Question about Lenovo ThinkPad Computers & Internet

1 Answer

Battery fuse - ThinkPad Lenovo Computers & Internet

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 779 Answers

I have never found a fuse in a battery. What u have r thermal cutouts, that sometimes reset after activation or not.

Posted on Dec 10, 2013

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wont charge, new battery and alternator


Is the battery symbol lit on the instrument cluster ? Check fuses F1.26 30amp in the battery junction box , fuse box near battery in the engine compartment . Also check F2.27 10amp fuse in the central junction box , inside passenger compartment under the dash . It won't charge without voltage on this fuses . Also the heavier gage wire on the back of the alternator should have battery voltage , 175 amp main fuse near battery connection .

Jan 17, 2016 | 2000 Ford Taurus

2 Answers

My 2005 dodge neon's battery won't hold a charge, lights flicker and dim and on the dashboard the word fuse flashes, what is going on?


Could be a bad battery but I suspect your battery cable is either loose or corroded or dirty. Before you pull the battery disconnect your battery cables and clean them both ends and when you put them back on make sure you have good connections and tighten good.If that does not work pull your battery and get it tested at a battery out let . they should do that for free.

Jan 10, 2016 | 2005 Dodge Neon

1 Answer

100 amp battery fuse assembling


Just hook fuse on one side to battery + and hook any other wires
to the other side of fuse .But kook the wires first then kook the fuse to the the battery.
Ray

Nov 05, 2014 | Cars & Trucks

4 Answers

Could a 1000 amp battery blow fuses in a 1999 blazer


Likely there is a blown fuse but a battery won't blow a fuse on its own. Change any blown fuses and if that fixes the issue and the fuse doesn't blow for awhile then your ok but if the fuse blows quickly then you have an issue with the electrical system and you need to take it to a shop

Apr 17, 2014 | 1999 Chevrolet Blazer

1 Answer

My battery light is on. its a brand new battery. why is my battery like coming on?


Have you checked your fuses ? There is a 10 amp fuse in the fuse panel under the hood of the vehcile in the engine compartment. Below is a fuse layout diagrm for that fuse panel. I have marked the fuse you want to check if you haven't already (# 26). If the fuse is good make sure you are getting power at the main big wire attched to the alternator. You should have the same amout of power at that connector at the alternator as you do in the battery itself. That is a direct wire going to the battery but it does have a fuse link in that wire so if no battery power there you will need to locate that fuse link and replace it. Sorry I don't have a picture of the location of the fuse link. Hope it's just a simple fuse or fuse link and I hope I was able to help....

2_21_2013_3_50_17_am.jpg

Feb 21, 2013 | 2001 Mercury Sable

1 Answer

I need to replace the fuse for Pronto M41 the fuse is 75A, the wheel chair was not staying charged so we took the battery out to have them checked and they told us to add water then let it charge over...


you are not to open and add water to your batteries they are supposed to be sealed. if you put unsealed batteries in your chair then you did not put in the correct batteries. Batteries from wal mart or any type of unsealed batteries will void any warranties on your chair. the fuse should not have blown if the batteries were put in correctly and you had the wrong batteries. You will have to contact Invacare directly to order a fuse or have a local provider order one for you. While your at it dump the batteries and purchase the correct batteries for your chair You need 2 U1 sealed deep cycle batteries. Check with a local interstate battery outlet or contact your provider to get you the proper batteries

Mar 30, 2011 | Electric Mobility Invacare Pronto M41...

1 Answer

Why wont my dashboardlights and radio not work. I have cheecked the fuses.


Did you check for battery power at the fuses, or did you give them the "Eyeball Test". The two fuses involved in your problem are fuse "O" and fuse "H". Fuse "O" will only have battery power when the ignition switch is in the "ACC" or "ON" positions. Fuse "H" will have battery power at all times. If both of these fuses have battery power when they are supposed to, the problem is probably your illumination control switch is either defective or turned off. If fuse H has no power, the problem is in the main wiring harness between the battery and the fuse block. If fuse "O" does not have power when it is supposed to, the problem is most likely your ignition switch.

Jan 11, 2011 | 1994 Nissan Sentra 4-Door

1 Answer

What is the fuse location for the power windows and for the rocker switches for the 2002 Ford Explorer? Thanks


for early production models
bjb (battery junction box) fuse #6
cjb (central junction box) fuse #17

for late production models
bjb (battery junction box) fuse #6
bjb (battery junction box) fuse #47
bjb (battery junction box) fuse #2
cjb (central junction box) fuse #17



Apr 04, 2010 | 2002 Ford Explorer

1 Answer

Car shorted out no power will not start


Hello! You'll need a multimeter set on the 50 volts dc scale. Pull the 10A fuse for ECM/IGN...Check for battery on the feed side of the fuse with the key on. If you read 12 vdc then battery is present at the fuse block. If battery is present at the block...carefully pull one fuse at a time and, rather than seeing if it's blown, check fuses with a meter. Set the meter on the X10 ohm scale. With battery at the block; Fuses are blown at the inside block.

If there is no battery coming to the fuse block inside the car; Go under the hood and check the fuses in the main fuse block. Check in the same fashion that was explained earlier.

I believe that the high amperage fuses, as in 60 or 80 amps that feed the ignition and supply battery to the inside fuse block are blown.

Also check for battery at the starter motor. This is a direct supply from +post on the battery itself. If no battery is present there may
be a fusible link installed. Disconnect the positive cable from the battery; Again use the ohm meter set on X10 scale and check to see if this cable is open. A fusible link may be installed between main battery and the red wire that runs through the firewall into the inside fuse block.

If you need further assistance write a comment...I am at your disposal like a garbage truck.


Guru................saailer


I’m happy to help further over the phone at https://www.6ya.com/expert/david_6df67de3b14de867

Dec 21, 2009 | 1991 Chevrolet Camaro

Not finding what you are looking for?

Open Questions:

Computers & Internet Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lenovo Computers & Internet Experts

Alun Cox

Level 3 Expert

2679 Answers

Ekse

Level 3 Expert

13434 Answers

Toby Lee
Toby Lee

Level 3 Expert

409 Answers

Are you a Lenovo Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...