Question about Briggs & Stratton Briggs Stratton Vanguard V - Twin Vertical Ohv Engine with Electric Start 23 Hp, 1" X 3 5/32" Shaft, ModelNo. 386777 - 0036 - E1

1 Answer

I have a 16hp v twin on a prusserwasher that bogs down under load

Vanguard v twin ohv

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 749 Answers

Check for intake leaks. restricted fuel line. air cleaner anf fuel filter.

Posted on Nov 18, 2017

Ad

5 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

adamsuydam

  • 5 Answers

SOURCE: vanguard twin 303447 drops a cylinder when hot

there is hose coming from your valve cover to pump. check it for cracks. one of your gaskets at the air filter housing to carb or carb to black block or block to intake maybe leaking. fuel shut off solenoid could be going bad. choke cable adjustment. there is crank case breather under air filter housing with a s shaped hose coming from it to air filter housing make sure it is not loose. i have an engine at work that did =the same thing. i work at a golf course. i am the mechanic. i changed the hose from valve cover to pump and it cured that problem

Posted on Jan 06, 2010

suzukiracing

suzukiracing

  • 200 Answers

SOURCE: I have an 18hp v twin vanguard and it is

Piston rings being wore.Thanks for asking and I hope this helps out.Please leave me 4 thumbs up.

Posted on Jul 20, 2010

Mike Roberts

  • 395 Answers

SOURCE: Ok i have a problem

It appears that you have a slight mis-adjustment in the idle speed and idle mixture. To adjust setup, start with at least a half tank of fuel, and have engine at operating temperature (That is warm but not overly Hot). The Briggs & Stratton Website manuals section should show the locations of the adjusting screws if you are not sure of them.
To adjust idle speed set Throttle control to minimum and adjust screw on throttle butterfly to maintain a good idle speed. To adjust idle mixture, screw in idle mixture screw (Lean) until motor falters and then screw out (Rich) until it falters again. Correct setting is the halfway point of these two positions. You may have to re-adjust idle speed again and also the mixture to get best running.
If you are not comfortable doing this, take it to a B & S dealer.

Posted on Sep 22, 2010

mark grubbs

  • 13 Answers

SOURCE: 23 hp engine will start great when cold, but after it run a short it will not start Brfiggs&Stratton vanguard V-Twin Vertical Ohv Engine start.

it sounds like a fuel starvation problem it is very possible theres a blocked vent in the carb. the carb will probably will need rebuilding not very difficult

Posted on Apr 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Will not start. but if I pour gas in carburetor it will. stop after the gas is burn of carburetor


Could be that the needle is stuck in carb, or else the fuel pump diaphragm is bad. Check the pump, thats what I would check first.

Jan 24, 2013 | Briggs & Stratton Briggs Stratton Vanguard...

1 Answer

How to set governor speed on B@S v-twin vanguard


It is a simple but tricky job to explain here..I suggest you go into utube and ask that very same question starting with utube and then the question there are good sites that cover this..good luck..

Jun 20, 2012 | Briggs & Stratton Briggs Stratton Vanguard...

1 Answer

Briggs and stratton vanguard 16 hp v-twin starter replacement


It most Likely is located under the engine cover..it mount just below the flywheel. Good luck

Apr 11, 2012 | Briggs & Stratton Briggs Stratton Vanguard...

2 Answers

23 hp engine will start great when cold, but after it run a short it will not start Brfiggs&Stratton vanguard V-Twin Vertical Ohv Engine start.


it sounds like a fuel starvation problem it is very possible theres a blocked vent in the carb. the carb will probably will need rebuilding not very difficult

Apr 09, 2012 | Briggs & Stratton Briggs Stratton Vanguard...

2 Answers

I have an 18hp v twin vanguard and it is


Piston rings being wore.Thanks for asking and I hope this helps out.Please leave me 4 thumbs up.

Jul 20, 2010 | Briggs & Stratton Briggs Stratton Vanguard...

1 Answer

How to change electric starter on vanguard 14 hp v twin vertical shaft.


Please, help me to regulate valves on Vanguard B&S 14HP OHV model:294446 tip:1141-a1. I don't know how. Thenks. My adress kolya-kolyanof@rambler.ru

Mar 31, 2010 | Briggs & Stratton Briggs Stratton Intek V...

1 Answer

Engine appears to run normaly until PTO is egaged,then it backfires and quits. Engine is an 18 HP Vanguard twin, model 350777.


Check you float in the carb I had one a few years back and it was partualy plugged cleaned it out and everthing worked fine. Also is the PTO binding up or bearings going bad putting an excessive load on the motor.

Jul 04, 2009 | Briggs & Stratton Briggs Stratton Vanguard...

Not finding what you are looking for?
Briggs & Stratton Briggs Stratton Vanguard V - Twin Vertical Ohv Engine with Electric Start 23 Hp, 1" X 3 5/32" Shaft, ModelNo. 386777 - 0036 - E1 Logo

Related Topics:

655 people viewed this question

Ask a Question

Usually answered in minutes!

Top Briggs & Stratton Tools & Hardware - Others Experts

Bill Boyd

Level 3 Expert

53757 Answers

Randy Schumann
Randy Schumann

Level 2 Expert

408 Answers

Tom Chichester

Level 3 Expert

55370 Answers

Are you a Briggs & Stratton Tool and Hardware - Other Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...