Question about Carrier XHB123D X/Y Series Heat/Cool Air Conditioner
Is this a problem with a stuck blowere switch, thermostat, or control panel. The heater seems to fire up adequately
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Carrier Weathermaker 8000Vs
This is nothing short of a circuit board fan relay of a bad motor.. to find out if the motor is good, unplugg the black & white wire , in which white =ground black=hi-speed 120volts and conect them to power -ground and see if the motor works..if does, then its the fan circuit board if not then its a bad motor...
Posted on Aug 25, 2008
Remove all power from the furnace, it is likely the brain in the furnace is need of being reset, from the battery replacement, why did you change the battery, was there an indicator telling you to change it?
Many times just removing all the power to the furnace will do the trick with a reset, if not let me know and we will go from there, but it sounds like the main brain is confused or bad, more likely confused, so try the power removed first.
Than let me know firstname.lastname@example.org
Posted on Nov 22, 2008
not sure if you have fixed the problem. There is a web site to get this motor... www.arnoldservice .com he should have the motor. I recomend a generic 3 speed mtr. you will have to cut the plug on the original as it may be a 4 speed but you only need 3 speeds. The oem motor will be more expensive then an aftermarket.
Posted on Feb 02, 2009
SOURCE: BLOWER NOISE
Could be a loose blower wheel. It has slipped and touching the sides of the blower housing.
Turn off the power to the nit.
Remove the 2 bolts holding the blower in place.
Make yourself a wiring schematic.
Remove the wires.
Be careful not to touch the capacitor.
Remove the blower housing.
Clean the blower blades.
Spin the wheel to see where it is hitting.
Loosen the set screw on the motor shaft and adjust your blower wheel.
Posted on Mar 10, 2009
If you can get to the shaft of the motor, oil it using electric motor oil. If the motor spins freely, you just may need to replace the start capacitor, however if it is binding; you will need to replace the inducer as an assembly.
Posted on Jan 18, 2010
Tips for a great answer:
Jul 26, 2018 | Heating & Cooling
Jun 13, 2017 | Carrier Heating & Cooling
May 09, 2012 | Heating & Cooling
Dec 11, 2010 | Carrier XHB123D X/Y Series Heat/Cool Air...
Oct 30, 2010 | Carrier XHB123D X/Y Series Heat/Cool Air...
Apr 19, 2010 | Carrier XHB123D X/Y Series Heat/Cool Air...
Oct 11, 2009 | Carrier XHB123D X/Y Series Heat/Cool Air...
Mar 10, 2009 | Carrier XHB123D X/Y Series Heat/Cool Air...
403 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: