Question about Kodak EASYSHARE 5500 All-In-One InkJet Printer

Open Question

Jammed printer door kodak 5100 will not close?

Posted by Anonymous on

Ad

4 Suggested Answers

Anonymous

  • 3 Answers

SOURCE: Labels in a Kodak?

I recommend our white matte or gloss inkjet labels. They should work in your printer without any issue. We can send samples if you want to try out the product. You can fill out our sample request form at the link below.

http://www.onlinelabels.com/sampreq.asp

Thanks.

Dave Carmany
OnlineLabels.com

Posted on Feb 22, 2008

Ad

Anonymous

  • 564 Answers

SOURCE: Kodak EasyShare 5100 All-in-one printer will not print ink

you most likely need to run a head clean and alignment, which is needed after each cartridge replacement.

http://tinyurl.com/6qcpgy

Posted on Aug 18, 2008

Ad

Anonymous

  • 25 Answers

SOURCE: Kodak 5100 all-in-one printer

Hello

You just need to push the button on top of the printhead and it will disengage from the carriage...(Make sure that when you open the printer access door, the printhead should move to the middle of the printer. If not, call Kodak technical support for that... 1-800-421-6699

I hope I have been some of help. Take care...

Posted on Nov 09, 2008

vegakitten20

Juanita Vega

  • 685 Answers

SOURCE: can't install Kodak 5100 printer unto new Mac

go to the web site and it will give you the right drivers for your printer.but make sure you go to the Kodak web site.

Posted on Apr 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Paper jam all the time but there is no paper jammed in it


This error message is displayed by the printer when paper is jammed in one or more locations. In such a case, users are recommended to remove the jammed paper from the specified location. The entire paper path must be checked for any pieces of paper. To stop the message, open and close the top most cover of the printer. Lastly, verify the flags and the sensors. If the problem persists, the cause of the error message could be a broken sensor or sensor lever.

Nov 17, 2010 | Kodak EASYSHARE 5100 All-In-One Printer

2 Answers

Paper jamed in kodak esp3


there is no two ways about it... either take the machine apart and pull out the paper or get a pair of plyers and pull out the paper... or pay someone to do it...

I’m happy to assist further over the phone at https://www.6ya.com/expert/norman_d2fa496dce30c65d

Dec 20, 2009 | Kodak EASYSHARE 5100 All-In-One Printer

1 Answer

Printer says there is a paper jam and there is no paper in there.


first thing you need to do is will do the overriding the error

1. open the pritner access door fo the printer
2. if the printhead or ink cartirdges already in center remove the ink cartridges and the printhead
3. If the printhead already removed close printer access door., Turn Off the pritner then after 10sex turn It own.

4. Now your pritner should detect no printhead installed not paper Jam., If you still recieved paper jam error without the pritnhead installed you need to have a printer replacement call kodak toll free number 1 800 421 6699 ext 05

5. Now if the message is pritnhead not installed., reseat the printhead and the ink cartordges then close the pritner access door., If your ecived same message paper jam., You need to replace the printhead you may also call kodak 1 800 421 6699, and have your free printhead replacement.

Most of the time overriding the error message solve the problem

Nov 17, 2009 | Kodak ESP 5 Printer

2 Answers

How do I clean the print head for a kodak printer


This is for Kodak AiO printer that has home center software installed
1.On your computer, start the KODAK AiO Home Center software.
2.Click the Help (?) icon located at the upper-right corner of the Home Center window
3.From the Help toolbar, select Maintenance.
4.Click Printhead Cleaning, and wait for the printer to complete the cleaning.
If there is NO Kodak AiO home Center software installed
1. 5100 printer HOME CENTER should be use or open the printer access door wait for the printhead to move at the middle then close the printer access door forcing the printehead to eject ink on the printhead nozzle
2.5300 & 5500 printer press the MENU button > select CLEAN PRINTHEAD > then select BASIC/DEEP CLEAN
3. ESP3 printer [press and hold at the same time COPY and CANCEL button for atleast 10 sec or until the printer start moving]

Nov 13, 2009 | Kodak EASYSHARE 5100 All-In-One Printer

1 Answer

Ive got a serious paper jam what do i do.


