Question about Heating & Cooling

1 Answer

Hitachi split ac ace cutout how to go to standby mode

The Ace Cut out split ac manual says that after 120 hours of operation the filter choked red light on the indoor unit will glow. Then we have to take out the filter and clean it and put it back. To make the red light go off we have to use the remote to make the AC go to standby mode and then press a particular button. I do not know how to make the AC to go to standby mode. Pl. tell me how to do it. The local AC mechanic hired by the Hitachi company also does not know how to do it.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Its very simple to remove that red light glowing on the AC, just switch-off your AC with your remote, but don't turn off the switch that resides with in the plug, remove filters wash gently and dry under shade and place them again in the AC, now keep it without turning-off the switch for 30-60minutes this is called stand by mode. Now take the remote open the panel and press the button that is situated in 4th row and 3rd column. By doing this the red light will be turned off and enjoy your AC.

Posted on Jun 02, 2012

  • virinchiyadav Jun 02, 2012

    Its very simple to remove that red light glowing on the AC, just switch-off your AC with your remote, but don't turn off the switch that resides with in the plug, remove filters wash gently and dry under shade and place them again in the AC, now keep it without turning-off the switch for 30-60minutes this is called stand by mode. Now take the remote open the panel and press the button that is situated in 4th row and 3rd column. By doing this the red light will be turned off and enjoy your AC.

×

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: ac split unit indoor an ouydoor unit electrical wiring diagram

machine off

Posted on Apr 25, 2009

jmgldsmth

Jim Goldsmith

  • 2005 Answers

SOURCE: ice formation in the indoor unit

you need to have the unit checked for the amount of freon in the system this must be done with a gauge set the freon amount is obviously incorrect
also the a-frame evaporator must be sealed in the furnace cabinet

Posted on May 28, 2009

kel1guy2002

Kelly

  • 3740 Answers

SOURCE: where is reset button located

Look at your remote carefully. There is a bal pen type push to reset filter button on the remote. Depress the rest button and it should reset. Also on the contol panel you can also reset it by depressing the mode and the UP temp arrow buttons for 5 seconds.


Thanks for choosing FixYa.

Kelly

Posted on Sep 05, 2010

kel1guy2002

Kelly

  • 3740 Answers

SOURCE: where is reset button located

Look real hard on the remote. There is a mini "use a ballpoint pen" push to reset filter button on the remote.

Electronic control panel: (not all models)
Hold the mode button and the Temp Up arrow depressed for about 5 seconds. It should display the temp and the FL should disappear.

Thanks for choosing FixYa.

Kelly

Posted on Sep 05, 2010

seth veloso

  • 334 Answers

SOURCE: Need user manual for hitachi logicool window ac

check out this link for the timer:
http://www.logicool-ac.com/pdf/015%20-%207%20Day%20Timer%20Operation.pdf

check out this link for the manual
http://www.logicool-ac.com/tech_downloads.html

Posted on Jun 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My hitachi inveter split ac green light 9 times blinking and ac not working


Get the model number of your mini split unit (on tag on indoor unit and outdoor unit) Google hitachi error codes. You should be able to pull up a code list for that unit. I believe it may be a communication problem between the indoor and outdoor unit. Possible bad connection of wire going from outdoor to indoor unit

Sep 14, 2018 | Hitachi Heating & Cooling

2 Answers

I have a Hitachi 1.5 ton Split AC and in that Red light always glows (the one indicating filter grid) How can I turn it off?


I've never owned one of those kind of air conditioners, but most air conditioners have a filter where air from the room enters the unit. They need cleaning or replacement and that sounds like what the indicator is suggesting. Might check manual or download one off internet.

Jun 09, 2016 | Hitachi Heating & Cooling

1 Answer

WHAT IS REFRIGERANT SUCTION PRESSURE OF MY 1 TON SPLIT AC?


R22= 70-80psig
R410a=120-130psig
Depending on many variables such as blower speed, coils clean, indoor/outdoor temps.

Aug 05, 2015 | AMVENT 18000 Btu 1.5 Ton Ductless Mini...

