Question about Magic Chef 31000 Gas Kitchen Range

Open Question

Where is the model number located on my magic chef super capcity gas range?

Where is the model number located?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Robert Hirst

  • 833 Answers

SOURCE: Magic Chef Gas Oven - Heats up slowly and has intermittent gas smell

STOP USING THE OVEN IMMEDIATELY!!! You are not getting enough air to the burners to burn all the fuel. Not only will you have an explosion hazard, you'll have a carbon monoxide hazard either of which will KILL YOU. Read all of the info below before you begin.

You need to clean all the burners and inlets thoroughly. You probably used the oven for a lot of broiling of meats or it is quite old. The deposits are clogging the tubes which gauge the amount of air entering the burners or the burner holes themselves. The burner tubes are generally removable by removing one screw and giggling the units clear. Before taking anything apart, note carefully the positions of any mix plates and scribe small marks between the two surfaces. Use a heavy duty cleaner or WD-40 to loosen grime. Don't use abrasives like Comet. Then wash in mild detergent with hot water and dry. Be sure all burner openings are clear. After assembly, note the color of the flames. They should be about 90% blue along their length from the burner head. If they are not, you didn't finish the job cleanly or you have another problem. If the burners are old, rusty or have irregularly shaped flame holes, replace them.

Posted on Dec 03, 2007

Ad

Anonymous

  • 360 Answers

SOURCE: Magic Chef Gas Range, model CGR3740ADW

magic chef fault codes

F1 1. Watchdog on board
2. Touch membrane defective To determine which component is at fault, disconnect ribbon strip. If NO fault code, replace membrane, otherwise replace board F2 Oven too hot Check oven temperature sensor F3 F4 Open or shorted oven temperature sensor Replace F5 Hardware and watchdog circuits disagree Replace clock assembly (also called the ERC) F6 Missing AC signal Replace clock assembly (also called the ERC) F7 Function key shorted Replace touch pad F8 Analog/Digital converter Replace clock assembly (also called the ERC) F9 Door latch Check door lock circuit F10 Function key stuck Replace touch pad

Posted on Feb 07, 2009

jumptrout51

steve

  • 3361 Answers

SOURCE: Gas range burner flame too high and too yellow.

Did it work OK in that location before the changes?
Sounds like you used Natural gas parts instead of LP.
Lp orifices have smaller holes than Nat.

Posted on Mar 12, 2009

Anonymous

  • 1 Answer

SOURCE: Magic Chef oven won't light

Replaced the ignitor.

Posted on Oct 09, 2009

Paul Carew

  • 3477 Answers

SOURCE: magic chef F1 error code gas range

Hi touch pad or clock fault

Posted on Feb 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is there a conversion kit for magic chef CPR1100ADW


Yes, there is an LP conversion kit for the CPR1100ADW. Sears Parts Direct lists it here: http://www.searspartsdirect.com/model-number/cpr1100adw/1429/0124002.html . Select the Gas Control drawing. The direct link to the LP orifice kit, part number 74009923, is http://www.searspartsdirect.com/part-number/74009923/0022/464.html?modelNumber=CPR1100ADW&categoryName=Free%20Standing,%20Gas&brandName=MAGIC%20CHEF . Note: the Magic Chef range uses the same parts as a Whirlpool or Maytag range.

The gas regulator also has to be adjusted. Most ranges with converter kits available just require the regulator to be removed and turned 180 degrees before replacing it. It's recommended that a LP service person do the work. The air flow may need to be adjusted and any mistakes could be dangerous.

I hope this helps.

Cindy Wells

May 06, 2017 | Magic Chef Kitchen Ranges

1 Answer

Using the oven with timer and how operate


Hi, you need the correct model number for your magic chef range/oven and repost, or go direct to magic chef's literature website: http://shared.whirlpoolcorp.com/product_literature/search.jsp?siteCd=MCF

Dec 11, 2010 | Magic Chef 31000 Gas Kitchen Range

1 Answer

Magic chef oven pilot light out


Hi, If the oven has a standing pilot too, Open the bottom door and locate the main burner. Follow the burner toward the rear of the oven and there will be a flame switch attatched to the burner. Hold the flame near the flame switch and the gas should ignite.
Some model do not have a standing pilot in the oven. Please get me your model number off the label located around the opening of the lower door so I can look this up and instruct you better.

Vic

Jul 15, 2009 | Magic Chef 31000 Gas Kitchen Range

1 Answer

We own a 1973 TravelEze travel trailer with a magic chef lp 4 burner range. The model number is unreadable. It does start with BT22 we think. We would like to order a replacement gas regulator and a m


I think you should have more numbers. there are quite a few other series for this unit. I have posted a site below for your assistance.

http://www.aaarv.net/bt22_series_parts.htm

Please rank if this helped


Apr 27, 2009 | Magic Chef 9122 Gas Single Oven

1 Answer

Location of pilot light on bottom of an old Majic Chef gas stove


please send model number...and how old in or about years..onthejob

Jan 01, 2009 | Magic Chef 31000 Gas Kitchen Range

1 Answer

Trying to find model number of an old Magic chef gas oven


depending on age, sometimes on back, or even under the main top if it lifts up, sounds as uf you would need to replace the door hinges

Nov 25, 2008 | Magic Chef 31000 Gas Kitchen Range

1 Answer

Lighting pilot light


The model number you gave is judged incomplete by the Magic Chef website, yielding this error:
----------- About Model Numbers:Model Numbers are made up of both alphabetical and numerical characters, and look like this: CEC1536 ----------  Once you have located a similar model number, you should be able to find a downloadable manual here:
Magic Chef manuals  

Nov 24, 2008 | Magic Chef 31000 Gas Kitchen Range

1 Answer

Magic chef range


if you give me a model number i be might be able to help try here get your model number off the serial plate from the range http://www.maytag.com/support/manuals_literature.jsp if that dont work reply to this thread with model number

Jan 15, 2008 | Kitchen Ranges

Not finding what you are looking for?
Magic Chef 31000 Gas Kitchen Range Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Magic Chef Kitchen Ranges Experts

Paul Carew

Level 3 Expert

3477 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

John Tripp
John Tripp

Level 3 Expert

4656 Answers

Are you a Magic Chef Kitchen Range Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...