Question about Fisher and Paykel (IWL12)
107. (01101011) Motor Control Module Reset Error
The Display Module has detected that the Motor Control Module has reset when it should
not have. This can be due to a Motor Control Module supply disturbance or microprocessor
Primary Source: Motor Control Module.
Action: Replace Motor Control Module.
Posted on Dec 18, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Fisher & Paykel Dishwasher
If the machine has stopped and still has water in it, the drain pump is jammed. The pump is situated under the machine on the right hand side and can be accessed if you tilt the machine back against a wall. Try turning the motor fan by hand. Sometimes it will clear any foreign matter caught in the pump. If still jammed, remove pump by switching the machine off at the wall and pulling out the plug. Remove the wiring harness from the pump and turn it clockwise while releasing the white plastic clip which holds it in place and keeps it from turning on its own.
Posted on Nov 03, 2007
ngfam1 here for you!
I am happy to be of assistance!
Try unplugging the washer and then rebooting it after 3 minutes!
If this fails,
here is a good service that I recommend to my customers,
in our 65 year old appliance business!
A&E Factory Service
1-800-905-9505 -(IN U.S.A.)
They are open to make appointments 7days/24hours
A&E is factory authorized service for most brands!
Including warranty work!!!
They will help you, and all will be well!
You will be fine now!
Posted on Aug 26, 2008
SOURCE: I have a fisher and
Hi there. FC 49 has a few possiblities
1. the wiring connection to the cold water valve has been disconnected
2.the cold valve has failed, compare resistance with hot valve (they should be the same)
3 the motor controller has failed
I hope this helps
Posted on Oct 25, 2008
SOURCE: Fisher and Paykel Intuitive has
I had the same problem, code 43 is an out of balance switch problem, i found mine was just sticky, if you pull it out (under the electronic control unit, under the top panel) you may be able to find out if its stuck or if it needs a new one, you could possibly find one from another model. hope this helps
Posted on Dec 26, 2008
Tips for a great answer:
Apr 29, 2018 | Fisher Refrigerators
Oct 16, 2015 | Fisher Washing Machines
Mar 15, 2013 | Fisher and Paykel GWL11 Top Load Washer
Aug 23, 2012 | Fisher and Paykel GWL11 Top Load Washer
Apr 13, 2012 | Fisher and Paykel Fisher & Paykel Washer
Nov 15, 2010 | Fisher and Paykel (IWL12)
May 18, 2010 | Fisher and Paykel Fisher Paykel Intuitive...
Apr 08, 2010 | Fisher and Paykel Fisher Paykel Intuitive...
Aug 24, 2008 | Refrigerators
268 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: