Question about Nikon Coolpix S9100 12.1mp Digital Camera red 26249
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
I had the same problem. i dont know if this will work for yours, but what i did was when i had the card in the slot i pushed in it as far as i could with my finger nail and then it clicked right in.
Posted on Oct 14, 2008
You should be able to transfer the pictures if it has built in memory. then transfer it to memory card the same way you'd take them off
Posted on Jan 08, 2009
SOURCE: sd memory card cannot be used
This happenes when you remove the card while read/write process is still going on. Try some professional service who will retive the data for you from the mem card. Hope this helps.
Posted on Jan 19, 2009
Some notebooks cannot read SD capacities of 4GB and above. The workaround is to use an external SD card reader.
NOTE: Please rate our help to keep this free service online
Posted on Jan 08, 2010
If the card works in another camera or another card doesn't work in your camera , the problem is with your card reader in your camera.
If you open you sd slot and look inside with a sharp light , you should be able to see on the left side of the slot there is a little copper or spring steel lever switch. This switch work as follows:
1. When no card is inserted / no write protection , the switch is open and thus the protection is off.
2. When locked card is inserted , the tab is depressed and tells the camera that the card is lock.
Contrary to popular belief ,the little tab on the sd card is not an electronic switch and does not physically influence the card operation itself. If you put a locked card into a camera without a sd lock switch , you would still be able to use the card normally.
It is incredible difficult to fix this switch because of space limitations in the sd card. Look into the sd slot and if you can see the switch , use a needle to pull the little tab down toward the base of the camera by about 2mm or until it works being careful not to bend it.
If this does not resolve your problem , there might be a short in the switch circuit and the camera will need to be disassembled to resolve this error. This should cost no more than $50.
Please feel free to contact me if you need further information
Posted on Sep 27, 2010
Tips for a great answer:
Dec 02, 2017 | Cameras
Jan 28, 2015 | Huawei Ascend II battery 2200 mAh, Black
Jan 18, 2010 | Kodak EasyShare One Digital Camera
Jan 16, 2010 | Kodak EasyShare C643 Digital Camera
Jan 04, 2010 | Kodak Easyshare C190 12MP Digital Camera...
Dec 31, 2008 | HP Photosmart R717 Digital Camera
Jul 13, 2008 | Panasonic Lumix DMC-FZ30 Digital Camera
May 27, 2008 | Cameras
Mar 16, 2008 | Kodak EasyShare C613 Digital Camera
85,236 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: