Question about Jensen JER-422 Universal Remote Control

1 Answer

Residential reroof, 3 layers comp. is ice & water required over eaves & rakes ???

Posted by on

  • Wesley Colberth
    Wesley Colberth Feb 27, 2016

    Great question about re roofing with ice and water shield over the eaves and rakes. I too have had similar questions about when its necessary to use ice and water shield. I imagine that working with a licensed roofer would be helpful. http://www.us-roofing.com

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 1 Answer

Probably not required unless an older home or low slope roof, but very easy and not expensive to do when re-roofing. When attics were poorly insulated snow would melt above the attic from heat lost from the house, then refreeze at the eave causing an ice dam. More melting water hits the ice dam then back up under roof shingles and felt paper.

It is not required, but your specific conditions could warranty it. If your roofer is recommending it I would do it.

Posted on Sep 22, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

3 beep alarm, machine is clean, has new float ***. but still locks out after dumping ice


Did you clean the float switch water tube going into the water trough when the switch was replaced?
Does it make 1 drop of ice,then shut off immediately?
What is the age of the machine?

3 beeps every 3 sec. = Freeze Back Up Timer. Freeze > Specified Setting
Yellow LED marked "F Timer" energizes. Check for F/S stuck
closed (up), WV leaking by, HGV leaking by, PM not pumping, TXV
not feeding properly, low charge, or inefficient comp. Dip switches 9
& 10 allow for factory adjustment of this back up timer feature.

Aug 10, 2011 | Hoshizaki KM-1300S Stackable Crescent...

1 Answer

There is layer of ice that has formed at the bottom of the freezer side. Due to this there is a leak of water that appears every two or three days. I cleaned the layer of ice once and after 2 or 3 weeks...


Sounds like the drainage hole is blocked with ice, i normally take the back cover off the freezer and at the bottom you will see a build up of ice at the bottom, turn freezer off and carefully remove as much ice as you can, then pour some boiling water over the excess ice and in the middle you will see a drain hole make sure water then freely flows down drain hole. Other than that you could try switching your freezer off for 24 hours to clear ice.

Nov 02, 2010 | Maytag MSB2654HE Side by Side Refrigerator

1 Answer

My water works on my refrigerator but my ice maker doesn't work.


Pour about 2/3 cup of water into the ice maker . If it freezes and dumps , replace the water valve ( the piece the wall water line connects to on the refrig ) . If it freezes and does not dump , replace the ice maker . Also check the rake ( rotating arm ) , to see if a small piece of ice could be blocking it , keeping it from turning . If so , the small cube could be an indication of not enough water going into the ice maker ( replace the water valve ) .

Apr 18, 2010 | Maytag MZD2669KE Side by Side Refrigerator

5 Answers

KitchenAid ice dispenser tray is dry - not working


Put some water in the ice mold is what I would try. wait and see if the ice maker harvest a batch. If it does drop a batch but no more then the water valve is probably shot. The ice maker itself controls the water. It does this by filling the ice mold for 7.5 seconds. Here is your Ice maker repair manual and some repair photos along with a pictorial which snows how to check the water valve.
Ice maker quit making ice

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

Apr 05, 2010 | KitchenAid KSRS25IL Side by Side...

2 Answers

WATER LEAK INSIDE


It likely has a hiding drain tube built inside the rear wall itself.
There are many many different models also.

Try to see if you can see the drain hose near the Compressor, and blow into it to see if it clears.

A lot of fridges require a serviceman to remove inner panels, ect to clear the problem.

Also,it might be ice built up at the top freezer section,preventing any further draining during regular defrost cycles.

Mar 04, 2010 | Refrigerators

1 Answer

Replaced ice maker in kenmore elite last year. stopped working again.replaced ice control sensor boards,still nothing.replaced module,poured some water in tray,freezes,rake starts down,hits ice then does...


the rakes can only move the ice if the tray has been heated .. there is a heater mounted on the tray that may be bad or not getting power . here is the sequence that should happen

the water solonoid operates to fill the tray (you should hear it click when this happens) .. then the tray is left alone until the cubes have frozen .. then the heater comes on to free the cubes from their mold then the rake operates to scoop out the ice .. the rake cant move the cubes unless they have first been freed by the heater .. it sounds like you have power (rakes moved) but its not clear if the water fill function is working .. even if it wasnt, if you filled the trays then it should still work but you would have to wait for the complete sequence .. you can feel the heater get hot at the right time if its working (just before the rakes move) .. its a bent tube structure mounted on the ice forming pickets .. be careful it can get pretty hot .. i cant tell but if several things are not working like it doesnt fill with water and the heater doesnt come on ever then that sounds like a connector not fully connected or damaged .. or perhaps a bad (new) module (broken solder connection or otherwise damaged) .. .. you can check the heater with an ohmmeter . it should read low resistance between hot terminals .. and open from ground to either terminal ..(power off and disconnected of course) .. make sure the heater is indeed plugged in ..

Oct 16, 2009 | Refrigerators

1 Answer

Ice machine does not make ice


No guide that I know of .

Open the freezer door and see if the laser light on the right side , flashes twice , then pause , repeatedly . Close the flap on the left side , and the laser should stop flashing . If this is what occures , then the optics ( cut off of the icemaker ) are ok . If you open the freezer and no laser on the right , check the position of the "rake" inside the icemaker . Close the freezer door for about 1 min , and then recheck the position of the rake . If it hasn't moved , then the icemaker is bad .
If the light flashes 2 times then pauses , pour about 2/3 cup of water into the icemaker , and check later , to see if the ice maker has dumped the cubes . If did not dump , replace the icemaker . If did dump , and did not fill with water , then the water valve behind the refrig is bad . Also check the black fill tube above the ice maker fill cup , to see if it is iced up , keeping the water from going into the fill cup . If it is frozen , then replace the water valve , due to seeping ( not closing completely ) , causing the slight drip , to freeze inside the tube .
This is the only guide I know of and it's called an experience guide .

Sep 27, 2009 | KitchenAid KSRG25FK Side by Side...

1 Answer

Rake will not push ice to drop.


Thanks, but no thanks. I am not interested in paying for a plan to help me solve this problem. I will seek assistance elsewhere.

Aug 28, 2009 | KitchenAid Superba Architect KSCS25INSS...

1 Answer

Ice maker flooded top freezer compartment


It may be just the water control valve on back of refrigerator. Put tap water in ice maker and lower lever for on. After ice is made, does it drop to tray? At this time when empty is the time the control valve is asked for water. The problem could be in valve on back or the inside ice maker itself. If you can try a few test with me I will help you locate the problem. Let me know what you find as I go through this with you. Sea Breeze
http://servicepartstec.blogspot.com/


516cd75.jpg

May 19, 2009 | Whirlpool 21.0 cu. ft. Top Freezer...

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

238 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jensen Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76204 Answers

Christopher Stearns

Level 2 Expert

101 Answers

Cindy Wells

Level 3 Expert

6063 Answers

Are you a Jensen Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...