20 Most Recent
Questions & Answers
Fuel line in tank has come loose, where does it connect inside tank
Some just connect externally to a barb fitting, but usually the fuel line and filter are all one piece. They are a bear to remove and replace because most of the new saws have a built in grommet in the fuel line itself to seal the plastic tank hole as it passes through it. Yours may have broken off inside the tank at the grommet. If so, its time for a new line/filter.
John Deere J3816...
on Apr 21, 2015
I have a John Deere Z225 has a 18.5 Briggs and
I'm working on z225 now the fuel pump gets the its vacuum from the crank case for it to pump gas these have a crank case breath hose under the mag to keep it from building up pressure let's the motor breath if this is stopped up it will pull the air it needs through the valve breath hose that runs to the crab while letting the mother breath its not as big as the crank case breathing hose and builds up pressure and pushes oil into the fuel pump pull the crank case hose off and check for oil if thiers oil in it check under the mag fine dirt grass gets under their i hope this helps
on Dec 14, 2019
John deere 310D backhoe will not move in reverse. Reverser oil good, forward good, runs great just not in reverse.
The oil inside for the reverser is good? You found that the oil level was correct, the fluid was clean and no further actions were needed? Usually the failure is the clutch pack but that is seen in the fluid. Can you feel or notice that the shift lever is moving into the gear selection correctly? Do you notice, feel or hear that reverse gear is engaged when selected. Do you hear any noises or sounds that weren't there before the failure? Did this failure happen out of the blue or have you noticed reverse acting up for a while now? Please let me know. Good luck.
on Dec 02, 2019
Not finding what you are looking for?