Question about Krups Bravo Plus 872 Espresso Machine
I purchased the small ground filters that contain the expresso grounds inside. I am following all indications but still no results.
As this is an automatic espresso machine, I suspect that the cake container is where the "used" pucks of ground coffee drop into after your espresso is extracted. The container may not be fully seated in position. See if there is a door on the machine that the container may be hiding behind.
Posted on Sep 27, 2008
SOURCE: Krups XP7240 leaks
The grind selector knob can be removed with the following steps: 1) Remove screw on side near grinder (do not let the screw fall into grinder, :-) ), 2) use sharp knife or similar to pry off cover with three dots. This should be easy. 3) Now you can rotate the grind selector and see that the white clear plastic does not rotate and the black does. There are two little pieces (one black, one clear plastic) on opposite side from grinder that slide over eavh other to keep this knob 'locked' into place. 4) again with a sharp pointed knife or similar you can separate these two pieces to 'unlock' them. This is made easier by lifting the side of the bean holder by the grinder gently and tipping it up. Be careful not to force anything too much. The black part should pop off. 5) Now you can lift off the clear bean holder.
After this good luck. We made it farther into the machine, but could never get to where we needed to go to fix our problem.
Krups must be congratulated for designing a machine that cannot be repaired and must be replaced with new purchases.
Posted on Jan 11, 2009
SOURCE: Krups XP4020
The coffee holder is just hanging in place, not secure against the seal as it should be. Make sure the coffee holder is secured flat up against the seal before turning the handle and locking it into place.
Posted on Apr 05, 2009
After I changed piston sealing I get the same error 09. It was caused by missing connection to the thermoblock temperature sensor. In my case both connectors for thermocouple were cracked. They are located directly on the body of thermoblock, below two fuses, covered by rubber housing. After I solder them again on the position error 09 disappeared. Unfortunately it is necessary to open at least front panel of the machine. Moreover I tink that there is also important to save polarity of those two cables.
Posted on Aug 07, 2009
Tips for a great answer:
May 05, 2018 | Coffee Makers & Espresso Machines
Sep 19, 2011 | Krups Bravo Plus 872 Espresso Machine
Jul 04, 2010 | Krups Bravo Plus 872 Espresso Machine
Oct 30, 2009 | Krups Coffee Makers & Espresso Machines
Aug 08, 2009 | Krups Bravo Plus 872 Espresso Machine
Oct 18, 2008 | Krups Bravo Plus 872 Espresso Machine
Aug 12, 2008 | Krups Caffe Bistro 867 Espresso & Coffee...
Oct 28, 2007 | Krups Caffe Bistro 867 Espresso & Coffee...
Oct 05, 2007 | Krups Bravo Plus 872 Espresso Machine
294 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: