Question about Bissell 3594 CleanView PowerTrak Bagless Upright Vacuum
Brush dirty and not spinning
Posted by Anonymous on
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Sounds like the beater brush is frozen and won't turn. Remove the beater brush and clean off all debris, especially at both ends. You will find a square(?) piece at each end of the beater brush that holds it in place. This need to turn freely. Put a little WD40 on these where the center rod of the beater brush enters the small holders and turn by hand until they turn freely. Once this is done, assemble with new belt, making sure the belt is put on properly. If the belt is missing and you need to replace, I would still do the cleaning on the beater brush. It should move freely when you turn it by hand.
Posted on Sep 12, 2010
SOURCE: the turbo brush attachment on
The turbo brush may just need to be cleaned. If hair or other large debris gets wrapped around the brush, it can prevent it from spinning. Since the top of the turbo brush is clear, you can look in and see if there is a lot of hair wrapped around the brush. If so, you can open it up by removing the two screws on the bottom of the brush and popping the clear cover off, then cleaning all the debris from the brush (scissors work well if its hard to get dog hair off). Be careful to see how the brush goes back together as you take it apart.
If cleaning the brush doesn't fix it, the belt might be broken. As you're looking at the top of the brush, there is a little belt that goes from the brush itself to the large blue/green gear (it's red on some models) so that if you reach your hand in and turn the gear, the brush should spin. If this belt is broken or missing, it will need to be replaced. You can probably find a replacement belt online, or you can order a whole new turbo brush from the Bissell website for $24.99.
Posted on Apr 07, 2011
SOURCE: bissell pro heat brush is
There are two belts a brush belt and a pump belt. For a kit with installation instructions contact BISSELL Consumer Services at 1-800-237-7691 Mon-Fri: 8am to 10pm ET Sat: 9am to 8pm ET
BISSELL Consumer Services at
Mon-Fri: 8am to 10pm ET
Sat: 9am to 8pm ET
Posted on Apr 20, 2011
Tips for a great answer:
Feb 02, 2013 | Bissell Cleanview Helix Deluxe Bagless...
May 29, 2011 | Bissell Cleanview Helix Deluxe Bagless...
Feb 04, 2011 | Bissell Cleanview Helix Deluxe Bagless...
Jan 10, 2011 | Bissell CleanView Helix 22C1 Bagged...
Mar 30, 2009 | Bissell 3576 CleanView II Bagless Upright...
Mar 29, 2008 | Bissell 3594 CleanView PowerTrak Bagless...
109 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: