20 Most Recent
Questions & Answers
I have just inherated the
This problem can be caused by the following, A bad battery, (which you say you are all new). A full base memory and a Faulty main base unit
This main base unit can only expand to four handsets and no more. If the base unit has been reset then the assigned numbers for each handset would begin with " handset 1" if they show any other number when reset then it would not have been reset..To re-set main base you will have to
De-Register All Handsets
Unplug the power supply from the base unit then Remove all handsets from the charge cradles and base then Press and hold the PAGE button on the base.
Plug in the power supply again while pressing the PAGE button, Continue pressing PAGE until the IN USE and CHARGING indicators are lit. (this could take up to 10 seconds)
Release the PAGE button All Handsets will display "enter base id".
If this does not solve your problem then you will have to replace the main base
on Apr 22, 2017
I can not get the handset to charge. Tried a new battery and all solutios in manual
This happens pretty regularly at my house. The solution is pretty simple. I take the batter out and put it back in and put it back into the cradle.
I have four kids at home and the phones are banged around quite a bit. I think the battery just loses a solid connection to the terminal points.
Now, can someone help me find a way to get my teenagers to implement this fix when they hear the battery beeping because of low battery?
on Jan 05, 2014
AT&T phone model E5634B
SOLUTION to AT&T Cordless Telephone/Answering System 4 phone set Model E5634B - Cannot answer incoming calls nor does caller ID work on phones.
Unplug the base for a few minutes, plug base back in, remove and reinsert the battery on each phone that does not work, then place each handset in the base for few minutes. Worked for me...all 4 phones can be answered and caller ID works!!! Hope this works for you... :o)
on Feb 12, 2012
I need a manual to reset.
Well, you can try downloading your manual from the link below -
on Aug 07, 2009
PARALLEL SET ON
That Means That Another Phone or is not responding to the base correctly try unplugging the unit wait 5mins and plug it back in one by one put the phones on the main base charger for at least 5mins this will reset them
on Apr 09, 2009
My AT&T Answering System 1337 has a steady buzz - how do I get rid of it?
Check your ground wire where the phone line comes into the junction box outside your house. It is either loose or corroded. It should be clean and clamped to a ground stake or water pipe like for an outdoor hose faucet. Check both ends of the wire. Without it, the phone system's impedance is so high that it will receive the 60 Hz hum from any electrical appliances around the house that are within a few feet of a line on an extension phone, answering machine or even an extension phone outlet wire running through a wall. These make great receiving antennas. good luck.
on Jan 04, 2019
Not finding what you are looking for?