20 Most Recent Mitsubishi Mr. Slim MXZ30TN Air Conditioner - Page 10 Questions & Answers


I need the complete circuit diagram without I have no clue

Mitsubishi Mr.... | Answered on Jan 24, 2012


Out door unit, Condensor not connected

Mitsubishi Mr.... | Answered on Jan 24, 2012


Yes but I do not want to have to cycle power manually I would like to change circuit.

Mitsubishi Mr.... | Answered on Jan 24, 2012


the fan has a circuit that faults with error E6 because the circuit is looking for outside condensor unit. I would like to run the fan as a stand alone.

Mitsubishi Mr.... | Answered on Jan 24, 2012


I do not know what P 6 means?

Mitsubishi Mr.... | Answered on Jan 24, 2012


S1 and S2 is the 220vac S3 is the commuicating connection to the outside airhandler. The solution is on the control board that handle the remote funtions

Mitsubishi Mr.... | Answered on Jan 24, 2012


The bearing needs to be replaced that holds the fan.Suggest replacing both sides.

Mitsubishi Mr.... | Answered on Nov 01, 2011


clean the blower and check again. If still problem, check if any broken leaf in wheel.

Mitsubishi Mr.... | Answered on Oct 27, 2011


Out door unit malfunction.

Mitsubishi Mr.... | Answered on Oct 27, 2011


Drain pipe line full of dust. You have to service the indoor.

Mitsubishi Mr.... | Answered on Oct 27, 2011


Simple. Unscrew the front panel and remove the front cover. now its visable of your blower motor. take long toothbrush or tied with a stick, slowly brush your blower teeth. and then keep a news paper covering your indoor and switch on. All the dust will fall down not spread over the room. Refix the front panel and screw again. Don't forget to clean air filter too. Thanks.

Mitsubishi Mr.... | Answered on Oct 27, 2011


It sounds like you know the problem and the sollution is to clean it. these system require rutine cleanings every 6 months because they have condensation always in the pan

Mitsubishi Mr.... | Answered on Oct 14, 2011


The highest percentage is to be clogged with dirt Wading in water, should remove the entire mask and left side in Wading, check any rate, the extra drainage Has blocked too

Mitsubishi Mr.... | Answered on Oct 08, 2011


Checking out the cable of the communication of internal and external drives and after connecting the stream to the outdoor unit.

Mitsubishi Mr.... | Answered on Oct 08, 2011


I do not understand exactly what is not working properly but if you discharges water from the outdoor unit does this only when working in hot and normal.

Mitsubishi Mr.... | Answered on Oct 08, 2011


There is a deodorizing filter which (usually) comes with the unit located behind the normal filters (spongy black material). This filter is washable, however usually this odor is associated with a dirty blower wheel and/or coil. Generally speaking you should have the unit cleaned properly every 1-3 years depending on your local average humidity. This entails pulling half of the indoor unit apart and is not recommended to the inexperienced. If you do choose to attempt this on your own then you will need a basic tool set to remove the blower wheel and a good solvent (Simple Green works well as a substitute for a NaOH solution) to clean the evaporator. Make absolute certain that the main power is off before attempting anything. Additionally there are thermistors located on the coil itself and the front cover who's location is critical to proper operation, so make good note of where each part came from to ensure it goes back properly. Take your time and have fun.

Mitsubishi Mr.... | Answered on Sep 22, 2011

Not finding what you are looking for?
Mitsubishi Mr. Slim MXZ30TN Air Conditioner Logo

656 questions posted

Ask a Question

Usually answered in minutes!

Top Mitsubishi Heating & Cooling Experts

NOEL
NOEL

Level 3 Expert

8537 Answers

vince

Level 3 Expert

1234 Answers

Stuart Slabber

Level 1 Expert

25 Answers

Are you a Mitsubishi Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Mitsubishi Heating & Cooling

  • Mitsubishi Heating & Cooling

Most Popular Question

mr slim remote not working

  • Heating & Cooling
Loading...