Top 20 Krell KAV-300i 2-Channel Amplifier Questions & Answers


You should be able to figur that out but first read the instructions they contain some amazing information. I can not help you because I have no idea of what you are asking.

Krell KAV-300i... | 78 views | 0 helpful votes


If you're able to switch between them then your issue is possibly relay, relay driver or microprocessor related; all of which require a service techs attention. hope this helps. Gene

Krell KAV-300i... | 98 views | 0 helpful votes


Onsemi ( which is motorola) is a good pic for replacements If youre looking at the 21195 , then there must be a compliment to that as well? 21194 or 21196

Krell KAV-300i... | 363 views | 0 helpful votes


Can you please provide more information about what you mean by "refresh"? Is there a performance problem or funcitonal problem with the unit?

Thanks,
Dan

Krell KAV-300i... | 423 views | 0 helpful votes


Sounds like the volume was way up when the iPod turned on. iPods are DC and cause a sudden thump through the speakers when they power on.
If the fuse is not blown, there may be another fuse you have not seen. Most amps have three to five fuses especially a 150watt/channel like the Krell.

Krell KAV-300i... | 197 views | 1 helpful votes


Check the Krell website

Krell KAV-300i... | 329 views | 1 helpful votes


try switching cables from one channel to the other and see if the problem follows the cables.

Krell KAV-300i... | 90 views | 0 helpful votes


That is an extremely odd problem. I suggest finding a tech in your area who is familiar with the unit, or contacting krell directly.

Krell KAV-300i... | 546 views | 0 helpful votes


first check your speaker cabels for short circuit and speaker for  short coil .after you confirm there is no shotr of cabel wires by checking with avometer in ohm postion.connect speaker if the problem excit your speaker is guilty - change it with same configuration.about switches put it in low order and chech for sound level and you can go up after that.

Krell KAV-300i... | 317 views | 0 helpful votes


try subbing out another newer speaker for the left one ? if sound returns then that older speaker is defective .

Krell Audio... | 171 views | 0 helpful votes


Fuses rarely go on their own. The cause is likely to be a shorted semiconductor device in the left channel output.
Fuses are generally not specific to any brand. Is the fuse a tube with metal ends? If it is measure the length in MM. Then look at the end and you should see the rating. Either in A for Amps or MA for milliamps.
Any electronic parts supplier should have the one you want in stock. Buy several, for if the part I mentioned has gone, it will blow again.

Krell Audio... | 313 views | 0 helpful votes


http://www.manualslib.com/manual/90296/Krell-Industries-Ksa-100s.html?page=18#manual Look on page 18

Krell Audio... | 250 views | 0 helpful votes


Thai will require removal of the top cover to move jumpers or program dip switches in proper order. This will be explained in the owners manual which is located at Krells web site.



Steven Leckrone
The Service Department
30 Unquowa Hill St
Bridgeport CT 06604
203-331-0671
Steven@theservicedepartmentct.com

www.theservicedepartmentct.com

Krell Audio... | 148 views | 0 helpful votes


Chances are that you have a "Leaking" capacitor in the final stage.

Time for the repair shop :(

Krell Audio... | 121 views | 0 helpful votes


Audio output section circuit draws enormous current at idle stage. Contact any service electrician to detect the fault and get it repaired. If you wish to get some details; check the site linked here. Viewing it in "Mosaic" will make surf easy. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/

Krell Audio... | 220 views | 1 helpful votes


it is possible the the processor could be locked up, do to a small power surge, and if you leave it unplug for 30MIN., it should reset back to normal.

Krell Audio... | 225 views | 0 helpful votes


this may not be a fuse. this may be the rectifier circuit in the power supply. A schematic will tell the voltages and surrounding components and their values. if you are not electronically capable of this repair then I suggest that you take the unit to a electronics tech to troubleshoot the unit properly with the right tools to determine the cause of no output.
Sears Repair is a good source for electronic repair.
I hope this helps. Have good day.

Krell Audio... | 42 views | 0 helpful votes


If it has a voltage selector for 220v, once configured it will work just fine Being electronic instead of mechanical the power frequency won't affect it. If it doesn't have a voltage selctor, don't plug it into 220.

Krell Audio... | 474 views | 0 helpful votes


Google (tevion)(ICR-737)(manual) without parens OR contact Tevion directly to request.

Audio Players &... | 57 views | 0 helpful votes

Not finding what you are looking for?
Audio Players & Recorders Logo

20 questions posted

Ask a Question

Usually answered in minutes!

Top Krell Audio Players & Recorders Experts

80stech

Level 2 Expert

120 Answers

 Grubhead
Grubhead

Level 3 Expert

5699 Answers

Gil Shultz

Level 3 Expert

3388 Answers

Are you a Krell Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Krell Audio Players & Recorders

  • Krell Audio Players & Recorders

Most Popular Question

not enough bass response increase bass

  • Audio Players & Recorders
Loading...