Top 20 Hitachi 61SDX01B 61" Rear Projection Television - Page 4 Questions & Answers


how old is the set? if its more than 4 or 5 yrs old buy a new one and did u contact hitachi? if not try them depending on how old it is maybe they fix it if not the should atleast tell u the correct problem

Hitachi 61SDX01B... | 129 views | 0 helpful votes


use the advanced options page and reset the factor blue and red convergence defaults then do re apply the auto color defaults color at first it seemed very red (which is good because red was the missing factor in the green picture) but after reseting all the color and tints to the normal ranges I then reset the color auto correct again and all seems fine.

Hitachi 61SDX01B... | 298 views | 0 helpful votes


Sounds like a convergence promblem.

Here are some of the most common symptoms of a convergence problem.

Screen looks 3D
One or more colors can't be adjusted when using the convergence menu.
Screen is bowed in or warped.

Here is a quick test....

Using your original remote go-to the tv settings then goto the convergence or magic focus section.

Try to adjust the convergence.

You should be able to move them up, down, left, and right.

If you can't move them in all directions your convergence chips are bad and should be replaced. This is a common problem.

Its a fairly easy fix on the Hitachi sets.

You can get a repair kit that includes all the parts from www.TvRepairKits.com. The kit includes a photo instruction guide, original Sanyo STK chips, convergence resistors, etc.
Everything you need to fix it yourself.

Hitachi 61SDX01B... | 686 views | 2 helpful votes


Sounds like a loose connection in the convergance amp ic's

Hitachi 61SDX01B... | 135 views | 0 helpful votes


skimo, service manual part number is "SM-PA0131" I doubt you can order the whole module anymore set is 2000 yr model, why do you want to order the whole module any way? Big bucks if it is available, BMW Rider

Hitachi 61SDX01B... | 92 views | 0 helpful votes


The problem is called green geometry.There is nothing wrong w/the green pix tube.It is critical to get the green geometry

accurate because the red and blue convergence overlays on

the green.If you have more than an alignment issue,that will need

repair before adjustments are attempted.

Hitachi 61SDX01B... | 238 views | 0 helpful votes


have you tried doing convergence from the menu? and them magic focus?

Hitachi 61SDX01B... | 162 views | 0 helpful votes


Can you find out what Led is not on or which comes up and goes out? Most of these sets have convergence problems. Or Power Regulators.

Hitachi 61SDX01B... | 221 views | 0 helpful votes


KIT10 $29.50
Repair Kit for Hitachi convergence Chassis DP-14G
KIT10 Includes 2 pcs STK392-150 , 1 each of the following 1W axial lead fusible resistors:


http://www.digitalhome.ca/forum/showpost.php?p=564268&postcount=220
http://cmpalmer.blogspot.com/2006/11/fixing-my-own-tv-part-ii.html

Hitachi 61SDX01B... | 97 views | 0 helpful votes


Excellent visual acuity technique!! I try to teach that procedure.

IC F6629B is probably shorted and at least one other part will

be open, possibly a zener diode,a fuse,a resistor or combo.

The service diagram would help.Be sure to use OEM first quality

parts.Let me know if you need more help.

Hitachi 61SDX01B... | 145 views | 0 helpful votes


I had this same problem and unplugged the TV from the a power strip and plugged it directly into the wall... problem solved.

I read elsewhere that this is called a "ground loop."

Hitachi 61SDX01B... | 193 views | 1 helpful votes


Most likely the power supply. In most models, if the lamp goes out you will still get sound. However, the power supply is not a single piece swap. I would suggest getting a voltmeter, and check the voltage where the power cord meets the power supply. Then follow the circuit pathways, checking after each component, until you find a break in power. You are getting power to that light, so some power is getting through. However, the light works on much less voltage than the rest of the television, so probably there is a capacitor or transformer that's gone out.

Hitachi 61SDX01B... | 78 views | 0 helpful votes


Check your powercord. Unplug it overnight, then plug the power cord back in the morning. If that doesnt help, it means that something is going on with your set. Sometimes your power cord has shorted out and needs to be replaced. Generally you can find them under $100 depending upon your set...

Hitachi 61SDX01B... | 45 views | 0 helpful votes


Sounds like the blue convergence circuit still not working.

Assuming both IC's are good, look for open soldered-in pico fuse.

Once bowing problem is solved,then convergence should adjust ok.     

Hitachi 61SDX01B... | 72 views | 0 helpful votes


hook up to antenna then go to tv air set up then channel search

Hitachi... | 41 views | 0 helpful votes


The applicable code would be found in a compatible remote control.

Hitachi... | 20 views | 0 helpful votes

Not finding what you are looking for?
Hitachi 61SDX01B 61" Rear Projection Television Logo

90 questions posted

Ask a Question

Usually answered in minutes!

Top Hitachi Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76204 Answers

matt martin
matt martin

Level 3 Expert

1257 Answers

Todd Hill
Todd Hill

Level 2 Expert

433 Answers

Are you a Hitachi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Hitachi Televison & Video

  • Hitachi Televison & Video

Most Popular Question

61swx01w magic focus still

  • Televison & Video
Loading...