1 Answer

36VDC Split Air Conditioner indoor unit in a 240VAC country


Will not work. If you plug in a 120 volt appliance into a mains that is ordinarily 240 volts, you will destroy/burn up the unit. If you use a step down transformer - 240 to 120 you can then use the appliances - just make sure that it is a large transformer that can handle the large current (s) involved.

Apr 02, 2014 | LG Heating & Cooling

1 Answer

Daikin split system air con dead


Split system Air conditioners are very often on two or more separate breakers, with a control voltage (24vac commonly) connecting their operation. the condensor unit and out-door fan generally on a 220 vc 'paired' breaker, possibly a quick disconnect near the unit with fuses inside, or an independant breaker pair, and the evaporator unit with INDOOR fan on a 110 or 220 vac breaker.

switch the fan to 'ON' at the thermostat... this is the midpoint of the system electrically. If the fan comes on check for voltage at the condensor unit. a check to see if the thermostat is the problem... remove the thermostat and connect the red, green and either the white or yellow wires (not both) if you chose white you should have heat...yellow AC...

most split system AC have a small buss fuse on the control circuit board of the indoor unit. looks like a glass tube with metal caps held by metal clips. In 40+ yrs experience I have found it is more likely one or both of the 30 amp buss fuses near the outdoor unit (replace both even if one is still ok) or a 30 amp breaker in the quick disconnect box.
In many systems the control voltage to the thermostat derives from a transformer in the outdoor unit... it could be as simple as a broken wire. Without a full diagnostic, a complete description of the unit ( AC or heat pump, etc) this is all speculation

Nov 19, 2013 | Heating & Cooling

2 Answers

AC power light blinks but not starts


The outside unit has a problem. Have it tested.

May 05, 2017 | Hitachi Heating & Cooling

5 Answers

LED LIGHT BLINKING OF HITACHI SPLIT AIR CONDITIONER


Did you figure out why the ac wasn't responding to the remote? I am having the same problem. I just cleaned out the filters but it's still not responding to the remote. I have already tried reset button in the remote, which didn't help. I am pretty sure that the remote is not out of battery.

Jun 18, 2012 | Hitachi Heating & Cooling

3 Answers

Hitachi ACE follow me red filter light is always on


the red light turns on automatically after 120 hrs of running to remind us for cleaning the filters. once you cleaned the filters and inserted back , then just keep ac in stand by mode, open the remote panel and press the button on extreme right bottom of the remote ( see carefully in the remote, there is very light image of the filter is made along with the button). red light will go off. no need to press the reset button.... enjoy

Apr 03, 2012 | Hitachi Heating & Cooling

1 Answer

Hi. I have a failed indoor controler on a hitachi ducted aircon. mod ras-5hz. inverter. can I replace it with other type. Unit 15 yrs old and parts not available. What is the control voltage between indoor...


Hi, the control voltage to both indoor and outdoor will always be 24 volts AC. If this is a heat-pump unit, the high voltage to the indoor and outdoor will be the same, 208/ 230/ 240/ 277. If it is a split unit with a gas fired unit, the outdoor will be 208 or higher and the indoor will be 120volts AC. I'm sorry, you have the inducer motor, so it is gas! My mistake. Yes, always the gas furnace will be 120 volts AC and the remote condenser will always be 208 and higher. As far as replacing the inducer motor with a different kind, it will have to be the same voltage, 120, and amps, R.P.M's, 60hz, and made to pressurize and be able to vent Hot gases also. It must fit and operate like the old one. They should make a replacement universal motor to fit? Check with some of the wholesale houses on this and they can locate a motor to fit. Keep me updated on this please Don.
Shastalaker7

Dec 18, 2009 | Hitachi Heating & Cooling

2 Answers

Fujitsu asya09lcc wallmount split lights flashing indoors


According to the service manual page 8, the unit has an 'indoor unit control error'. Below is the link to the manual. Hope this helps. http://www.oceanairdist.co.uk/assets/pdf/service/Fujitsu/ASYA09LC.pdf
Mat

Jul 04, 2009 | Fujitsu 24R1 Air Conditioner

Not finding what you are looking for?
Heating & Cooling Logo

Related Topics:

3,046 people viewed this question

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

Paul Carew

Level 3 Expert

3484 Answers

Marvin
Marvin

Level 3 Expert

85222 Answers

john h

Level 3 Expert

22486 Answers

Are you a Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...