Question about Stanley 77-720 Stud Sensor 200
Posted by Anonymous on
The stud finder works by picking up density of the product it is pressed and slid on..Turn your stud finder on make sure the ok light is on...then slightly press it against the wall or surface you are working with,,then slowly moved it right or left still against the surface. As the finder starts to detect more density "thickness" it will. Glow or beep depending what type you have..It will get brighter,louder or what ever it signals are while crossing the stud beneath the surface..keep moving until it stops then move back
again until it stops.....mark or note the position where the signal starts then find the middle...2x4's are 1 1/2 inches across...so center should be 3/4 of an inch...good luck..
Posted on Oct 16, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Tips for a great answer:
Jun 23, 2017 | Skil 14.4 volt Drill with Built - in Stud...
Apr 17, 2012 | Skil 14.4 volt Drill with Built - in Stud...
Mar 05, 2012 | Stanley Measuring Tools & Sensors
May 08, 2011 | Stanley Garden
Oct 02, 2010 | Ryobi WallTech Stud Finder Stud Finders
Jul 10, 2010 | Ryobi WallTech Stud Finder Stud Finders
Jun 18, 2010 | Strait-Line Intersect Laser Level With...
Jul 13, 2009 | Ryobi WallTech Stud Finder Stud Finders
1,138 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: