Question about OKI C9600hdn Laser Printer
Posted by Anonymous on
Where the cable plugs into the head often gets toner around it and it shorts the cable and you will get a 13X error. Just clean the connector and usually it cures it.
Posted on Jun 30, 2018
My OKI C9600 printer has problem related to led head with error code 133. This error msg indicates Cyan led head is failed.
There are some reasons that leading to this failure. One of them might be caused by drum. If drum is dirty or is overflown by toner.
So you may test C Led head to know it is OK or not. How to test ? Try changing with another Led Head such as Y,K, M.
This is the way I did, and my printer is OK now.
Posted on Jun 26, 2018
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: 980: Fatal Error
From the Service Manual:
*Error by media
clinging to the fuser
*Media has clung to the fuser.
Replace the fuser unit.
Before you replace the fuser, take it out and check for a piece of stuck label, paper, etc. You can spin the fuser roller by turning the gear on the side.
Posted on Apr 07, 2008
SOURCE: does anyone know what is
If you look on top of the fuser roller(upper orange roller), there is a thermistor (orange rectangle plastic that rides on the roller) you will see four wires going into that housing. Two are for the thermistor and the other two is for the fuse that is built into the housing. You would have to use a soldering iron to melt the plastic that the fuse is sitting in. You would have to figure out what to use as a fast blow fuse.
Okidata makes it difficult to take out the thermistor because the nut is locktite on the screw. Try using the soldering iron to melt it. Just make sure you dont damage the thermistor.
Posted on Jul 03, 2009
SOURCE: oki c9600 fatal error 175
short-circuit or Open
is detected (High
or Low Temperature
Turn ON power again.
Leave in that state for 30
minutes then turn ON power
Posted on Mar 29, 2010
Tips for a great answer:
Aug 17, 2014 | Oki Electric Industry C711n Led Printer
Jul 23, 2013 | OKI C9600hdn Laser Printer
Jun 30, 2011 | OKI C9600hdn Laser Printer
May 08, 2010 | OKI C9600hdn Laser Printer
Dec 21, 2009 | OKI C9600hdn Laser Printer
Aug 28, 2009 | OKI C9600hdn Laser Printer
Apr 25, 2009 | OKI C9600hdn Led Printer
Jan 07, 2009 | OKI C9600hdn Laser Printer
570 people viewed this question
Usually answered in minutes!