Questions & Answers
Canon hole punch
Go into the printer options settings on the PC and make sure the "punch" is enabled. Especially on Windows PCs, it's common that not all the options are communicated between a network printer and the computer.
157 views | 0 helpful votes
Check the destination.Change the settings on the file server to enable access to the folder, or contact the server administrator.
48 views | 0 helpful votes
The problem is about error 000002 0000 for my ir6000
1) Is the developing assembly locking plate mounted correctly?
NO: Mount the plate correctly.
2) Is the shutter releasing member of the hopper mouth mounted correctly
to the developing assembly locking plate?
NO: It is likely that the inside of the hopper is clogged with toner. Remove
and then mount back the shutter releasing member to remove
the clog, or replace the hopper unit.
General condition, Developing assembly toner sensor (TS1)
3) Is the developing assembly adequately provided with toner?
YES: Check the developing assembly toner sensor.
General condition, Hopper toner sensor (TS2)
4) Is the hopper adequately provided with toner?
NO: Check the hopper toner sensor.
Hopper connector, Hopper supply motor (M10)
5) Is the connection of the hopper connector normal?
NO: Connect the connector securely.
YES: Check the hopper supply motor.
211 views | 0 helpful votes
Ir 7200 error 732-001
e0732-001 trouble in control board or scanner, check it out...
check also the communication of them... (cable or socket)
349 views | 2 helpful votes
Error code E000069-0000
Error code E000069-0000: "corona transfer error"
This is an error regarding a problem with the transfer corona, it seems you had a high voltage spike on your machine, causing this error.
There are different causes for these errors, one of the most common is the dirt on the transfer corona to become operational will provoke "jumper" between the contacts.
What you can do is to spray air above the corona to remove the toner accumulatedand if the fault still need to clean more thoroughly.
Note: The corona tends at times to fail randomly.
422 views | 0 helpful votes
Error code E000732-0001 on Image
Error code E000732 is a communication problem from the main reader to the controller unit. Shut machine off remove and reattach the reader cable. Make sure it isn't broken or damaged. Turn back on again. If cables are making a good connection this error message goes away. Else you may have a problem on the controller side. Good Luck.
497 views | 4 helpful votes
related to developer module .are u using loose toner.if so change the toner but first clean ur developer module for all toner and also check the toner motor and hopper .it is density of toner that is causingthe problem
88 views | 0 helpful votes
Not finding what you are looking for?