Question about Health & Beauty
Posted by Anonymous on
My flexcare began randomly turning itself on about a week ago. When charging it would vibrate a pattern of one short, then 2 short bursts. After talking with tech support and finding my flexcare was out of warranty, fixed it myself.
I opened the the base with a flat head, disconnected the battery (my model did not have a soldered in one) and wiped out the condensation in the housing and on the brush. I put it back together and it works as before. YMMV
Posted on Sep 12, 2013
Here is how I fixed the problem: I removed the bottom cap of the toothbrush by inserting a large flathead screwdriver in the slot/hole in the bottom and twisted to left until the cap popped out. Make sure your screwdriver is wide enough to fit in the slotted groves or you will strip it. I then slid out the brush assembly and did notice there was moisture and even some corrosion on the board under the ON button. I dried the assembly off the best I could then I used a can of electronics cleaner from RadioShack. This will displace any moisture and clean any corrosion buildup. I sprayed it liberally one component at a time. The buttons, all the chips on the board, the charging coil at the bottom and even the battery contact. It dries very fast. I repeated this a few times. When I sprayed the on button, I repeatedly pressed it on and off to work the cleaner in. I dried out the inside of the plastic case before I slid the assembly back in place. Then then pushed the bottom cap back in until it snapped into place. This was easy and does not require a tool. It is now fixed and no longer starts on its own or pulse while on the charger.
Posted on Jan 13, 2015
Update to my original solution. Six months after my original fix my brush started to become very difficult to turn on. The main problem with theses brushes is moisture getting inside the brush handle and damaging the electronics. My original solution fixed the issue but did not address the moisture. I took my brush apart once again and cleaned it with electronics cleaner from Radio Shack. I then applied clear dielectric grease (Get at any auto parts store ) to both buttons on the main board that control the settings and on/off function. I pushed the buttons repeatedly and kept reapplying the grease to work it in.This will displace any water and protect the buttons from moisture moving forward and prevent any future corrosion. I then lubed the O-Ring at the bottom. And before I re-assembled the toothbrush I applied a ring of clear silicon over top of the rubber boot at the top of the brush. I then snapped the brush back together and let the silicon dry completely before using. The silicon should help make a better seal keep out the moisture and if any gets in the dielectric grease should protect the buttons. The brush is back to 100% operational and hopefully will not have any more issues for a while.
Posted on Apr 20, 2015
I own an HX8910. It recently began turning off while brushing and on when standing on counter. I attempted to remove the insides as many have suggested but It won't budge. I don't want to risk breaking it and having to buy a new one - Cha Ching! But if I have to I will but probably not a Sonicare. I should get way more use than a year and a half. Any suggestions or tell me how much pressure I need to exert to get the inside out would be appreciated.
Posted on Jan 07, 2019
The switch is worn out and there's no fixing it. Sorry, but you'll have to get a new one (although I think Phillips is counting on that).
Posted on Sep 01, 2017
Over the last few weeks, my Sonicare Diamond Clean began to turn itself on and off, as described in other posts, like Morse code. Then a couple of weeks later, it would turn itself on and run for many minutes at a time.
I managed to slide the internals of the unit out from the bottom (no tools required), just placing the unit upside down, and firmly pushing down on the housing until the internals pushed out from the bottom of the unit.
Once the internals were separated from the housing, it was clear Sonicare has a design flaw with this brush system, as water must seep down the top seal and into the internals while it sits in the charging base.
My unit was very wet on the inside, with lots of corrosion on the circuit board. I left the unit apart overnight to let all the moisture dry.
Next day, Using about ½ can of CRC QD Electronic Cleaner on all the electronics and battery connections of the unit made a visible improvement to the corrosion problems.
Put the unit back together again, and it appears to be charging and working as normal.
Lesson learned to extend the life of my Sonicare Brush is after each use, remove the brush head, and dry the top post with a towel, to reduce the opportunity for water to seep down into the unit while it in the charging base.
Thanks to all who have previously posted, because without the knowledge, I would have otherwise just gone to Costco and purchased a new one.
Posted on Apr 13, 2017
This is happening to mine, as well. I had to put it in the garage to get some silence. I called Phillips Customer Care and was told it is out of warranty. No help and no suggestions. I bought it from my dentist's office about 3 years ago.
Thanks for the fix suggestions...will try that.
I am very dissatisfied and disappointed with Phillips Customer service and support. Those toothbrush es are very expensive.
Posted on Oct 13, 2016
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
This happened to me as well. In my case, it meant that one of the metal bars for the brush head broke. If you unscrew the brush from the base and look at it, touch the metal stabilizer bars inside to see if one of them is broken. If so, a simple brush head replacement will fix your problem.
Posted on Jan 09, 2011
SOURCE: On the 28th January 2011
I work for Philips, and I came across your post while visiting Fixya. I wanted to share with you the link for registering your Philips Sonicare:
You can also shop online, search for product information, and find support by visiting www.philips.com.
I hope this helps.
Posted on Feb 08, 2011
Tips for a great answer:
May 10, 2018 | Philips Health & Beauty
Apr 05, 2018 | Health & Beauty
Mar 11, 2015 | Sonicare Phillips Philips Sonicare...
Jan 07, 2015 | Computers & Internet
Feb 10, 2013 | Sonicare Phillips FlexCare RS930 / HX6932...
The best electric toothbrushes are the Oral-b Professional Care and the
Phillip Sonicare Diamond Clean. You can find more information on these electric
toothbrushes on their respected websites: http://www.usa.philips.com/c/diamondclean/289711/cat/en/ and http://www.oralb.com/products/professional-care-smart-series-4000/.
Feb 04, 2013 | Health & Beauty
Dec 11, 2011 | Sonicare Philips Essence 5500 Toothbrush
Dec 02, 2017 | Health & Beauty
Sep 30, 2011 | Sonicare Philips Essence 5500 Toothbrush
Feb 09, 2018 | Sonicare Healthy White Toothbrush
Jan 14, 2020 | Elite Health & Beauty
67,154 people viewed this question
Usually answered in minutes!