20 Most Recent
Questions & Answers
Flush valve doesn't stay up long enough
the reason for this that the toilet valve have loss out from it position for the water to be able to flow out completely
what you need to do from here is that you have to open the water carrier that is behide the toilet sitter the valve will need to be adjusted down a bite from the screw that help in holding the valve for the water to be able to flow out as usual
after this then your flush valve will allow all the water to run out to flush the toilet well
Good luck and thanks for using fixya.
on Jul 02, 2018
When I put the tank
This happens when the floor is not level. You need to keep the tank tight to the bowl. Silicone a shim under the lid on the low side to make the lid level. This will make the tank look level also
on Aug 30, 2011
I have a Kohler elongated
You need to adjust your float level in the tank.
Look on the arm of the float ball and there should be a screw that you can adjust the level of the tank water.
Turn the screw to raise the level of the water in the tank, to just about a 1/2 inch of the overflow pipe
If it will not adjust then you will have to replace the float valve (ballcock...is what it is called)
Please take time to rate me
on Jul 04, 2011
Not finding what you are looking for?