Question about Galaxy Radios DX- 88HL Base CB Radio

1 Answer

Where is the switch that keys and changes light green to red

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Galaxy Radios Master
  • 1,847 Answers

There should be 4 diodes in the front end of the radio.two are for the channel selector and two are for the rest of the lights replace all four.

Posted on Jun 05, 2014

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need a wiring diagram on suzuki raiderj 110. Please. Tnx.


Maybe you can use these codes taken from:

http://www.motorcyclephilippines.com/forums/showthread.php?120554-Motorcycle-Electrical-Wiring-Diagram-Thread

This is a Wiring Harness Guide for Suzuki Smash, Raider J, ShogunR/Pro Motorcycles. It may also be applicable to Hayate, Step, Mola and Raider 150.

CDI
ORANGE - from Ignition +ACC
BLACK/swhite - Ground
WHITE/sblue - to Ignition Coil
BLUE/syellow - to ENGINE Stator side

ENGINE - Stator Single Phase
WHITE/sred - To RECTIFIER
YELLOW/swhite - To RECTIFIER
BLUE/syellow - from CDI sensor

ENGINE - Transmission Gearbox
GREEN/sblue - 1st Gear
YELLOW/sblue - 2nd Gear
WHITE/syellow - 3rd Gear
RED/swhite - 4th Gear
BLUE - Neutral

ENGINE - Rear Side
PINK - Odometer Speed Sensor
BLACK/swhite - Ground
ORANGE/sred -

ELECTRIC Start RELAY
YELLOW/sgreen - form Starter Switch
BLACK/swhite - Ground

BREAK - Foot pedal
ORANGE - From ignition + ACC
WHITE/sblack - to Break light

BREAK - Hand Lever
ORANGE - from IGNITION + ACC
WHITE/sblack - To BREAK Light

FUEL Sensor
Yellow/sblack - to Console
BLACK/swhite - Ground

REAR - Lights
WHITE/sblack - form BREAK foot/hand
GRAY - From Night Switch
BLACK - from Left Turnsignal
LIMEGREEN - from Right TurnSignal

Signal Flasher Relay
ORANGE - from Ignition + ACC
LIGHTBLUE - Signal SW

RECTIFIER
WHITE/sred - From STATOR
BLACK/swhite - Ground
YELLOW/swhite - From STATOR
RED/sorange - BATT+/HEAD LIGHT

IGNITION Key
RED - from FUSE
ORANGE - to ACC

HORN Switch
BLACK/swhite - Ground
Green - to Horn

HORN
GREEN - from HORN Switch
ORANGE - Ignition + ACC

NIGHT Switch
RED/sorange - From Rectifier
GRAY - To REAR LIGHT/HEADLIGHTThis is a Wiring Harness Guide for Suzuki Smash, Raider J, ShogunR/Pro Motorcycles. It may also be applicable to Hayate, Step, Mola and Raider 150.

CDI
ORANGE - from Ignition +ACC
BLACK/swhite - Ground
WHITE/sblue - to Ignition Coil
BLUE/syellow - to ENGINE Stator side

ENGINE - Stator Single Phase
WHITE/sred - To RECTIFIER
YELLOW/swhite - To RECTIFIER
BLUE/syellow - from CDI sensor

ENGINE - Transmission Gearbox
GREEN/sblue - 1st Gear
YELLOW/sblue - 2nd Gear
WHITE/syellow - 3rd Gear
RED/swhite - 4th Gear
BLUE - Neutral

ENGINE - Rear Side
PINK - Odometer Speed Sensor
BLACK/swhite - Ground
ORANGE/sred -

ELECTRIC Start RELAY
YELLOW/sgreen - form Starter Switch
BLACK/swhite - Ground

BREAK - Foot pedal
ORANGE - From ignition + ACC
WHITE/sblack - to Break light

BREAK - Hand Lever
ORANGE - from IGNITION + ACC
WHITE/sblack - To BREAK Light

FUEL Sensor
Yellow/sblack - to Console
BLACK/swhite - Ground

REAR - Lights
WHITE/sblack - form BREAK foot/hand
GRAY - From Night Switch
BLACK - from Left Turnsignal
LIMEGREEN - from Right TurnSignal

