Question about Health & Beauty

1 Answer

Need a wiring diagram for a Scoot-N-Go Elecric scooter?

Electric 24 volt Scooter

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

After getting a new set of batteries, now when I turn on the key the scooter's motor engages and takes off. I have the wiring diagram and everything looks right, what could be the problem?

Posted on May 17, 2013

  • jacdaddy
    jacdaddy Jan 11, 2014

    there are two connectors the same size one comes from the motor you have it hooked straigh to batts it needs to go through controler blue & yllow to the motor red & blk to batts

×

Ad

5 Suggested Answers

gewiz

Rob Hill

  • 1414 Answers

SOURCE: Need service manual or electrical wiring diagram.

one ofthe best ways to work it out is the find the motor controller, normally it's a black box located under the seat,

Now remember you have two wires from the batteries B+, B-, two wires to the motor, M+, M- and some smaller wires on maybe a ten connector block that leads to the tiller where the throttle on the handlebars is located.

Hope that helps

Regards
GeWiz.

Posted on Oct 02, 2009

Ad

Anonymous

  • 1 Answer

SOURCE: Need a wiring diagram for Pride Rally Electric Scooter

I can tell you how i fixed it for $19.95

Posted on Jun 22, 2009

gewiz

Rob Hill

  • 1414 Answers

SOURCE: electric mobility Rascal 265 LE scooter won't run

Are you sure the batteries are charged ? Is the Battery charger charging ok ? Are the batteries connected ? take off seat and cover to check battery leads, does the key fit in the lock okay ?

Posted on Jun 13, 2009

Neil Wood

  • 177 Answers

SOURCE: electric mobility scooter says charge is full but won't run

Hi. Most chargers should be connected to the scooter first before plugging into the wall socket. The charger senses the battery voltage to regulate itself. Your other answer suggested the circuit breaker, and this might be correct. Sone times the circuit breaker blowing can mean there is other faults such as a faulty motor. Many mobility scooters have plugs and sockets on the battery leads, and most are too light to carry the high currents. I have removed these from many machines and connected the leads straight to the batteries.

The third pin in the charger plug is to disable the controller in the scooter while the charger is connected.Good luck. Neil.

Posted on May 27, 2010

Neil Wood

  • 177 Answers

SOURCE: wiring diagram for sc234ala mobility scooter

Hi. Do you need a basic wiring diagramme for the lights, motors etc. or do you need one for the controller? What faults do you have?
Fisher and Paykel sold their mobility scooter business to Plega Healthcare in Australia. Plega now no longer suport the mobility scooters.
We have some parts left in stock, and were an authorised service agent for these machines.
No one was ever supplied with a circuit diagramme for the controllers.
We do have all the service manuals here and have a full set of the fault codes.
You can email us at scooterworks@xnet.co.nz
Good luck. Neil.

Posted on Jul 24, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I wire two tandem batteries for an electric scooter


Tandem batteries... is a fairly loose term to be dealing with on batteries... SIMPLY BECAUSE THEY ARE EXPLOSIVE.


TANDEM voltage
(assuming you were trying to achieve 24 volts with 2
12 volt batteries would NORMALLY be called serial...

Where as to increase AMPACITY ... called "parallel."


Rather than risk severe burn, blindness (end of life
experimenting with EXPLOSIVES...
You need to go back to your source for better information ...
or
Provide better information here... Pretty please

Jan 12, 2017 | Electric Health & Beauty

1 Answer

Scooter wiring diagram


Bad connections on the battery posts is most likely. If the circuit breaker was bad you'd get nothing at the battery . The charger voltage is 29 volts when not connected to the batteries. 26 or more when connected and on.

Jun 30, 2013 | Pride Mobility Revo 3 Wheel Electric...

1 Answer

Bella scooter light says charged but nothing happens when turn throttle


check the batteries with a multimeteer and make sure they are putting out at least 24 volts

May 13, 2012 | Razor E200/300 Electric Scooter Battery

1 Answer

The electric brake that is on the end of the 24 volt motor doesn't release


krazy the brake will have to be replaced contact the provider where you got the scooter to ask if they can repair it. If not you can contact Repair Xpress @ 1-877-581-3733 to see if they have a tech in your area Hope this helps

Apr 20, 2011 | Electric Mobility Handicap Scooter

1 Answer

I have 18volts at the box that the battery leads go to and the consol leads go out of. the warning beeper goes off even when standing still and in neutral. i have tryed bridging the leads from battery to...


18 volts is not enough voltage to run this scooter. You have 2 batteries that should each read a max voltage of 13.5 volts each or 26 to 27 volts when fully charged and measured in series. 2 batteries that are 50% charged will read 24 volts. Your batteries are almost dead by this measuring method. Charge them up or replace them and your scooter should run. Hope this helps.

Feb 18, 2011 | Electric Mobility 4 Wheel Power Electric...

1 Answer

I want to add 2 more 12v 20ah batteries to my 48w electric scooter and im not sure how to wire it and charge it.Please help


join them in parallel if there all 12 volt you could just charge the 1 battery with 12 volts and that would charge them all but all the other batterys have to be in series you cant do it if u have 2 24 volt batterys they all have to be 12 v

Dec 18, 2010 | Electric Bicycle Motor, Bike,electric...

2 Answers

Electric mobility Rascal 265 LE scooter won't run 24 volts dc on batteries no sound or movement


Are you sure the batteries are charged ? Is the Battery charger charging ok ? Are the batteries connected ? take off seat and cover to check battery leads, does the key fit in the lock okay ?

May 02, 2009 | Electric Mobility Mobility Electric Power...

1 Answer

Does the S600 and a Missle FS schwinn scooters use same charger?


Hi you can use the charger if the Specifications match up. Output volts, Amps, Charger size, The most important is it 24 volt or 36 volt charger. Check your scooter to see what volt it runs at. Must be equal to your scooter!

Mar 03, 2009 | TitanNet PowerStar Replacement Battery for...

Not finding what you are looking for?
Health & Beauty Logo

Related Topics:

1,769 people viewed this question

Ask a Question

Usually answered in minutes!

Top Health & Beauty Experts

Rob Hill
Rob Hill

Level 3 Expert

1414 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Jeff Bird

Level 3 Expert

1345 Answers

Are you a Health and Beauty Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...