Question about Minn Kota Endura 30 Freshwater Transom Mount Trolling Motor

Open Question

How to replace a tilt lever on a Minn Kota Endura 30

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Gene Pitts

  • 159 Answers

SOURCE: Minn Kota 30 transom mount motor magnets fell out during service

Hello drummondr, please contact www.minnkotamotors.com/index.asp by E-mail attention Dave with your questions. Merry Christmas.

Posted on Dec 09, 2008

Ad

Anonymous

  • 1 Answer

SOURCE: I have a Minn Kota Endura 30, transom mount.

There is kind of a collar on the lower side of the head where the head connects to the shaft. There is a single bolt that runs right thru the shaft at this location, remove it. Rotate the head 180 degrees and re-install the bolt. 5 minute job.

Posted on Apr 17, 2009

Anonymous

  • 1 Answer

SOURCE: minn kota endura 30 repair

The top section will pop off when the six screws are removed. It might just be dirty and sticking.

Posted on May 06, 2009

Anonymous

  • 2 Answers

SOURCE: the prop will turn on my minn kota endura 44 but

Odds are you have sheared the pin (slides through the prop shaft) holding the prop, or you have damaged the slot on the prop that the pin sits in.

Prop is secured to the shaft with a metal nut, or flat plastic wing nut. Remove the nut to remove the prop. You may have to pry, slightly, the prop from the motor housing. Removed, you will see a whole in the shaft where a pin should be located. If the pin broke, it probably hit the floor when the prop was loosened. If the pin is intact, examine the rear side of the prop and look for damage to the plastic slot where the pin would sit making contact.

If you've snapped the pin, you can make a replacement with a nail using a hacksaw. Replacement pins can also be ordered from Minn Kota. If the back side of the prop is damaged (recess for the pin to sit), the prop is toast. Replacement props are often carried by Walmart, and include a new pin.

If neither part is broken, perhaps the prop was just not seated on the pin correctly allowing the prop to freewheel.

Posted on May 13, 2009

Anonymous

  • 1 Answer

SOURCE: how do I remove the composite shaft from the motor housing

I just replaced the shaft (composite) on my Endura 34 today. First, remove the crossbolt that attaches the control head to the top of the shaft. Second, remove the top cover of the control head. Third, make note of the wire connections within the control head (take a picture) and then unplug the red, yellow, white and black wires...no need to unplug the main 6 guage red and black power wires. Fourth, with the wires unplugged, pull the shaft with motor housing attached through the transom mount assembly. Fifth, immobilize the motor housing (gently vice?) and heat the socket in which the shaft screws into motor housing. Do not overheat, only use enough heat to soften factory sealant making unscrewing shaft possible. Sixth, reassemble in reverse order.

Notes: Do not use a pipe wrench as this will crush the composite shaft, either old or new. Apply thread sealant prior to installing new shaft (I used Permatex Thread Sealant/Formagasket). Ensure crossbolt hole on top of shaft aligns with motor housing below.

Posted on Jun 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What kind or type of battery do I need for a Minn Kota Endura 40 trolling motor?


The Endura 40 is a 12V motor. To get off a bit cheaper go to a place that sells car batteries and get a sealed maintenance free battery.

Sep 27, 2010 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

What is the amp draw of the motor, so i can buy the right battery for a minn kota endura 30 trolling motor?


You will need a 100 to130 amp hour deep cycle marine battery. Check prices of many brands in your area. (WalMart, Autozone, boat dealers,ect.)

Sep 16, 2010 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

Minn Kota Endura 30 Trolling Motor specs


call 800 number on head minn kota they are very helpful and will fax, email or mail you anything you need.

Jun 02, 2010 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

Endura 30 Freshwater Transom Mount Trolling Motor: I JUST PURCHASED A Pellican pontoon boat 10e and i...


probably an endura 50 would be a better fit for a potoon boat. assuming the boat is normal size. if its a smaller one then this motor might work just fine. give it a try and see if it moves you about fast enough for your taste.

May 15, 2010 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

MY MINN KOTA 30LB THRUST MOTOR HAS DEVELOPED A NOISE IN THE LOWER UNIT LIKE A LOOSE BEARING.IT SEEMS TO BE WORSE IN REVERSE


Hi!
Here is a schematic for your motor:
Endura 30
It sounds like the motor has leaked water into it and wil need to be cleaned up, have the brushes, seal kit and bearings replaced.
Best of luck!
Mike

Jul 09, 2009 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

I need a truster speed for a Minn Kota Endura 46


Hi!
Here is a scchematic with part numbers and service center listing as well:
Endura 46
Best of luck!
Mike

Jun 21, 2009 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

Overheated Minn Kota Endura28


This sounds like a fairly big deal. You need to check it water got into the motor. Turn it upside down and see if water comes out of the handle end of the motor. This may be a shop deal.

May 31, 2009 | Minn Kota Endura 30 Freshwater Transom...

1 Answer

Minn kota endura 30 repair


The top section will pop off when the six screws are removed. It might just be dirty and sticking.

Apr 12, 2009 | Minn Kota Endura 30 Freshwater Transom...

Not finding what you are looking for?
Minn Kota Endura 30 Freshwater Transom Mount Trolling Motor Logo

Related Topics:

274 people viewed this question

Ask a Question

Usually answered in minutes!

Top Minn Kota Boating Experts

Gene Pitts

Level 2 Expert

159 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Andrew Taylor
Andrew Taylor

Level 3 Expert

29424 Answers

Are you a Minn Kota Boating Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...