Signal Flasher Relay
ORANGE - from Ignition + ACC
LIGHTBLUE - Signal SW

RECTIFIER
WHITE/sred - From STATOR
BLACK/swhite - Ground
YELLOW/swhite - From STATOR
RED/sorange - BATT+/HEAD LIGHT

IGNITION Key
RED - from FUSE
ORANGE - to ACC

HORN Switch
BLACK/swhite - Ground
Green - to Horn

HORN
GREEN - from HORN Switch
ORANGE - Ignition + ACC

NIGHT Switch
RED/sorange - From Rectifier
GRAY - To REAR LIGHT/HEADLIGHT
This is a Wiring Harness Guide for Suzuki Smash, Raider J, ShogunR/Pro Motorcycles. It may also be applicable to Hayate, Step, Mola and Raider 150.

CDI
ORANGE - from Ignition +ACC
BLACK/swhite - Ground
WHITE/sblue - to Ignition Coil
BLUE/syellow - to ENGINE Stator side

ENGINE - Stator Single Phase
WHITE/sred - To RECTIFIER
YELLOW/swhite - To RECTIFIER
BLUE/syellow - from CDI sensor

ENGINE - Transmission Gearbox
GREEN/sblue - 1st Gear
YELLOW/sblue - 2nd Gear
WHITE/syellow - 3rd Gear
RED/swhite - 4th Gear
BLUE - Neutral

ENGINE - Rear Side
PINK - Odometer Speed Sensor
BLACK/swhite - Ground
ORANGE/sred -

ELECTRIC Start RELAY
YELLOW/sgreen - form Starter Switch
BLACK/swhite - Ground

BREAK - Foot pedal
ORANGE - From ignition + ACC
WHITE/sblack - to Break light

BREAK - Hand Lever
ORANGE - from IGNITION + ACC
WHITE/sblack - To BREAK Light

FUEL Sensor
Yellow/sblack - to Console
BLACK/swhite - Ground

REAR - Lights
WHITE/sblack - form BREAK foot/hand
GRAY - From Night Switch
BLACK - from Left Turnsignal
LIMEGREEN - from Right TurnSignal

Signal Flasher Relay
ORANGE - from Ignition + ACC
LIGHTBLUE - Signal SW

RECTIFIER
WHITE/sred - From STATOR
BLACK/swhite - Ground
YELLOW/swhite - From STATOR
RED/sorange - BATT+/HEAD LIGHT

IGNITION Key
RED - from FUSE
ORANGE - to ACC

HORN Switch
BLACK/swhite - Ground
Green - to Horn

HORN
GREEN - from HORN Switch
ORANGE - Ignition + ACC

NIGHT Switch
RED/sorange - From Rectifier
GRAY - To REAR LIGHT/HEADLIGHT

Dec 27, 2015 | 2006 Suzuki Stratosphere

1 Answer

Does the green light turn red when I key the mike


Yes ,it must turn red when transmit.
you have to press the PTT and hold buttom to calibrate the SWR meter for readind.with the switch to calibrate(cal)

Nov 23, 2013 | Cobra 25 LTD 40-Channel CB Radio

1 Answer

Hi, if I change my computer to my Nissan 300ZX 1986 I have to reset my computer or simply change it. Thank you for answer.