Carefully open the unit up, and you will see where the paper is jammed. Gently wiggly and pull the paper out to unjam. Close unit cover and reboot (turn off and on). I hope this helps.

Oct 26, 2009 | Kodak EASYSHARE 5100 All-In-One Printer

2 Answers

My printer reports error B! close printer access door. I have repeatedly opened and closed the door. This causes the printer to go through it's reset process but then the same message reappears. Any...


You have a malfunctioning access door sensor.

The solution is to replaced the sensor yourself or buy a new printer. Taking it to be fixed will cost about as much a s new on.

Aug 14, 2009 | Kodak EASYSHARE 5100 All-In-One Printer

2 Answers

Kodak 5500 Printer Pa[per jam


Verify that the ink cartridges are intact and securely inserted into the printhead, then make the same print.
  1. Lift the printer access door, then remove the ink cartridges from the printhead.
  2. Verify that the label on the ink cartridges is intact, and the cartridges are not damaged.
  3. Verify that only KODAK branded ink cartridges are installed.
  4. Insert the ink cartridges into the printhead, then press down firmly until you hear them click into position.
  5. Close the printer access door, then make the same print.
If this will not correct the issue, try to follow these steps
Clean the printhead, then print a demo sheet.



5000_demo_sheet.jpg
  1. Verify that inkjet paper is loaded in the paper trays.
  2. Press Menu.
  3. Select Clean Printhead, then press OK.
  4. Select Deep Clean, then press OK. The On/Off light flashes green during the cleaning procedure.
  5. When the On/Off light glows a steady green, select Print Demo Sheet, then pressStart.
If these steps will not correct the issue on the printout., you need to call Kodak technical support ( 1 800 421 6699) possible the printhead is defective and it needs to be replaced

Dec 11, 2008 | Kodak EASYSHARE 5100 All-In-One Printer

1 Answer

Kodak 5100 all-in-one printer


Hello

You just need to push the button on top of the printhead and it will disengage from the carriage...(Make sure that when you open the printer access door, the printhead should move to the middle of the printer. If not, call Kodak technical support for that... 1-800-421-6699

I hope I have been some of help. Take care...

Oct 27, 2008 | Kodak EASYSHARE 5100 All-In-One Printer

2 Answers

5300 kodak eazyshare printer


Well, here is the proper way of fixing or troubleshooting that paper jam error in your printer

Open the printer access door and remove both of the ink cartridge, then remove also the printhead, after that close the printer access door, without those parts. Then it will show a message in the printer screen, "Printhead is missing or has come loose" or "Printhead Not Detected" Install the printhead, just the printhead without the ink cartridges. After that close the printer access door. Then it will show you a message"Ink cartridges is not installed,install ink cartridges". then open again the printer access door, then install the black ink cartridge without the color ink cartridge. then close the printer access door, then message must be " Color ink cartridge is not installed, install color ink cartridge" then install the color ink cartridge." the message must be,"New printhead is detected calibration require, load paper and press start"

Thats the way of overiding the paper jam error message of your kodak all in one printer
hope this will help you guys

by: E.brown

Happy Printing(", )
Kodak AIO tech support 1-800-421-6699

Jun 04, 2008 | Kodak EASYSHARE 5500 All-In-One InkJet...

1 Answer

Kodak 5100 wont print after paper jam


If you cant get the jam cleared from the back or the top access door you could exchange it from where you got it. Or try and open it up and fix it yourself but that will void the waranty and you wont be able to exchange it. Or you could check the yellow pages for a PC/printer repair shop. But I mostly recomend trying to exchange it from where you bought it.

Feb 16, 2008 | Kodak EASYSHARE 5100 All-In-One Printer

Not finding what you are looking for?
Kodak EASYSHARE 5500 All-In-One InkJet Printer Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kodak Office Equipment & Supplies Experts

Ekse

Level 3 Expert

13434 Answers

Cindy Wells

Level 3 Expert

6073 Answers

jasbo
jasbo

Level 3 Expert

2239 Answers

Are you a Kodak Office Equipment and Supply Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...