20 Most Recent ION Audio IED11 Sound Session Complete Electronics Drum Set Questions & Answers


Good job of troubleshooting... I assumed you have tried other triggers into the kick drum input and found it is dead. This leaves the problem in the "brain". Look in your manual for anything to do with sensitivity of the kick drum input. It is likely all the inouts are sampled and digitized by the same A-D convertor via a multiplexor switch. I was unable to find the schematic of your unit so I downloaded one for a Roland TD8. Often the different companies rob designs from eachother so one can glean methods from a different brand. As expected the inouts are conditioned and then go to a MUXX chip that samples the input. The signals are conditioned before going to the MUX by a limiter and before that there is an RF bypass cap on the input. IF you might have had a static discharge, that capcitor(s) may have shorted rendering those inouts dead. This is what I want you to try:with a suitable cable I would like you to pulse the kick input by momentarily connecting a 9 volt batery to it... try both polarities. If NEITHER polarity fires the kick, then I want you to take an ohmmeter and measure the resistance of the input. The Roland schematic has coupling capcitors and if your brand has similar circuits you should see infinite resistance... if you find it very low, say 100 ohms, probablly the RF bypass cap at the input is shorted. These will be surface mounted caps and you need to be a bit adept at electronic repair to replace them. Essentially I believe you will find a failure in teh interface ckt where those inputs come in.

ION Audio IED11... | Answered on Jun 27, 2015


I understand your pain - was googling for similar, and came across this post, 5 years prior. My SGC Nanyo Bass Collection has just started to play silly beggars with the pots, and a bridge fault. Nowhere online seemed to have any details of the wiring, as the problem is, as you say, the fact that all of the tone and volume pots are based on a printed circuit board. If theres a nick or short on the board, its a pig to replace, and I really wouldn't like to have to wire any pots onto it. I'm currently looking at the options of ripping out the old electrics and wiring it from scratch myself. If you're still after answers, good luck!

PS - noted that none of the previous replies are relevant to this - mostly going on about the amps or a Fender guitar??!

Music | Answered on Dec 05, 2019


Hi there and cheers for examining my bio. I'm just Daryl Ibbott and I'm just residing in Arvada, CO . My own pops and good friend completed study from An In-depth & Unbaised Eat Sleep Burn Review

Music | Answered on Nov 30, 2019


Amazon
https://www.amazon.com/MT-540-Keyboard-replacement-supply-adaptor/dp/B00GQVUMEG

NewEgg
https://www.newegg.com/p/14R-02A5-01UZ4

To verify, often the voltage is stamped on the back of the keyboard, near the power jack. Should say 9V

Music | Answered on Nov 28, 2019


Try here; http://www.synthmanuals.com/manuals/technics/u90/user_manual/

Music | Answered on Nov 28, 2019


Can you please Edit or add a comment to your question, what make and model of organ is it? Have you tried it in a different AC outlet? Do any lights come on when you switch it on? Have you tried the headphone output as well as the speakers? Does it have a line output? What happens when you move the volume knob and or the swell pedal, do you hear any noise?

Music | Answered on Nov 06, 2019


Have you checked that it is not the amp that is the problem? This is a fairly common thing to have the amp heat up and the thermal protection shut it down partly. Since the bass drops, a loose connection or bad guitar cable can cause that. If the signal becomes capacitively coupled only the treble will come through and be very distorted. Try a new cable. For the guitar, open the electronics area and look for loose or broken wire.

Music | Answered on Oct 21, 2019


you found it on search on net

Music | Answered on Oct 16, 2019


The best way is to plug the send to the input then output to return of mixer

Music | Answered on Oct 11, 2019

Not finding what you are looking for?
ION Audio IED11 Sound Session Complete Electronics Drum Set Logo

Popular Tags

2 questions posted

Ask a Question

Usually answered in minutes!

Top ION Audio Music Experts

Michial Gueffroy

Level 3 Expert

1140 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Brad Brown

Level 3 Expert

18121 Answers

Are you an ION Audio Music Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

ION Audio Music

  • ION Audio Music

Most Popular Question

ied 11

  • Music
Loading...