20 Most Recent Beko DSV64W White Vented Tumble Dryer 6 kg, 9 Cycles Questions & Answers

empty the small reservoir around the back
there's a single screw to take out and siphon the water out with a small bore pipe I used two drinking straws taped together

you will see the float go down and turn the switch off

Beko DSV64W... | Answered on Sep 22, 2019

go into service mode and reset

to do this move to delicates turn on dryer and keep
pressed down cancel button for about ten seconds release
then all lights should flash when you press cancel again machine will go through test mode , then just turn machine off
it is now reset, this worked for min a drcs68w

Beko DSV64W... | Answered on Feb 09, 2019

Check the power receptacle for proper voltage. You might have a failed circuit breaker. Sometimes one side will trip without moving the reset handle.

Beko DSV64W... | Answered on Nov 24, 2018

Could be improper voltage, thermal fuse, control board, door switch, wiring, motor, and maybe a few things I’m leaving out.

Beko DSV64W... | Answered on Nov 20, 2018

go to


then click select your country on the top right

then find the support sites (they all are a little different)

here you should be able to get the manual if you have the correct model number

Beko DSV64W... | Answered on Nov 27, 2015


A loose or worn BELT can make funny noises

Or the idler pulley that puts tension on the dryer drum drive belt could be worn out. If the pulley is bad we recommend also replacing the belt.

The glides on drum worn and making metal to metal contact.

The drum slides or glides support the front of the drum. As the drum rotates over the years, the glides wear out and then the dryer makes noise. Replace all of the glides as a set if they are worn out.


Sometimes an item can get stuck inbetween the drum and the housing and scrape and grind making funny noises, things like coins, bra wire, nails, hair pins, etc sometimes u can just remove the cabinet and observe by turning the drum by hand or looking for scratch or scrape marks on housing.

The blower:

Clumps of lint, socks, and other small articles of clothing can get past the lint filter and into the blower wheel. If the dryer makes noise, and the noise seems to be at a very fast pace, there might be something caught in the blower wheel. In addition, the blower wheel sleeve might be worn out, allowing the blower wheel to wobble on the motor shaft. If this happens, replace the blower wheel.

The bearings:

The drum bearing supports the rear of the dryer drum. If the dryer makes noise this bearing might be worn out. Replace the bearing if it is worn out. Do not lubricate the bearing, the lubrication will attract lint and dirt and accelerate the wearing process.

The bearings TEST by moving drum by hand u may be able to feel loose or rough movement. And listen to sounds when turning it.

The drum rollers or castors:

It is very common for dryer drum rollers to wear out. If the dryer makes noise, particularly a loud rumbling noise, one or more of the rollers may be worn out. After removing the drum from the dryer, inspect the rollers.

Check for cracks, dryness, or damage and not engaging drum properly. Sometimes u can use high density LITHIUM BASE gear grease to re oil/grease them.







Beko DSV64W... | Answered on May 22, 2015

Unfortunately, if you double-check me here at the SPECIFICATIONS page of this dryers website link, it does not appear that this door IS interchangeable. I hope for your sake to be wrong but cannot find any information to state otherwise:

See here: http://www.beko.co.uk/Item/DSV64


Beko DSV64W... | Answered on Nov 25, 2014

hi take top off hold back of drum see if u can pull it up if you can feel play its more than liklely the bearing wot dryer is it

Beko Dryers | Answered on Feb 13, 2014

no we would not. try your local auto parts suppliers store

Dryers | Answered 9 hours ago

Hampton Bay Fan. The vendor MAY be Home Depot.

Need replacement globe for Hampton Bay ceiling fan & light ...

community.homedepot.com > howto > DiscussionDetail

Nov 18, 2018 - Hey Erovinmo,. Thanks for your question and welcome to the community. To get the replacement globe for your Hampton Bay ceiling fan, ...

Ceiling Fan - Need manual ' The Home Depot Community

community.homedepot.com > howto > DiscussionDetail

Jul 28, 2016 - Bought from Vendor #445993. Brand- Hampton Bay. Remote has stopped working. Changed batteries. When I look up this UPC code to get ...

I have a ceiling fan that has a sticker on it with Vendor ...

www.justanswer.com > ... > Electrical Questions > Ceiling Fan Problems

Nov 2, 2010 - Ok your fan model comes back to a Hampton Bay Ceiling Fan. ... They did tell me however, that Hampton Bay is owned by Home Depot. ... Home Depot has several differen companies that manufacturer fans under the Hampton Bay name.

Hampton Bay Lifetime Motor Warranty - Hampton bay ceiling ...

hamptonlightingadvice.com > files

The retailer warrants the fan motor to be free from defects in workmanship and ... Model No. 844854. Serial No. Vendor No. 445993. '71. UPC '718212349083.

I lost the remote control for my fan light vendor 445993 UPC - Fixya

www.fixya.com > support > t6398305-lost_remote_control_fan_light...

Oct 13, 2010 - You can use a plastic box provided it's listed for fan support. That is, the box can't provide the sole means of supporting the weight of the fan.

Dryers | Answered Yesterday

Not finding what you are looking for?
Beko DSV64W White Vented Tumble Dryer 6 kg, 9 Cycles Logo

9 questions posted

Ask a Question

Usually answered in minutes!

Top Beko Dryers Experts


Level 3 Expert

85223 Answers


Level 3 Expert

369 Answers

Lawrence Oravetz

Level 3 Expert

10543 Answers

Are you a Beko Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Beko Dryers

  • Beko Dryers

Most Popular Question

beko dryer keeps saying water tank full

  • Dryers