Question about Maytag Neptune FAV6800AW Top Load Washer

1 Answer

My control panel lights keep beeping and changing in the spin cycles and continues to beep and go through them before after and during. I shut it off and it comes back on by itelf? Any help?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 526 Answers

Could be a Control Board issue, a Console issue or something pulling down the +12VDC supply on the Control Board.

How deep into DIY do you want to get? There is no reset button to fix this issue. Hav you had any electrical storm activity recently?

Posted on Aug 30, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GE Quiet Power 3 won't start when door is closed.


What is the exact model number? This may be an issue with the cables that connect the door to the power supply.

Apr 06, 2018 | GE Dishwashers

1 Answer

Door ajar alarm keep beeping every 5 minutes and door is shut


was the replaced control panel a used unit
are the door hinges and seals ok
still maybe a faulty door sensor

Jun 17, 2016 | Refrigerators

1 Answer

Ltf2140e


Hello Mike - Typically, if the water temperature combination is not appropriate for the cycle selected, the status lights will blink and signal will beep 3 times. Try resetting the unit by either unplugging it or flipping the household circuit breaker to the off position. Wait roughly ten minutes and turn on the washer. Select a normal cycle and verify if the washer continues to beep. If resetting the power does not correct the issue, your appliance could be experiencing a communication error with the control board or could have a wiring failure. I would suggest contacting an experienced service technician to determine the precise cause.

Apr 28, 2013 | Frigidaire ATF6000ES Front Load Washer

1 Answer

My currys essential washing machine beeps during cycle and stops help


Remove the power for sometime , check if the spindle is FREE and moves. , Remove the back and under side to inspect for any damage to the motor or drive. check the power lines, check on the motor CAPACITOR. Now when powering check the VOLTAGE to the motor. if this is low or absent then the program controller unit is faulty.

Dec 31, 2012 | Washing Machines

1 Answer

Top drawer on F&P dish drawer stuck on cycle & continuously beeping


You could isolate the top drawer by taking the controller power cable out. DIsconnect mains power to dishwasher, open top drawer and remove front cover carefull after removing 2 plastic pins on each side with plier. Controller box is on left top side, remove bottom connector and cover with insulation tape. Put things back and turn power back on.

But if you want to find the fault with top drawer then that is very trick if there is no fault code on panel except beeping First clean the top panel inside door with a clean damp cloth. If this does not change the situation, then it is very likely the controller is detecting some faulty sensor - and will need to find one by one. Are you ready for it?

Dec 17, 2012 | Fisher and Paykel 23 in. DD-603SS Built-in...

1 Answer

Cycle Signal Volume beeps from loud to soft


This is a common and very well known problem with the Oasis. You will need to replace the operator interface board inside the control panel to resolve this issue. The board is located directly behind the control knob. If you post back with your model number, I can research a part number for you, give you info on where you can order a replacement, and give you guidance on how to replace the board yourself.

Feb 12, 2009 | Kenmore Oasis HE 27082 Top Load Washer

1 Answer

I can't change the default wash cycle without it switching


1 Beep/E10--Error: Water doesn't enter Cause: Water supply problem, Check kinks and faucets
1 Beep/E10--Error: Water leaks Cause: Water connections loose,household drain clog,oversudsing. Correct problems.
1 Beep/E10--Error: Dispenser drawer is open Cause: Washer will not operate if drawer is open.
2 Beeps/E20--Error: Water dosen't drain. Cause: Drain is kinked or household clog. Correct.
3 Beeps/E30--Error: Drum overfilled. Cause: Inlet valve,pressure switch or control board failure.Select drain/spin to remove water. Restart.
4 Beeps/E40--Error: Door is open. Cause: Washer will not operate if door is open. Close door.
5 Beeps/E50--Error: Motor is overheated. Cause: Wait 30 minutes to cool down. Restart.
7 Beeps/E70--Error: Cold water doesn't enter. Cause: Hoses crossed,faucet problem.
15 Beeps/EF0--Error: Oversudsing. Cause: Too much detergent,or improper detergent for machine.
15 Beeps/EF0--Error: Hot water doesn't enter. Cause: Hoses crossed,faucet problem.


Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE question

Jan 28, 2009 | Kenmore Oasis HE 27082 Top Load Washer

1 Answer

3 quick beeps during cycle if you can get it to stay in a cycle


MY KENMORE OASIS HE IS DRIVING ME CRAZY! THE CYCLE SIGNAL CONTINUES TO BEEP AT LEAST 25 TIMES, STOPS FOR MAYBE 20 SECONDS, THEN BEEPS AGAIN ABOUT 25 TIMES. THE WASHER WORKS GREAT, BUT IT WILL NOT STOP BEEPING! HELP!!!!!

Sep 13, 2008 | Kenmore Oasis HE 27062 Top Load Washer

3 Answers

Maytag Neptune Dryer MDE5500AYW beeping and resetting itself


Ok , I replaced the control board. Still beeps continuously. Just sitting there, nothing else is on, just plugged in......beeep,beeeep,beeeeep,WTF man? I am about to turn this damn thing into an anchor and invest in more clothes lines! Maytag sucks. MAYTAG an acronym for...
Maybe
All
Your
Technicians
Agree;
Garbage...

May 16, 2008 | Maytag Neptune MDE5500AY Electric Dryer

Not finding what you are looking for?
Maytag Neptune FAV6800AW Top Load Washer Logo

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

jimorris77

Level 3 Expert

411 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Bill Long

Level 3 Expert

606 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...