Question about Amana NTW4700YQ Top Load Washer NTW4700YQ

1 Answer

Amana washer lid lock wont quit blinking

Washer was not in use and lid was up. lid lock light started blinking and now washer will only fill and drain-will not wash or spin

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    New Friend:

    An expert that has 1 follower.

  • Contributor
  • 2 Answers

Your washer lid lock button is locked and lid was not put down before it locked, which is why the light is flashing. Therefore, push the "START" button until you see the lid lock button is off (Approx 3 seconds). Once it is off, then you can put the lid down and push the start button again, which will lock the lid into place. The washer will NOT drain or wash or spin unless the lid itself is in the locked position. If you were able to get the lid down and locked and it still doesn't work, then you need a technician to replace a wiring harness. However, you mentioned that the lid lock button was flashing, therefore, it stands to reason that your lid is NOT locked down.

Posted on Apr 13, 2014

Testimonial: "I really appreciate the response, but I should have mentioned that I already tried holding the start button many times to no avail and I tried messing with the lock mechanism, which is not in the lock position."

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 2 Answers

SOURCE: Washer wont work.

I FOUND BROKEN BELT . HOW DO I CHANGE IT ?

Posted on Sep 04, 2008

Anonymous

  • 146 Answers

SOURCE: amana ALW480DAW washer

Remove the front panel by loosening the two screws that hold it in place. Unhook the spring that puts tension on the tension pulley. Remove old/worn belt and replace with new belt. Very important that you use the correct size belt or the motor may be damaged and remember to hook the spring back for the tension pulley. The new belt has to go around the inside of the tension pulley.

Posted on Oct 31, 2007

craig carter

  • 156 Answers

SOURCE: washer wont drain or spin just hums and then blows fuse

bad motor

Posted on Feb 25, 2008

Anonymous

  • 1 Answer

SOURCE: Amana LWA50AW Washer Leaks!

Same problem here. It's coming from Shaft. Any instructions???

Posted on Apr 26, 2008

Anonymous

  • 2 Answers

SOURCE: won't drain or spin

Sounds like the lid switch which is only about 30.00 to fix if you do it yourself. It's a little difficult but it's much better than replacing or having someone come in and do it

Posted on Mar 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mav6451aww will not spin


Does washer fill, wash and drain? This washer is a straight forward unit and that complicated like new front loads. If unit fills, wash and drain, then I would lean toward a timer issue. With the unit filling, washing and draining, that tells me lid switch is good, motor runs in wash direction, pressure switch is working and tub is not locked down. Also, if motor turns one way, then motor is good. If unit is not doing the three things, then could be lid switch, pressure switch or bad motor.

May 12, 2016 | Maytag Washing Machines

1 Answer

Blinking lid locked light and green sensor light on machine won't start cycle


The good ol' Whirlpool Lid Lock Flashing Light Problem - ApplianceBlog

www.applianceblog.com/.../42456-The-good-ol-Whirlpool-Lid-Lock-Fl...

Dec 11, 2013 - 10 posts - ‎3 authors
Red Lid Lock light flashing intermittently when you try to start a cycle. ... I'm going to post what SENSING does first, then you will need to locate your tech. ... start with thelid lock on and blinking, or the unit will not start and spin. FIXED Sense light on light humming noise won't start ...
8 posts
Aug 9, 2015
Whirlpool WTW4950XW not working
10 posts
Nov 2, 2013
Stacked GE washer/dryer lights Blinking doeent start at ...
5 posts
Feb 20, 2012
More results from www.applianceblog.com

Washer Sensing led (Green) on with the lid locking led (Red ...

www.shopyourway.com > Manage My Life > Questions
... this: Sensing led (Green) on, the lid locking led (Red) blinking with a clicking noise ... red led light goes off green led light stays on and the washer does not start.

Oct 27, 2015 | Washing Machines

1 Answer

Why won't my Maytag Brazos top loader washer, model mvwx600xw1 agitate or spin? Also, the lid lock light blinks once in awhile. Checked lid lock, still no spinning


my first suspicion is in the door lock switch if it goes bad u have no action in wash or spin, next I would first check the water pressure switch as it is the unit that sends the signal to the machine to start wash cycle? if the diaphram does not detect the proper level of pressure due to water level. it will just keep filling and overflow and never start wash cycle. als0 check the water inlet valve, lastly a bad clutch will not allow much in the way of a spin cycle but would not effect the wash cycle? a bad motor coupler on the other hand stops both wash and spin?

Mar 23, 2015 | Maytag Washing Machines

1 Answer

Haier HLP21n blinking light error code.. Rinse and Spin lights blink...what does it mean?


This washer is a sanyo on the inside. When panasonic bought out sanyo and all its daughter brands, they started making parts not available for repairs. The service manual is here---> https://panasonic.encompass.com/shop/research_new/HAI/sm/HLP21N.pdf

Good luck!
This is also known as a sears proflex among other names.... haier-hlp21n-blinking-light-error-code-eqln1e0r5dvuapuxoxy4lmrd-1-0.jpg

Dec 09, 2014 | Haier HLP21N Washer

1 Answer

Unlocking your washer so it actually works.


If the green cycle light is flashing on then off, this usually means the cycle is paused. The lid lock should unlock when in pause mode, if not you will need to press and hold the "Pause/Play" button to clear the cycle completely, if there is water in the unit, it will drain first, then unlock the lid and be on standby to start a new cycle. Pleazer Appliance...

Apr 13, 2014 | Amana NTW4700YQ Top Load Washer NTW4700YQ

1 Answer

Lid is not locking properly, washer sensor is overfilling, and the washer wont spin


Check door switch: If the lid switch is bad it will not drain or spin. Try this test: With lid open let it finish wash cycle. Press lid switch down with screwdriver. Washer should begin draining. Release switch. Motor should stop. Press switch a second time. Washer should start spinning as it continues to drain. If motor doesn't come on while lid switch is pressed, replace the switch. OR
http://www.youtube.com/watch?v=q942xn_2VXY
Pl click if helped.

Apr 28, 2013 | Whirlpool WTW4950XW Washer

2 Answers

Kenmore washer model #21302 lock on light is flashing, will not start


Kenmore top load washer 21302, the sensor light is on and the lid lock light is on with a clicking noise. What could be wrong with it and how do I fix it?

May 21, 2012 | Kenmore Washing Machines

1 Answer

Washer will not spin or completely drain


you could have problem with door lock. or lid switch. this part senses if the door is close.
if it is not functioning, it would interpret it as an open door and will not spin.will not drain either.

tnx 4 using fixya,

drcool

Sep 23, 2008 | Washing Machines

2 Answers

Door Lock Clicks/Makes noises Washer does not agitate/spin


Sounds like very worn motor brushes to me, as its trying to turn the drum but has'nt the power needed to maintain any momentum,and the blinking door light is because of the bad cotact from brushes to motor.About £20 for a set of brushes or get an engineer to fit new brushes,but get a price first.

Apr 18, 2007 | GE WSXH208A Front Load Washer

Not finding what you are looking for?
Amana NTW4700YQ Top Load Washer NTW4700YQ Logo

1,503 people viewed this question

Ask a Question

Usually answered in minutes!

Top Amana Washing Machines Experts

Mike

Level 3 Expert

4363 Answers

Gerry Harvey
Gerry Harvey

Level 3 Expert

1481 Answers

jimorris77

Level 3 Expert

411 Answers

Are you an Amana Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...