Question about Xerox Phaser 8500/DN Printer
Posted by Anonymous on
That error signifies a problem with the printhead tilt, you need to replace the Process motor camshaft pivot kit, part number 8560-Z2.
Posted on Sep 21, 2015
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
SOURCE: Phaser 8560 error code
Most likely you are using generic ink or ink not made for that specific machine. The black ink is the one causing the problem. the printer will then need to be reset.
Posted on Apr 15, 2009
That's a ink loader error, due to the 8200 ink stick; to fix it:
- Power down the printer.
- Hold the back button and the info button at the same time, without letting go, power up the printer.
- Keep holding down the buttons until the XEROX logo comes fully to the center of the screen, keep holding for 2 more seconds, then let go. I'll take about a minute or two for the Diagnostic screen to come up, the display will turn blank and black.
- When the Diagnostic screen comes up go to down to the Function or Exercise option, there will be an option that says "clear ISC faults" it'll ask you to press OK to confirm, after you do then you will exit Diagnostics and the printer will reboot.
It should be fine until it happens again. Until all the 8200 ink is gone you will probably be doing this a few more times. Also make sure the 8200 ink is not jammed inside the ink loader, if it is then you have to un-jam it some how.
Please come back and just gave a vote, it will gave me some satisfaction to know am helping some one so I will keep on helping.
All The Best: Pineworks
Posted on Mar 02, 2010
SOURCE: xerox error code 08,009.43
That is a media path motor fault.
That is the paper path motor and gear assembly on the left side of the machine looking from the front.
Since it happened during a cleaning session, I would suspect that the maintenance kit may just be stuck out of position of the head maintenance clutch may be bad, Here is that part number
Head Maintenance Clutch
Posted on Jul 09, 2010
Testimonial: "Thanks so much."
Here is someone that had the same issue, and followed these steps to resolve. Good luck!
Posted on Apr 20, 2011
Tips for a great answer:
Sep 21, 2015 | Xerox Phaser 8560DN Printer
Feb 26, 2015 | Xerox Phaser 8560/YN Printer
Oct 11, 2014 | Xerox Phaser® 8550, 8560, 8560MFP Extended...
Are there obstructions or spilled ink on the Wiper Blade, the Head Tilt Gear drive path, or under the Printhead?
Is the Waste Tray overfilled?
Clean the inside of the printer and retest
Mar 10, 2014 | Xerox Office Equipment & Supplies
Aug 08, 2012 | Xerox Phaser 8560MFP Laser Printer
Jun 07, 2012 | Xerox Phaser 8500/DN Printer
Apr 20, 2011 | Xerox Phaser 8560DN Laser Printer
Apr 19, 2011 | Xerox Phaser 8560DN Laser Printer
Jun 30, 2014 | Xerox Phaser 8500/DN Printer
Jun 04, 2014 | Xerox Phaser 8500/DN Printer
231 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: