Question about Maytag Neptune FAV6800AW Top Load Washer

1 Answer

I Have A Neptune Washer Model FAV6800AWW Have error code of LR Lock rotor? what is bad? control board ot motor or both?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 526 Answers

Motor for the most part is bullet proof has a 10 yr warranty

I would start with front panel removal and see if you can rotate the Clutch Pulley CW the Wash/agitate direction and CCW the Spin direction. Make sure nothing is seized.

It could be an issue with the Control Board or the Motor Controller. I have working spares for all and that makes troubleshooting easier.

If you decide to troubleshoot further and try a Control Board swap (in the console) or a Motor Controller swap I would buy parts from a supplier that will allow you to return the part for refund with no questions asked.
Google this ""Neptune TL Washer FAV6800AWW"" a forum where I help owners of the FAV6800A and FAV9800A machines.


This is a sticky on a DIY forum at the 5th post down you can link to the FAV6800A/FAV9800A Service Manual. You can post in that forum in the Maytag washer forum for additional help. You will find a link to parts supplier.
I link you to a post on this forum where I was working with an owner who was troubleshooting issues and started throwing a LR error code. He ended up replacing both the Motor Control Board, my 1st suggestion and that did not resolve the issue. A Control Board swap in the Console resolved the issue. Maytag Neptune Top Load FAV6800AWW -- tub/motor will not spin ... I won't troubleshoot any further on this forum it's just difficult for me. Can't edit, search post and sometimes pics don't attach. There are better DIY forums out there for working on the FAV6800A/FAV9800A......just mu opinion.

Your machine more than likely is ready for an Tub Seal replacement.....Google this FAV6800A/FAV9800A Outer Tub bearing replacement Another forum I help owners with FAV6800A/FAV9800A machine issues........good luck.

Posted on Sep 07, 2011

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Yes I just want to know I it's worth fixing this prob. I have a maytag Neptune tl washer model fav6800aww it's starts fine but after 3 minutes it stops on wash cycle an after 5 minutes Lr shows on...


Lr error code is locked rotor. Could be a couple different issues.

Google this phrase and read thru the post ""[FIXED] Maytag Neptune Top Load FAV6800AWW -- tub/motor will not spin""

Post in that forum if you want to DIY I do not offer DIY help here any more.

Jul 12, 2011 | Maytag Neptune FAV6800AW Top Load Washer

1 Answer

Maytag neptune tl what is code Lr


LR is the error code for Locked Rotor.

This could be an issue with the Motor Controller or Control Board.

I have not seen Drive Motor cause this issue to date.

If you want to investigate further I would suggest getting the FAV6800A/FAV9800A Service Manual.

Google this ""Neptune TL Washer FAV6800AWW""

This is a sticky for the FAV6800A/FAV9800A washer DIY support. Go to the 5th post down in the Sticky and you will find a link for the Service Manual.

If you want to go further in troubleshooting and possibly a DIY fix just open a new thread in that DIY forum with Model number and Serial number. That info is found tag behind the console right back side as you face the machine console.

Feb 24, 2011 | Maytag Neptune FAV6800AW Top Load Washer

1 Answer

We have a maytag neptune washer and it is suddenly not working and displaying a code of LU it kinda looks like>?


perhaps and lr??? LR--- means locked rotor assy. you will need to replace your motor control board and motor assy, comes as a kit not a bad repair (NEPTUNE REPAIR KIT) if thats indeed the issue you seeing that is

Oct 09, 2010 | Maytag Neptune Washer

1 Answer

I have an Maytag neptune with an error code of Lr. It fills but doesn't seem to turn when washing.


Hi

Thanks for using FixYa. Lr means locked rotor, this issue occurs due to locked rotors, you'll need to check the rotor wiring and windings. If the wiring is good and windings are not burnt then you'll need to replace your motor and motor control board. These are sold as one unit, it is a 3 phase motor and one of the phases is bad. A little power surge can damage the boards. Please rate the solution if the issue is resolved else post a comment for further assistance.

Thanks
Rylee

Oct 06, 2010 | Maytag Neptune MAH5500B Front Load Washer

1 Answer

Getting error code LR


Hi

Thanks for using FixYa. Lr means locked rotor, this issue occurs due to locked rotors, you'll need to check the rotor wiring and windings. If the wiring is good and windings are not burnt then you'll need to replace your motor and motor control board. These are sold as one unit, it is a 3 phase motor and one of the phases is bad. A little power surge can damage the boards. Please rate the solution if the issue is resolved else post a comment for further assistance.

Thanks
Rylee

Oct 06, 2010 | Maytag Neptune FAV6800AW Top Load Washer

1 Answer

Displays lr code


Hi


Thanks for using FixYa. Error Lr means locked rotor, this issue occurs due to locked rotors, you'll need to check the rotor wiring and windings. If the wiring is good and windings are not burnt then you'll need to replace your motor and motor control board. These are sold as one unit, it is a 3 phase motor and one of the phases is bad. A little power surge can damage the boards. Please do rate the solution if the issue is resolved else post a comment for further assistance.


Thanks
Rylee

Sep 06, 2010 | Maytag Neptune FAV6800AW Top Load Washer

1 Answer

Gives an error code lr


The “Lr” = Locked Rotor: The machine has repeatedly tried to turn the motor.

I have seen this issue caused by a failed motor. I have seen a bad Control Board cause this issue and a bad Motor Controller cause this issue.

If the Lr error code happened in the Spin Cycle of the wash cycle it could be caused by seized Outer Tub bearings.

Without a known good Control Board and Motor Control board this could be difficult to troubleshoot.

Here is a link for the FAV6800A/FAV9800A Service Manual

May 31, 2010 | Maytag Neptune FAV6800AW Top Load Washer

1 Answer

Maytag washer top load neptune


See this post for troubleshooting the Lr error code. . http://www.fixya.com/support/t2419091-maytag_neptune_top_load_fav6800aww_tub

Lr is locked rotor. My first thought was that this could be a Motor Controller issue. This owner replaced tried that and it did not resolve the issue. He then replaced the main Control Board and that fixed his machine. Without known good parts (Control Board Motor Controller) this might be difficult for a DIY fix.

The Service Manual for reference. Sears Parts Direct for reference.

If you are going to try to DIY the repair I will see if I can help……Rich

Apr 28, 2010 | Maytag Neptune FAV6800AW Top Load Washer

1 Answer

What does error code Lr mean and how do I fix it?


http://www.bobvila.com/wwwboard/messages/155863.html

says:

just an FYI to anyone who might need to know. my neptune started kicking up an error of LR and stopping. i ended up sending an email to maytag and got a response back from one of their techs. the LR code means "Locked Rotor". when this happens the cause is one of two items. 1) the circuit board at the top of the unit has lost connection to the motor and its control board at the bottom (connector loose) or 2) the motor and or control board at the bottom have trashed and need to be replaced (P/N 12002039).

hope the info helps someone as i had a heck of a time finding it.

Dec 21, 2008 | Maytag Neptune Washer

1 Answer

Maytag neptune washer


LR == locked rotor, which translates to a bad motor and motor control board( usually depending on age sold a 1 set. Neptune repair kit. retails for about $200 part number 12002039

Oct 26, 2008 | Maytag Neptune MAH5500B Front Load Washer

Not finding what you are looking for?
Maytag Neptune FAV6800AW Top Load Washer Logo

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Washing Machines Experts

jimorris77

Level 3 Expert

411 Answers

Sheldon Dedek

Level 3 Expert

909 Answers

Bill Long

Level 3 Expert

606 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...