Question about Mitsubishi MS12TN Air Conditioner

2 Answers

I have a a/c unit mitsubishi electric ms-12rv r22 when starting it on cooling or heating mode it stops after 30sec and the operating light flashes and the otdoor unit does not run the indoor unit fan stops can you help thanks

Posted by on

  • carole_hendr Apr 11, 2009

    there is two lights on the indoor unit the left light is power on the other is cooling run or heating run.the power light flashes and the cooling light goes out

  • Anonymous May 11, 2010

    Can you tell me the flashes or if it has a fault code?



2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Mitsubishi Master
  • 43,501 Answers

Here is where you can find all the info you will ever need about Mitsubishi Air Conditioning units...
Check out this tip that I wrote about that...

Mitsubishi Air Conditioner Troubleshooting and Repair


Posted on Aug 20, 2010

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 2 Answers


Posted on Feb 08, 2011


1 Suggested Answer


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Can the Mitsubishi Electric MSH-17DV be charged with R407C?

No Mitsubishi units are critically charged. Use only R22. They engineer the heck out of their units....they don't like other refrigerants in the system and won't warranty any problems with any other refrigerants

Jun 02, 2018 | Mitsubishi Heating & Cooling

1 Answer

My LG air con was working and now it's stopped and there is a gree light flashing 7 times the a pause then 7

7 Flash==== Different Operation Mode
Indoor Unit is Set in Different Cool/Heat Operation Mode.....

Jan 14, 2016 | LG Heating & Cooling

1 Answer

Is the heat pump cooling itself down? It is a combination heat pump/air conditioner wall unit.

If a unit is in heating mode the outdoor unit is in cooling mode (outside always does opposite of indoor) after a while if there is a build up of ice on outdoor coil unit stops and puts hot gas through outdoor coil to clear it. The indoor fan stops to avoid and heat loss in area served buy unit once this has been done and indoor unit coil is hot again fan will start. This is the correct operation of the unit to save against bust could and reduced efficiency

Dec 31, 2015 | Heating & Cooling

1 Answer

Mr slim Mitsubishi - how much fill

On the data plate for the outdoor unit it will tell you what type and how much refrigerant you need. If the line set is longer than 25 feet you will likely need a bit more than what it says. A 40 degrees evaporator temperature is ideal, approximately 65 psi for r22

If you need further help, reach me via phone at

Mar 31, 2017 | Mitsubishi Mr. Slim MXZ30TN Air...

1 Answer

Fujitsu Air Conditioning split unit Model

Your compressor is seized up. shut down unit and let compressor cool down, it may start again but probably needs to be replaced.... sorry for the bad news,

Nov 10, 2009 | Fujitsu 24C1 Air Conditioner

1 Answer

My reverse cycle air con (Mitsubishi MSH 12RV) is not producing warm air (for use during cold weather). Which is likely the faulty part ?

I would check the reversing valve. This is what switches the flow of refrigerant for Heating and cooling.There could be several other reasons that could cause it not to heat.
Good Luck, Sincerely, shastalaker7

ps Heat pumps are very temper mental, like I said there could be many things that could cause this problem, and I couldn't walk you through them all. If you have a split system, two piece unit, go to the out side unit and have some run the a/c in cool. Then after a few min. have them switch it to heat and you can hear the reversing valve switch to heat, as it will make a swishing sound.If it doesnt, the valve may be bad, no power to the coil on it, or even the coil could be burned out.
Sincerely, shastalaker7

Oct 30, 2009 | Heating & Cooling

1 Answer

Power light is flashing and it isnt working

A multi split system is it? One of the reasons why the light flashes is because one indoor unit is on cool and the other is on heat. Changing the one on cool (or on heat) will fix this. Both indoor units need to operate on the same mode.

Jul 20, 2009 | Mitsubishi Mr. Slim MXZ30TN Air...

1 Answer

Mitsubishi PAR-F27MEA AC controller icon meanings

hi.welcome to the mitsubishi worl of airconditioning.thay are great units to have.ok let me explane this for you.

the sun is for heat mode
the snow flake is for cooling mode
rain droplet is for dehumifiy the air if its a humid day.i hope this helps have to choose the modes on the remote for the unit.then the unit will do the mode you choose on the day.

Jun 09, 2009 | Heating & Cooling

1 Answer

Mitsubishi wall unit srk50zg condenser src50zg air con not heating new install

Double check your wiring .if the indoor fan is not blowing then you either have an electrical issue OR bad blower motor .

May 24, 2017 | Refrigerators

Not finding what you are looking for?
Mitsubishi MS12TN Air Conditioner Logo

1,096 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Heating & Cooling Experts


Level 3 Expert

8546 Answers

Stuart Slabber

Level 1 Expert

25 Answers


Level 3 Expert

85222 Answers

Are you a Mitsubishi Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides