20 Most Recent KitchenAid Architect ® II KEBS208S Electric Double Oven Questions & Answers


Although fault code "F6E6" most often indicates a communication failure between the User Interface and Appliance Manager board (Service Pointer W10538518), it could also indicate an incorrect electrical connection at the customer's home junction box. Sounds like you have some wires crossed!

KitchenAid... | Answered on Aug 30, 2016


Hello

The only way to adjust the hinges is to replace the hinge it self but you have to replace both sides to get the right pull.You can go to www. searspartdirect.com and order 2 W10174285 hinges $21.90 each plus shipping.to put these on you have to remove the door and then separate the inner liner from the outer door.(its not hard) just sounds like it its only a couple of screws!!!

THANK YOU FOR VISITING FIXYA

KitchenAid... | Answered on Jan 31, 2011


Hi, Check to see if there are any lights working, such as the ones that come on when you open the oven doors. If there is absolutely no power going to the unit, check the household circuit breaker panel that services the oven.
An oven works at 240 volts so the circuit breaker for it will be a double breaker, similar to the ones
electric water heaters or air conditioning units. It may have tripped. If it is tripped, then
the lever connecting the two sides of the breaker will not line up with other breaker switches in the
breaker panel. If that is the case, shut down the breaker completely and then after about 10 seconds,
turn it back on. If it will not stay on, there is an electrical problem in the circuit going to the oven or the oven itself. Hope this helps. Let me know if your need more help.
Best,
Mark

KitchenAid... | Answered on Dec 30, 2010


Hi,


If your electric oven is taking too long to heat or just not heating up right, then check out this tip that will give more detail about your problem.

Oven Problems Electric Oven is Heating Slowly or Poorly

heatman101

KitchenAid... | Answered on Dec 26, 2010


the only way to adjust the hinges is to replace the hinge it self but you have to replace both sides to get the right pull go to www.searspartsdirect.com and order 2 W10174285 hinges $21.90 each plus shipping.to put these on you have to remove the door and then separate the inner liner from the outer door.(its not hard) just sounds like it its only a couple of screws!!!

KitchenAid... | Answered on Dec 23, 2010


Here is a web blog pertaining to your problem. The first blog describes the PF error coming up, and then turning into another error after they tried some things:
http://forum.doityourself.com/kitchen-laundry-large-electric-appliances/299820-error-code-f2-e1-kitchenaid.html
It could be that you can reseat the connector, or it could be a bad control board, but that would take some testing, to make sure it's not a bad thermostate control, etc.
A lot of people have had problems with Kitchenaid's ovens, and some problems have been settle by Kitchenaid. This site explains problems with the self-cleaning function that many have had:
http://www.ihfex.com/Wall-Ovens/Kitchenaid-Wall-Ovens/
This blog explained how one person had a problem with the self-cleaning function, and Kitchenaid replaced their unit:
http://www.epinions.com/reviews/KitchenAid_DBL_OVEN_T_C_OVER_T_C9
I would contact Kitchenaid, and see if there is a recall or some support they can provide. This is clearly a common problem with these units, and they haven't remedied it, from what I read.
Here is Kitchenaid's support page:
http://www.kitchenaid.com/flash.cmd?/#/page/customer-service
Good luck, thanks for using FixYa, and hope this helps.

KitchenAid... | Answered on Aug 24, 2010


I have a 2yo Kitchenaid oven, and my advice is first, don't use convection for cakes or pizza. Use the thermal oven. For pizza preheat to 500 degrees, then put the pizza on the lowest rack, and bake for 7-8 minutes.This way the bottom browns, and the top doesn't get broiled from the top element coming on during the bake cycle.

As for cakes, again place them on the low rack so that they get bottom heat. I keep my eye on the oven and when the broil element comes on I stick a piece of foil over the cake until it goes off. Otherwise it will set the top and the cake won't rise as much. Even doing that cakes don't rise as much as they did in my old oven, and they brown too much on top.

The convection oven does a good job of cookies, and the broil mode is okay.

I wish I hadn't bought this oven, but I didn't know about the upper (broil) element coming on during the bake cycle until I'd had it for awhile, and it was too late to return it.

If anyone's shopping for an oven, ask questions, and don't get one that maintains the oven temperature by activating the broil element when baking.

KitchenAid... | Answered on Dec 30, 2009


if you cant program it for more than the 270 you may have changed it from farienhiet ( bad spelling) to celcius. pushing and holding broil may switch it back.

KitchenAid... | Answered on May 02, 2009


First,

Disconnect the power from the oven and let it sit for at least a few minutes. Then reconnect the power and see if it unlocks.

If not you may need an oven latch replacement.

KitchenAid... | Answered on Mar 29, 2009


If voltage to display board bad if no voltage to display check voltage to control board

KitchenAid Ovens | Answered on Aug 22, 2019


Hi, my name is Audrey. I am a KitchenAid employee and would appreciate the opportunity to assist you with your oven. Please send me an email through our customer service address,

KitchenAid_CustomerExperience@KitchenAid.com and type 'Attention: Audrey' in the subject line. Please include your full name, phone number, and model and serial number, and I would be happy to try to help resolve the situation with your appliance.

KitchenAid Ovens | Answered on Aug 07, 2019


Hello Susan Bailey,
Typically "THEY" do...
It would be really great to know if we are talking about a USA domestic product...
or another NATIONALITY.
Other countries normally have FUSES in the
appliance cords.

Find your MODEL NUMBER and go to a PART/SPARES
supplier ( I like appliancepartspros.com )
-> appliancepartspros.com
If this is a "MICROWAVE" the FUSE will start popping because the MAGNETRON has deteriorated
and is CONSUMING it's own energy.

I can be a LOT MORE specific if you provide a
model number (pretty please).
Read minds... Cannot rally do...!!
https://en.wikipedia.org/wiki/Carnac_the_Magnificent

KitchenAid Ovens | Answered on Jun 25, 2019

Not finding what you are looking for?
KitchenAid Architect ® II KEBS208S Electric Double Oven Logo

Popular Tags

15 questions posted

Ask a Question

Usually answered in minutes!

Top KitchenAid Ovens Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

jdthefixer

Level 3 Expert

746 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a KitchenAid Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

KitchenAid Ovens

  • KitchenAid Ovens

Most Popular Question

lower oven door not close tight

  • Ovens
Loading...