Question about Kenmore 63942 Dryer
HELP! I'm having a problem with a Kenmore electric dryer. The motor runs, the drum tumbles, there's 240vac at the terminal block. I've followed all the t-shooting suggestions that are on the tech sheet that came with the dryer. I've checked all the t-stats, centrifigal switch in the motor (I removed the motor, blew out the lint/dirt and manually ohmed out the switch by moving it in/out - worked ok), voltages, etc. I also did the on-baord diagnostics test. At first I thought it may be the fabric care temp switch (5 pos) because when I tested the switch outside the unit, it appeard that the med and med-high positions didn't work. But during the diag test, it "beeped" with each click. Also when I checked it in circuit, the voltages appeared to be working when measured at the board (binary 0 - 4). The heating element reads 9.9 ohm, the exhaust thermistor reads correct for ambient temp. The only thing left is the pc board. I don't want to purchase a new board, if this isn't the problem and there are no schematics for it anywhere. Are there any other t-shooting suggestions to try? Is there a way to test the board? Any help is appreciated. The wife is getting ready to hang me out to dry instead of the clothes! Thanks!!
The new dryer products clog up the fine mesh screen lint trap. Take it out each time and wash it with hot water until you can see the water run through. I learned this the hard way and paid for a service call.
Posted on Aug 19, 2007
Not an interesting comment. Most of the Guru's of this sight do not get paid a cent for their solutions. What they do, is help people. Take time out of their careers and family life to help people save money. A lot of them get unfair ratings from sef centered know it alls or ungrateful people who do not take the time to read the posts. I'm glad the directors of this site take the time to correct unfair ratings. It makes us feel a little better about going out of our way to help people.
Posted on Jun 19, 2007
I have had this problem before. Check to see that the vent tube is not kinked going to the outside or that it is not clogged. Once I unclogged the tube (because I had the dryer pushed all the way to the wall) it started to dry once again.
Posted on Sep 24, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Mar 11, 2010 | Whirlpool LER4634J Electric Dryer
Jan 08, 2010 | Dryers
Jan 06, 2010 | Kenmore 84832 Electric Dryer
Dec 23, 2009 | Dryers
Dec 11, 2009 | Maytag Neptune MDE5500AY Electric Dryer
Nov 09, 2009 | Kenmore 62602 Electric Dryer
Oct 23, 2009 | Whirlpool LER4634J Electric Dryer
Sep 24, 2009 | Dryers
Aug 15, 2009 | Kenmore 62872 Electric Dryer
Aug 10, 2009 | Kenmore 60172 Electric Commercial Dryer
13,504 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: