Questions & Answers
How to cold reset in HP LaserJet 1536 dnf mfp
Resetting the HP LaserJet Pro M1536dnf accomplishes the following:
- Clears all data from the printer's memory (including unprinted data, downloaded fonts, and macros).
- Stops any printing that is taking place and ejects the page.
- Removes some error conditions.
- Resets the printer to its factory default settings.
- Turn off the printer
- Press and hold the Left arrow & Cancel while you turn on the printer
- Once you see Permanent Storage Init you can release the buttons.
- The printer should now start resetting.
HP Printer Support
4,759 views | 0 helpful votes
SCEA 25992 CODE
switch on the printer
while memory counting press 3 then all led will glow stable then press 9 then start button u will find full nvram on display then press 6
32 views | 0 helpful votes
58.04 error is an Engine Power Supply error.
RM1-1041 is the part number for 110v
RM1-1042 is the part number for 220v.
You will need a tech to swap it out. You have to strip the printer down to get to the part.
76 views | 0 helpful votes
Solution57.04 erreur dimprimante hp
57.04 indicates the main fan (FN101) is not working.
Listen for the fan to operate while the printer is initializing. If the fan does not operate during the initialization sequence, replace it.
RK2-0278-000CN Fan, Main Cooling
27 views | 0 helpful votes
Scan multiple pages pdf
I'm assuming that you're trying to scan to your computer.?? I'm not specifically knowledgeable about the HP M4345 printer.... but, it HAS to have a cable connection. The cable should be one that has a usb connection on one end, and a small kind of rectangular plug on the other that plugs into the back of the printer.. Look on the back of the printer. There has to be a connection, besides the jack for the 110 V.
740 views | 0 helpful votes
How to assign ip address for laserjet M4345 when it is reset at 0.0.0.0
1 Press MENU.
2 Touch CONFIGURE DEVICE.
3 Touch I/O.
4 Touch EMBEDDED JETDIRECT MENU or EIO JETDIRECT MENU, depending on which type of
network connection you are using.
5 Touch TCP/IP.
6 Touch CONFIG METHOD, and touch MANUAL.
7 Touch MANUAL SETTINGS
8 Touch IP ADDRESS
9 Touch the left arrow or the right arrow to highlight each segment of the IP address.
10 Use the numeric keypad to type the digits in each segment of the IP address.
11 Touch OK to save the IP address.
1,189 views | 0 helpful votes
Hp 4345 has error code 13.20.00 paper jam in tray
The printer may need a "swing plate" replaced to solve the fuser noise. Remove the fuser and look at the black gear inside the printer on the left side. Do the teeth on that gear look worn ? If so that gear (swing plate) needs to be replaced. Its a hard job to do. Can you turn the fuser gears with it out of the machine without them skipping ? The tray 2 jam may just be worn rollers in tray 2 or a stuck sensor. Good luck !
2,425 views | 0 helpful votes
when powered off the printer, press 3 and 6 and hold, power on, make your choice at menu, (cold reset) and press ok. printer will restart itself.
97 views | 0 helpful votes
Not finding what you are looking for?