20 Most Recent Ariston Technologies AW129NA 16 Lbs Front Load Washer Questions & Answers


This video will show you how to keep your soap draw clear and how to service the parts
Please remember to subscribe to our YouTube channel for all appliance tutorials
a 4 THUMBS rating is appreciated for answering your FREE question.

Ariston... | Answered on Jul 30, 2013


it is poss that you pressure system has not released, and this can keep the door closed. Unplugging it will not cure this fault. It is also poss that you have a blocked filter or waste. Unfortunatly has you are older people I would call an engineer

Ariston... | Answered on May 30, 2012


Many times faults like this can be cured by Uplugging the washer from the mains power supply and leaving for 10mins. Also check all filters, drain and supply lines are clear and not kinked.

Ariston... | Answered on May 04, 2011


Hi.

The procedure is quite complicate, because the seal is secured to the front panel, and you will need to remove top panel, detergent drawer and access control assembly

  1. Disconnect appliance from power
  2. Remove the door, held by two screws located on the rear side of the lid.
  3. Lift the top panel, held by two screws at back.
  4. Undo the two screws joining the detergent dispenser to the inlet valve.
  5. Undo the two screws located at the front corners. So to release the fascia and dispenser.
  6. take out fascia and the dispenser alltogether and put it on one side. Take care to not disconnect wiring and do not drop parts.
  7. Release the retaining wire that keep the seal secured to the front panel. Look after it, you will need it again.
  8. Undo the two screws that hold the front pane. They are located on the front side.
  9. Remove the kick panel
  10. Behind the the kick panel you will find the two screws that will release the front panel, remove both of them.
  11. Disconnect the door switch conntector.
  12. Lift the front panel. You may need to help yourself using a putty knife.
  13. Remove the clip with two hooks inside, it is located at about one o clock. This will finally release the seal.
  14. Remove the seal and clean the area where you will fit the new seal.
  15. Start mounting the seal from the lower part on the right, at about four o clock. You will notice the seal matching.
  16. Put back the retaining wire usingf long-nose pliers to put the wire in tension.
  17. Reassemble the washer in reverse order.

Unfortunately we do not have step by step pictures. I hope that my instructions had been enough clear and detailed.

Regards.

Ariston... | Answered on Apr 08, 2010


Take out the filter and wash it thoroughly, also flush the outpipe to make sure the whole system is clean. Does it give you an error code?

Ariston... | Answered on Feb 02, 2010


SOUNDS LIKE THE HEATING ELEMENT HAS GONE

Ariston... | Answered on Jan 09, 2010


hi,
The cycle doesn't advance
When the cycle doesn't advance, it's probably the timer or a cold-water supply problem:

It's the timer, if your washing machine fills with water and begins agitating, but the timer never advances--or if the washer is in a spin cycle and the timer won't advance. Then you need to replace the timer. 


It may be a cold-water supply problem, if the washing machine fills with water, agitates, drains, and spins, but then doesn't fill with rinse water. See There's no cold water.

Thanks for your question.

Ariston... | Answered on Jan 20, 2009


Dear babmat: just now got your question. We are very satisfied with our ARISTON Washing Machine. I trust that that is what you are inquired about? I had the same problem the first time. This locking occurs when one opens or tries to open the washing machine door too soon!!!! It has to be left alone for a few minutes. When I waited and later tried again to open the machine, I did not have a problem.
Just wanted to leave this note for anyone who encountered the same problem. You, yourself, hopefully, might have gotten that answer and the problem fixed in the meantime!?
Greetings, handinovice

Ariston... | Answered on Nov 01, 2008


try pause/cancel twice to open door open detergent disp look for a plastic string and pull it

Ariston... | Answered on Dec 31, 2007


Pump fault or more likely blocked filter try cleaning should reset it self

Ariston... | Answered on May 06, 2019


If it is a child lock, normally by pressing and holding the Child Lock Button. Sometimes it requires two buttons, from Off, press and hold the On button and the Child Lock button for 6 seconds.

For other lock problems, see the videos

https://www.google.com/search?q=unlock+my+ariston+washing+machine

Ariston... | Answered on Feb 24, 2019


did you check breaker in breaker panel

Ariston... | Answered on Jan 05, 2019


https://www.needapplianceparts.com/aristonerrorcodes.aspx.

Ariston... | Answered on Dec 16, 2018

Not finding what you are looking for?
Ariston Technologies AW129NA 16 Lbs Front Load Washer Logo

23 questions posted

Ask a Question

Usually answered in minutes!

Top Ariston Technologies Washing Machines Experts

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Harjeet Singh

Level 2 Expert

109 Answers

Are you an Ariston Technologies Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Ariston Technologies Washing Machines

  • Ariston Technologies Washing Machines

Most Popular Question

washing machine door will not open

  • Washing Machines
Loading...