Question about Asko D1996SS Built-in Dishwasher

1 Answer

Lights on the Asko D1996 keep blinking

The lights on the dishwash keep blinking, if I close the door on the washer while the dish washer is blinking water drains into the sink. If I hold down the start button the lights seem to reset but when I close the door nothing happens.

Posted by on

  • Anonymous Nov 30, 2008

    Lights blinking, dishwasher does not turn on

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 2 Answers

This depends on the blinking pattern. Of the eight lights on the panel, if the four on the left blink on and then the right four lights blink on as the left ones go off, and keep blinking back and forth, that just means the mode has been set and the Start button pressed. After closing the door it should just continue on wherever it is in the cycle. (This is normal operation).
If you hold down the Start button, this resets the dishwasher. If you then close the door, nothing will happen because it thinks it's done.
If the lights are blinking in a different pattern, such as they all blink on and off in unison, that indicates an error condition and needs to be diagnosed. If the pump is not running constantly, then at least it's not because water is leaking out somewhere.

Posted on Sep 18, 2009

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

GE Quiet Power 3 won't start when door is closed.


What is the exact model number? This may be an issue with the cables that connect the door to the power supply.

Apr 06, 2018 | GE Dishwashers

1 Answer

Rinse aid dispenser not working


You have to take apart the whole door panel to see what the problem is,.

Jun 07, 2013 | Asko Dishwashers

1 Answer

The normal wash and heated dry lights keep blinking on my GE Quiet Power2 dishwasher. Every few minutes it will beep. I am unable to wash dishes.


Check the door switch, is the door completely shut? Door switches will ware out, they are used everytime you open, and close the dishwasher

Dec 13, 2012 | Dishwashers

1 Answer

Asko 1996 appears "dead".....no lights flashing, won't respond to repeatedly pushing on/off button. Some water left in the bottom...siphoned it out, cleaned filters, no blockage there. Almost like it's...


Don't know if this will help, but my dishwasher has a "propeller" device above the top and bottom racks that spins while dispensing the water. If the dishes on either rack are stacked too high (i.e. if even one plate comes in contact with that propeller, keeping it from spinning properly) the dishwasher will go through its full cycle but will not use the soap (soap door will still be closed and soap packet still intact) and will not get the dishes clean.
However, it sounds like you either have a bit of a drain issue as well--or perhaps your dishwasher acts the same way as mine (if that's the case) but ceases to drain as well if blocked.

Jun 26, 2010 | Asko D1996SS Built-in Dishwasher

1 Answer

Asko D1996 dishwater does not turnon.


Check inside the machine for fuse or circuit breaker. Replace or reset. If repeats, you have to contact the service center.

Apr 14, 2010 | Asko D1996SS Built-in Dishwasher

1 Answer

Asko D1996 lights flashing washer won't start


I'm having the same issues. What did you do to solve yours? My start button never lights up! Thanks for your help!

Oct 01, 2009 | Asko D1776 Stainless Steel Built-in...

1 Answer

Power on Press Start.Lights flash. Close door . Fails to Start


Possible causes
1. Main switch is OFF.
2. Door not properly closed.
3. Fuse has blown.
4. Power supply plug not plugged in.
5. Water tap not opened.

Please check these and let me know if any have worked.

And please remember to rate me.

Feb 02, 2009 | Asko D1996SS Built-in Dishwasher

1 Answer

Asko D1996 Stainless Steel Detergent Door Does Not Open


the pcb will need replacing,the dispenser gets its power from there.

Feb 28, 2008 | Asko D1776 Stainless Steel Built-in...

Not finding what you are looking for?
Asko D1996SS Built-in Dishwasher Logo

1,026 people viewed this question

Ask a Question

Usually answered in minutes!

Top Asko Dishwashers Experts

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

MARLON KELLER

Level 2 Expert

111 Answers

Are you an Asko Dishwasher Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...