10 minutes
Then put the ink back in, power it on and tell me if it then prints correctly please
This will also allow you to see if any foreign objects are in the printer which may cause this.

Canon Office... | Answered 3 days ago

Not finding what you are looking for?
Canon NP 7130 Black and White Copier Logo

136 questions posted

Ask a Question

Usually answered in minutes!

Top Canon Office Equipment & Supplies Experts

Clive
Clive

Level 3 Expert

4345 Answers

old marine
old marine

Level 3 Expert

2260 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Canon Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Canon Office Equipment & Supplies

  • Canon Office Equipment & Supplies

Most Popular Question

doesn 39 t feed paper shows p

  • Office Equipment & Supplies
Loading...