Question about Pioneer PDP-5020FD 50 in. Plasma HDTV

1 Answer

My brandnew Pioneer PDP-5020FD won't turn on.

I just took the TV out of the box. It wont turn on when I plug it in. I have checked the power connection. I have tried multiple outlets. I am trying to turn the TV using the standby button on the side of the TV, not via the remote.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Check page 9 of this document:

http://www.pioneerelectronics.com/StaticFiles/Manuals/Home/PDP-5020FD_OperatingInstructions0610.pdf

You will see that there is a power button on the bottom right corner of the back of the unit (item 25). Turn the unit on using that first.

Posted on Aug 10, 2009

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I turn it on a blue light came blinking but no sound and no picture


The blinking blue light may be signaling power supply failure.

May 06, 2016 | Pioneer PDP-5020FD 50 in. Plasma HDTV

1 Answer

Find activation code for pioneer


My pioneer 5020FD Kuro tv. when I plug power to the unit, a blue light blinks 8 times pause 2 sec. and blink 8 times repeating this and if i press power button it clicks red light and makes a clicking sound and goes back to the blue light blinking again, it did this once before and the picture came on fine until i turned it off and now it just blink the blue code.

Dec 10, 2014 | Pioneer PDP-5020FD 50 in. Plasma HDTV

1 Answer

My tv wont turn on


Fault with the main power supply regulator board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electronicshelponline.blogspot.com/
It will be best to replace the power supply regulator board as card basis rather than making "Surgery" to it; which usually will make loss for both money and precious time.

Aug 31, 2014 | Pioneer PDP-5020FD 50 in. Plasma HDTV

1 Answer

How do i connect head phones to pioneer pdp 5071pu TV


This model has no headphone out put. In the rear panel there are two monitor audio outputs which could drive headphones, but I think the volume output to a possible monitor matches the tv loudspeaker output, and may not turn off the audio separately.

Mar 09, 2014 | Pioneer PDP-5020FD 50 in. Plasma HDTV

1 Answer

Cost repair screen cracked


should have 4 screws on front of tv screan on coners or on back then you should be able to pull front of screan an replace the screan it just plugs in to the mother bord jesus loves u un plug it first

Nov 05, 2013 | Pioneer PDP-5020FD 50 in. Plasma HDTV

1 Answer

PIONEER TV RED LIGHTS


Hi Miquel.

If the unit does not start but stays in standby with the red light on, then the TV is in forced standby mode because an internal problem has been detected.

Try disconnecting power cord for ten minutes. If that does not help, then the TV must be tested and repaired.

Regards.

Ginko

Dec 02, 2011 | Pioneer PDP-5020FD 50 in. Plasma HDTV

1 Answer

Pioneer pdp-4271 plasma will not turn on, tried unplugging it and letting it set and plugged back in not turning on, i have checked the outlet for power and it is good also checked end of plug that...


The tv have a power supply board problems.That the board,where the power a/c cord plug into it.Tries websites like Shopjimmy.com,Ebay.com to buy a refurbish power supply board for the replacement.

Oct 19, 2010 | Pioneer PDP-4271HD 42 in. Plasma...

1 Answer

No power to tv


If there is no power to tv, remove rear panel and check the fuse. If the fuse is good, the power supply will need to be replaced

Jul 09, 2009 | Pioneer PDP-5020FD 50 in. Plasma HDTV

Not finding what you are looking for?
Pioneer PDP-5020FD 50 in. Plasma HDTV Logo

742 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Televison & Video Experts

The Knight
The Knight

Level 3 Expert

76177 Answers

Marvin
Marvin

Level 3 Expert

85216 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Pioneer Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...