20 Most Recent
Questions & Answers
How to replace cam drive on andis super 2 speed
ok you need to take the upper cassing off, remove the hinge assembly and the circuit board now the motor unit should come away from the lower cassing.
remove the clips holding the carbon brushes in place beware there are springs behind these clips, remove the two long black clips holding the front and rear motor frames to the field coil and then pull apart. This will allow access to the armature and then simply unscrew the drive cam.
Totaly dismantle all the parts of your Andis AGC clipper.
on Feb 27, 2016
Andis Super 2 Speed AGC Clippers - The blades get very hot !
Buy some Kool Lube (Oster) or Andis Blade Coolant. Both are aerosols. Your 2-speed runs faster, so your blades heat up quicker. Check them often by touching them to your inner wrist, and spray them when they are hot. A bonus is that the sprays also disinfect! (FYI a hot blade can badly burn a pet, so make sure you keep them cool)
on Feb 18, 2010
Putting blade back on my Andis dog clipper
It sounds like you may have a bent hinge which is what the blade slides onto. Please call Andis customer service at 1-800-558-9441 to speak with a customer service rep. They can give you instructions on where to purchase a new hinge or send or clippers in for repair.
on Jul 23, 2008
Not finding what you are looking for?