There is no re-setting. You just change it out. Be sure and disconnect battery before unplugging the ecu. It's a simple swap and go.
If yours is like my '87 Sentra, there is no trouble code capability, but there are limited diagnostic functions. The red and green LED lights and the diagnostic switch (on/off), can tell you if problems are present in the system or not. You just have to follow the diagnostic procedure.
Here's how: Make sure diagnostic switch on ecu is off. Run engine at 2000 rpm for 5 minutes, at no load. Look at green led: if it flashes at least 5 times in 10 seconds (that is the oxygen sensor making it flash), turn car off. Turn diagnostic switch on. Turn key to on, do not start engine. Check led's: if red is off and green on steady-No problems present in system.
If the red light is on and green light is flashing, post back and I can furnish the rest of the diagnostic procedure-basically, you will be checking voltages and resistance of all solenoids and relays the ecu controls. The green led may flash in two different sequences (either longer flashes and short pauses, or longer pauses and short flashes) when in diag. mode (with the red led on), and that will lead you down two different diagnostic routes. Pretty simple, really, and pretty effective. Took me hours and hours before I realized I even had this diagnostic function.

Aug 18, 2013 | Nissan 300ZX Cars & Trucks

3 Answers

Tda9380ps /n3/3/1664 using in sharp tv power supply ok ,but no EHT ,the power LED are glowing red light press program key to change green light to return in few miniutes to standby in red light position...


tda9380ps /n3/3/1664 using in sharp tv power supply ok ,but no EHT ,the power LED are glowing red light press program key to change green light to return in few miniutes to standby in red light

Aug 30, 2011 | Sharp 21" Multi System Stereo TV

2 Answers

Tda9380ps /n3/3/1664 using in sharp tv power supply ok ,but no EHT ,the power LED are glowing red light press program key to change green light to return in few miniutes to ...


Tda9380ps /n3/3/1664 using in sharp tv power supply ok ,but no EHT ,the power LED are glowing red light press program key to change green light to return in few miniutes to standby in red light position ,please to help of rectivied this problem and send circuit diagram and IC pin configaration thanking you sir

Mar 03, 2011 | Televison & Video

1 Answer

BH105 is switched on, green light is blinking, but Nokia 5310 phone is not able to detected it.


U must RESET the Headset.
Switch OFF the Headset.
HOLD the answer/end key + power key (for about 5 second).
Red + Green indicators lights start to alternate.
Then Ur Headset is RESET.

Connect / Pair it with your Mobile as normal.

Nov 02, 2010 | Nokia Bluetooth Headset BH105

1 Answer

Hello, I have recenty acquired a Philips CRT 29PT9420 Television. However. when i attempt to turn the TV on, the light at the bottom of the TV (Standby, On, Off light) flashes between green and red for 2...


Switch the TV on: Press the power switch A on the front of the TV. A green indicator on the front of the TV lights up when the screen is on. If the indicator is red, press the
-CH + keys on the remote control.
The green light blinks every time you press a key n the remote control.

Ref. link:
https://www.manualslib.com/manual/173137/Philips-29pt9420-69r.html?page=4#manual

Oct 11, 2017 | Televison & Video

1 Answer

Change filter light


Water Filter Status Indicator
Light (select models)
The Water Filter Status Indicator Light serves as a
reminder to replace the water filter. A green light
indicates that the filter is in good condition. A red light
indicates the filter should be changed. Once light turns
red, it will remain red until function is reset.
To Reset Indicator:
• Press and hold both the Lock and Water
buttons simultaneously for four seconds. The
green filter status indicator light will flash
three times when the function has
successfully reset.
Sea Breeze

Nov 25, 2009 | Maytag MSD2650H Side by Side Refrigerator

2 Answers

Maintenance required light is orange


it comes on after a certain amount of miles
look it over check all belts hoses brakes fluids
and check the timing belt if all looks good put your key in the slot next to orange light and it will goto green again if you don't reset it will goto red in a few miles but it is not the check eng. light just a reminder

Jun 28, 2009 | 1991 Honda Accord

Not finding what you are looking for?
Galaxy Radios DX- 88HL Base CB Radio Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Galaxy Radios Radio Communications Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Brad Brown

Level 3 Expert

18110 Answers

Edward Stotts
Edward Stotts

Level 1 Expert

15 Answers

Are you a Galaxy Radios Radio Communication Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...