20 Most Recent Aurora Electronics AS1018CD Shredder Questions & Answers


there is a lip at the top of the tiny window on the front. Pull it forward like you would pull a file cabinet drawer open. it might take a bit of muscle if it's jammed full of shreddings.

Aurora... | Answered on May 19, 2015


First, look for any screw holes if not then it has an interlocking clips... so be careful when removing it... use proper tools

Aurora... | Answered on Feb 13, 2015


Try the Aurora troubleshooting page at
http://www.auroracorp.com/troubleshooting.html

Aurora... | Answered on May 20, 2014


Cleaning of the paper sensors is essential. Blowing on the center of the paper insert area will clear the paper fibers near the sensor but not all. Since my shredder was way past warranty, I opted to remove the 7 screws on the back of shredder mechanism, gingerly remove the shredding mechanism from its seat and there I found, wedged in between one of the sensors, a solitary paper fiber. That ominous, evil paper fiber was wedged in so tight that even the jet engine blasts from a 747 aircraft would have not dislodged the paper fiber. Making use of a Qtip, I dislodged the paper fiber, cleaned out all remaining paper fibers in and around the inside of the housing, then reassembled the unit. It has worked satisfactorily since then.

Aurora... | Answered on Jul 17, 2013


I FIXED MINE!!! Hey folks same problem AS1018CD would not shut off. CURE: Take apart and clean electronic eye. PROCEDURE: 1. Unplug. 2.  Remove shredder and turn upside down. 3. Remove 6 phillips head screws on back of unit ( 1 is under sticker in middle peel back sticker to access screw. 4. Carefully separate unit. 5. Pull off shredder piece. It is a snug rubber grommet fit and just lifts off( gears everything comes off as one piece. 6. Electric Eye is exposed remove screw holding in and gently slide out and wipe clean. Do both sides. While apart clear all debris and wipe entire unit as clean as you can. Put gear assembly back on grommets. Put top and bottom back together. Replace screws. Plug in. FIXED :-)

Aurora... | Answered on Jul 28, 2012


My boss has a shredder that will not run unless the bin is exactly centered in the bottom of the unit. There is a safety switch inside there, and a magnet to activate it. Make sure nothing is interfering with the bin or the shredder fitting together.
On other units, there is a slot that must match up with the shredder. It will only work one way. See of the shredder will turn around and put it on the bin the other way.

Aurora... | Answered on Mar 10, 2012


shredder cloged will not work

Aurora... | Answered on Aug 23, 2011


1 more screw at the back covered by a label

Aurora... | Answered on Aug 01, 2011

Not finding what you are looking for?
Aurora Electronics AS1018CD Shredder Logo

50 questions posted

Ask a Question

Usually answered in minutes!

Top Aurora Electronics Office Equipment & Supplies Experts

Jim Keysor

Level 2 Expert

331 Answers

Vincent G
Vincent G

Level 3 Expert

2361 Answers

chargerhp
chargerhp

Level 3 Expert

815 Answers

Are you an Aurora Electronics Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Aurora Electronics Office Equipment & Supplies

  • Aurora Electronics Office Equipment & Supplies

Most Popular Question

light will not shred or backup reverse

  • Office Equipment & Supplies
Loading...