Question about Whirlpool GU2400XTP Built-in Dishwasher
I am locked out of cycle with clean light blinking green and cannot find my manual, dishwasher is about 1 year old. Is there a sequence to break this cycle? I turned off power for 60 seconds to no avail.
then cancel..... wait until 2 minute cycle is done. open and close the door and make sure it is closed.
Then run another cycle. saw this on another post and it worked for me. They said that if it did not reset then either the latch has a bad connection or the heater for the water is bad.. it must register that the door is closed in order to actually start the heater for the water. I hope this helps you as well as it helped me.
Posted on Dec 22, 2008
Try the door switch first. This is a very easy fix if it is it. Otherwise you will kick yourself for not trying it sooner if it turns out to be the problem, trust me I know. Push in on the door when it is closed to close it tighter. If you here a click, and then another click when you release the pressure, then the switch could be your problem. Even if you don't hear a click, try this fix first. There is a double switch in the latch and the one for the heating element can be left off when the rest of the machine is on. I had this problem. I bent down the thin metal tab that the door latches onto. Bending it just a little fixed my problem. Don't bend down too much or you will keep the door from shutting properly.
Posted on Jan 19, 2009
Thanks! I just had to pay a technician 35.00 to diagnose what wasn't wrong. He said I needed a control circuit board and It was going to run me over 200.00, parts and labor!
Posted on May 22, 2009
Thanks...... worked for me.....
I save $..........
Posted on Dec 24, 2012
Press hi temp wash, air dry, hi temp wash, air dry this should reset the cycle
Posted on Mar 20, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
you have to hit heated dry and normal and toggle these till all the lights light up. then hit cancel . you are going to have to turn the power of and slide the dishwasher out and look directly behind the dishwasher you will see that a wire off of the heater is more than likly burned of repair the wire you should be fine. replug dishwasher in after wire is repaired. if you do not have a burned wire you have a bad heating element replace the element.
Posted on Apr 14, 2009
Tips for a great answer:
Dec 18, 2013 | Whirlpool Gold Dishwasher with Quiet...
Mar 07, 2011 | Whirlpool GU2400XTP Built-in Dishwasher
May 16, 2010 | Dishwashers
May 10, 2010 | Whirlpool 24 in. DU1100XTP Built-in...
Aug 29, 2009 | KitchenAid 24 in. KUDI02IR Built-in...
Jun 21, 2009 | Whirlpool Dishwashers
Apr 14, 2009 | KitchenAid 24 in. KUDI02IR Built-in...
Mar 04, 2008 | Whirlpool GU2400XTP Built-in Dishwasher
16,107 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: