Question about Frigidaire FGF316 Gas Kitchen Range

Open Question

Frigidaire gas range burners not ignite model es200/300

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
catriver

Ron Marek

  • 878 Answers

SOURCE: FRIGIDAIRE GAS RANGE FGF378WCC

sl, because it't happening to both broil and bake the first thing I would suspect is the temperature probe. You should ohm it out. You can do this either at the board or at the harness connection in back. For the board, remove the back panel, there should be a 8 pin connector to the left of 3 relays. On the harness measure the resistance of the wires going to pins 1 and 2. On the shemantic it shows them being the 2 on the bottom. Should read around 1100 ohms at room temp. If you cant get a good reading on it there, Remove the probe from the inside oven, remove the screws and pull it out until the harness connector comes through, disconnect it and ohm it out from there. I don't think that both ignitors would fail at the same time so Im leaning toward the probe. Catriver.

Posted on Dec 11, 2007

Ad

Anonymous

  • 1 Answer

SOURCE: bybass auto shutoff (frigidaire gas range ES340)

Look on page 10 of the use and care manual under "To Set Control for Continuous Bake or 12 Hour Energy Saving" Page 10 in my manual.

Posted on Sep 09, 2008

Anonymous

  • 9 Answers

SOURCE: Frigidaire Gas Range Oven not getting hot - FGF376CEFP

DEAR CORDLESS TRY CHANGEING THE GLOW IGNITER THE GLOW IGNITER GOES BAD AFTER A FEW YEARS AND YOU HAVE TO CHANGE THEM YOUR BURNER SHOULD LIGHT IN 30 TO 60 SECONDS IF YOUR GLOW IGNITER IS NOT DRAWING ENOUGH AMPS YOU WILL SMELL GAS BUT NOT IGNIGHT THANKS GEORGE

Posted on Apr 11, 2009

TheMobilian

Dan Webster

  • 8220 Answers

SOURCE: Frigidaire FGF316WGSF GAS range oven won't work.

check this out

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Posted on Mar 22, 2010

tmcgarrigle

  • 2 Answers

SOURCE: Does my griddle pan on my Frigidaire 5 burner

I just got a new range and the instructions to season the griddle are in the instruction book. Wash an d dry the griddle. coat all surfaces ( top and bottom ) with a thin coat of cookin oil. place in oven at 350F for one hour. turn off afer an hour and let cool in the oven.

Posted on Jul 12, 2010

Testimonial: "Thanks! That's what I thought, too."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Frigidaire oven FGB24L2ASA. Igniter glows red, gas turns on, but does not light.


I appreciate your inquiry, K Ogle!

From what you have described about your Frigidaire range the igniter glows red and the gas turns on but it will not light. It sounds like it could be a faulty burner or igniter and I would recommend having a professional come out to properly assess your range. This does not sound like a simple DIY job. Good luck. -Matt

Feb 17, 2015 | Frigidaire Kitchen Ranges

1 Answer

Frigidaire professional series gas stove does not light. When handle is turned the "clicking" sound happens, with the smell of gas but no flame. what could be problem? 3 other burners work...


A few months ago I lost one igniter on the left front burner. It clicks and gas flows but wont ignite.Now when I turn on the left back burner, the gas still flows but I hear clicking on the right side, not from that burner. It wont light either.

Dec 17, 2010 | Frigidaire FEF336BC Electric Kitchen Range

1 Answer

Burner won't ignite. Spark is there gas we can smell, but it doesn't light the burner?This is a six month old Gallary Frigidaire range.


An electric range with gas? The heading must be the wrong model...

Assuming gas, this can be caused by either holes in the burner that jet gas out thru a channel to the sparker being plugged by spill overs or a mis-alignment of the tube like channels.

Feb 26, 2010 | Frigidaire PLEF398AC Electric Kitchen...

2 Answers

Top burners on Frigidaire gas stove come on but the oven will not.Whats the problem?


This sounds like a weak igniter, it would have to be a gas oven and the symptoms usually are: takes longer than normal to ignite the burner, may or may not smell gas in the oven, does not maintain set temperature or burner does not come on fully, eventually won't heat at all. On gas ovens, a glo igniter is like a light bulb, the more you cook, the faster it wears out. Bottom line, needs to be replaced. Good luck. 

Jan 30, 2010 | Frigidaire FGF326AS Gas Kitchen Range

1 Answer

Frigidaire oven wont ignite


This sounds like a weak igniter, it would have to be a gas oven and the symptoms usually are: takes longer than normal to ignite the burner, may or may not smell gas in the oven, does not maintain set temperature or burner does not come on fully, eventually won't heat at all. On gas ovens, a glo igniter is like a light bulb, the more you cook, the faster it wears out. Bottom line, needs to be replaced. Good luck. 

Jan 29, 2010 | Frigidaire FGF378AC Gas Kitchen Range

1 Answer

I have a Frigidaire FGF379 gas range. Ignition problem


I'm having the same problem and i'm wondering if you got a solution to yours.

Jan 22, 2010 | Frigidaire Kitchen Ranges

1 Answer

Frigidaire gas range model FGF316WGSH, all burners have gas but neither of the igniters will work when the knobs are turned to lite


Electric gas igniters sometimes get stuck in one position causing a clicking sound. The clicking sound that you hear is the electric arc that is pulsing from the igniter conductor (wire) to ground (the gas burner). It receives power from the electrical outlet that the stove is plugged into.
Residue from food and sometimes cleaning products may be preventing the igniter from producing a spark (Arc) to the base of the burner. This is a common problem that occurs when the stove has been cleaned or food is allowed to build up. Make sure that the igniter and the burner base are clean and dry. This will help with proper operation. Oven cleaner and a small tooth brush may be used to accomplish this. Another problem with ignition may occur if you have too little (touching) or too much space between the igniter and the base of the burner; it will prevent the burner from igniting. You should only have a little more space than the thickness of a nickel between the burner base and the igniter. A good "blue" arc from the igniter to the burner base is optimal. If this doesn’t work, you may need to replace the electric igniter module. Good luck.

Sep 08, 2009 | Frigidaire FGF316 Gas Kitchen Range

1 Answer

Gas range


I would call A&E Factory service like you recommend to everyone else. If you are too cheap to spend $75 on a service you are pathetic. Sound familiar?

Aug 25, 2008 | Kitchen Ranges

1 Answer

Frigidaire Gas Range Oven not getting hot - FGF376CEFP


DEAR CORDLESS TRY CHANGEING THE GLOW IGNITER THE GLOW IGNITER GOES BAD AFTER A FEW YEARS AND YOU HAVE TO CHANGE THEM YOUR BURNER SHOULD LIGHT IN 30 TO 60 SECONDS IF YOUR GLOW IGNITER IS NOT DRAWING ENOUGH AMPS YOU WILL SMELL GAS BUT NOT IGNIGHT THANKS GEORGE

Oct 29, 2007 | Frigidaire FGF376 Gas Kitchen Range

Not finding what you are looking for?
Frigidaire FGF316 Gas Kitchen Range Logo

Related Topics:

106 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Kitchen Ranges Experts

Ismael Rodriguez...

Level 2 Expert

184 Answers

Paul Carew

Level 3 Expert

3484 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

Are you a Frigidaire Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...